List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. SBIR Phase II: High multiplex visual mapping of heterogeneity in FFPE biospecimen

    SBC: BIOSYNTAGMA, LLC            Topic: BM

    This SBIR Phase II project aims to facilitate understanding of cellular diversity in tumors, a phenomenon that contributes to acquired drug resistance. Quantifying and understanding this diversity may help predict a patient?s response to certain drugs which would allow the selection of ideal drug combinations for an individual patient?s tumor, thus enabling personalized medicine. This Phase II pro ...

    SBIR Phase II 2018 National Science Foundation
  2. SBIR Phase II: Novel Radar Using 3D Printed Luneburg Lens for Autonomous Transportation

    SBC: LUNEWAVE INC.            Topic: EW

    The broader impact/commercial potential of this project will be that this research will address the resolution and detection range requirements of autonomous driving in complex environments such as urban scenarios. The next major revolution of transportation is undoubtedly autonomous driving, which will increase safety, mobility and productivity. Fully autonomous transportation may eliminate human ...

    SBIR Phase II 2018 National Science Foundation
  3. High-Efficiency Radiation-Hard Solar Array Interface to Spacecraft Power System

    SBC: Alphacore, Inc.            Topic: AF162007

    The Phase II SAI prototype will be developed using COTS GaN switches and CMOS drivers. During Phase II Alphacore will design and fabricate a rad-hard CMOS driver ASIC to provide electrical and on-chip algorithmic control of the GaN switches. The SAI and its components will be tested and measured under varying environmental conditions, including across temperature and radiation extremes. The GaN de ...

    SBIR Phase II 2018 Department of DefenseAir Force
  4. Low Voltage Radiation Hardened Optoelectronics for Optical Interconnects

    SBC: QuantTera            Topic: DTRA152001

    The Defense Threat Reduction Agency (DTRA) recognizes the need for low-power high-bandwidth radiation-hard optical interconnects to process more data more quickly and to replace electronic data.Our companys core development in optical communications with semiconductor materials is a unique fit for DTRAs low-power consumption high-bandwidth radiation-hard intra-chip communication components for sat ...

    SBIR Phase II 2018 Department of DefenseDefense Threat Reduction Agency
  5. Thermally Efficient Emitter Technology for Advanced Scene/Simulation Capability in Hardware in the Loop Testing

    SBC: ROBERT A. RICHWINE, LLC            Topic: MDA15014

    We introduce a concept and a design for a high-speed, high-temperature infrared scene projector for midwave (MWIR) and longwave infrared (LWIR) application. Results from study of carbon nanotube (CNT) material characteristics, along with field emission and electro-thermal modeling show that higheffective MWIR temperatures can be sustained and projected by a CNT pixel with little or no spillover to ...

    SBIR Phase II 2018 Department of DefenseMissile Defense Agency
  6. Pocket-sized Surface Flotation Device for Cold Water Aviation Survival

    SBC: SAFE INC            Topic: N162096

    The Navy requires a life raft that is small enough to fit within a front pocket on the body-worn survival ensemble. Having a pocket-sized raft at hand helps facilitate successful egress, inflation, and boarding. The required 12 cubic inches of stowed volume is a significant challenge, considering that a typical one-person raft compacts to about 700 cubic inches under vacuum. Safe, Inc. (Safe) has ...

    SBIR Phase II 2018 Department of DefenseNavy
  7. SBIR Phase II: Transparent Flexible Quasi-Ceramic Intelligent Multifunctional Coatings for Corrosion and Biofouling Protection

    SBC: FLORA COATINGS LLC            Topic: CT

    This SBIR Phase II project aims to develop and commercialize a transparent, thin multifunctional coating for corrosion and biofouling prevention on coated surface. Its environmentally friendly product will be an efficient ready-to-use single component product that can be applied with ease, and would dry in ambient conditions without the need for external heating equipment. The global annual expend ...

    SBIR Phase II 2018 National Science Foundation
  8. SBIR Phase II: Profitable Recycling of Silicon Solar Cells and Modules

    SBC: TG Companies, LLC            Topic: PH

    The broader impact/commercial potential of this Small Business Innovation Research (SBIR) project is to make the 'green' solar industry truly green. As the deployment of solar modules expands rapidly, so will module wastes. The International Renewable Energy Agency (IRENA) estimates that module wastes will appear in large quantities by early 2030's and by 2050 they will total 78 million tonnes. To ...

    SBIR Phase II 2018 National Science Foundation
  9. Active Battery Management System with Physics Based Life Modeling Topology

    SBC: Electric Power Systems LLC            Topic: A2

    Robust Data Acquisition on flight applications enables Researchers to rapidly advance technology. Distributed Electric Propulsion (DEP) and Hybrid Electric architectures rely heavily on batteries to achieve fuel efficiency and reduced CO2 emissions. DEP Aircraft of the future have demands for Energy Storage Systems with large counts of cells put in series and parallel to achieve needed voltage and ...

    SBIR Phase II 2018 National Aeronautics and Space Administration
  10. Lightweight High Energy Density Capacitors for NASA AMPS and PPUs

    SBC: SIGMA TECHNOLOGIES INTERNATIONAL GROUP, INC.            Topic: S3

    All NASA Power Processing Units (PPUs) including DC to DC and DC to AC converters and inverters require a DC-link capacitor, placed between the DC source (PV solar array or battery) and the switching power semiconductors.  NASA technical personnel has identified a failure mode in Multi-Layer Ceramic (MLC) DC-link capacitors currently used in PPUs that can cause them to short.   Poly ...

    SBIR Phase II 2018 National Aeronautics and Space Administration

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government