For best search results, use the search terms first and then apply the filters

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Production of Phenol Formaldehyde Resins from Recycled Composite Materials

    SBC: Adherent Technologies, Inc.            Topic: N/A

    The recycling of thermoset composite materials produces valuable fibers and a liquid hydrocarbon byproduct. The liquid hydrocarbons constitute a potential hazardous wastestream that could prevent the recycling process from being adopted on a large scale by government and industrial users. This project addresses the conversion of these liquid hydrocarbons into useful products. Phase I showed tha ...

    STTR Phase II 2001 Department of Energy
  2. Low-Temperature Composite Recycling Process

    SBC: Adherent Technologies, Inc.            Topic: N/A

    60770 Recycling of carbon fiber reinforced composites is an important task for the future development of this class of materials. Without recycling, the full potential of using composite materials in low-cost applications like automobile production, along with the resulting fuel economy, will not be realized. Recycling the composites will also have a huge ecological benefit by removing a w ...

    SBIR Phase II 2001 Department of Energy
  3. Enhanced, Three-Dimensional, Multicomponent Seismic Imaging for Lithology and Fluid Characterization

    SBC: 4th Wave Imaging Corporation            Topic: N/A

    60143 Multicomponent shear-wave seismic data reveal information about subsurface lithologies and fluid properties that is difficult or impossible to obtain with compressional-wave data alone. Although commercially available three-dimensional (3D), multicomponent simulations handle many aspects of the 3D behavior of shear waves in complex media, there are serious gaps. In particular, step ...

    SBIR Phase II 2001 Department of Energy
  4. Direct Lamination Cooling of Motors for Electric Vehicles

    SBC: AEROVIRONMENT, INC.            Topic: N/A

    60765 Current designs for electric motors use a housing that acts as both a structural support and as a method of cooling the stator and rotor. This approach to cooling is not as effective as possible because heat must flow from the rotor and stator through the housing to the cooling media. Because the housing must contain the coolant, it is also larger, heavier, and more expensive than n ...

    SBIR Phase II 2001 Department of Energy
  5. A Novel Concept to Achieve High-Packing Density of Solar Cells with High Reliability

    SBC: Amonix, Inc.            Topic: N/A

    60136 The use of photovoltaic (PV) cells for thermophotovoltaic (TPV) or reflective concentration systems will require a configuration that maximizes performance through dense cell packing and provides for high reliability through the use of bypass diodes. The lack of such a method is an impediment to the commercialization of TPV and reflective concentration systems. This project will use ...

    SBIR Phase II 2001 Department of Energy
  6. 'On Chip' Smart Sensor Array and Control Teleplatform for Thermophotovoltaic Cell Manufacturing Applications

    SBC: Arseco            Topic: N/A

    60731 Thermophotovoltaic (TPV) cells offer many opportunities as an alternate energy source. However, problems in TPV cell characterization, needed for manufacturing process control have an adverse impact on efficient cell manufacturing and yields. This project will develop an `On Chip¿ smart sensor array to characterize TPV cell parameters such as temperature gradients, poly metal sheet ...

    SBIR Phase II 2001 Department of Energy
  7. Development of Multiple-Beam Guns for High-Power Radio Frequency Sources for Accelerators and Colliders

    SBC: Calabazas Creek Research, Inc.            Topic: N/A

    60150 The current generation of high power klystrons, used in accelerators for high energy physics research, operate at voltages between 400 and 600 kV. One of the major cost drivers for these devices is the high operating voltage. Not only are the power supply costs significant, but the high voltage leads to increased circuit length, higher radiation hazards, larger insulating cera ...

    SBIR Phase II 2001 Department of Energy
  8. Advanced Design of Quasi-Optical Launchers for Fusion Plasma Heating

    SBC: Calabazas Creek Research, Inc.            Topic: N/A

    60176 Current high power gyrotron tubes, used for heating fusion plasmas, produce power in high order TE modes, which are converted to a Gaussian like mode through use of an internal mode converter and launcher. However, these converter systems typically achieve only 85-90% efficiency for conversion of cavity output power to a usable Gaussian mode, leading to significant efficiency degra ...

    SBIR Phase II 2001 Department of Energy
  9. Development of a Three-Dimensional, Finite Element Charged Particle Code with Adaptive Meshing

    SBC: Calabazas Creek Research, Inc.            Topic: N/A

    60459 The current generation of charged particle codes are unable to model practical three dimensional problems, such as those in high energy physics research, because of the large number of nodes required in the analysis. Without this design capability, it is not possible to develop many new, innovative devices that could dramatically advance the state-of-the-art in charged particle electro ...

    SBIR Phase II 2001 Department of Energy
  10. Vacuum Pump Power Supply with Controller Integrated Circuit

    SBC: Champion Research            Topic: N/A

    60768 Present technology vacuum pump power supplies do not provide the features needed for the Next Linear Collider (NLC). Most are located some distance from the pumps themselves, requiring high voltage distribution cables that can break down electrically due to radiation induced damage and cause fires. Those power supplies that do mount on pumps do not have serial control or adequately pr ...

    SBIR Phase II 2001 Department of Energy

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government