Award Data

The rotorcraft aerodynamic interaction is a complicated problem and remains an extremely challenging aspect of rotorcraft analysis. This STTR is dedicated to developing a solution for the complicated rotorcraft aerodynamic interaction problem. The Phase I research coupled a state-of-the-art vortex particle method (VPM) with an unstructured Navier-Stokes CFD body surface solver and prototyped a hyb ...

Aerius Photonics is proposing to develop high-power Vertical Cavity Surface Emitting Lasers (VCSELs) and arrays on 4” substrates with an integrated thermal management approach to improve the thermal performance on an entirely wafer-level manufacturing compatible process. This is critical as waste heat and wafer-scale manufacturing approaches are driving factors for performance and costs in a la ...

Transphorm proposes to demonstrate a normally off fast high voltage Gallium Nitride power switch solution. The switch would block to 1200V, have a threshold voltage greater than 5 V, and the phase 2 switch will target an on resistance less than 15 ohm-mm and current more than 1 Amp. To accomplish these targets, Transphorm will combine the design requirements of realizing a high (and positive) thre ...

This Small Business Technology Transfer (STTR) Phase II project proposes the development of an integrated powered knee-ankle prosthesis. The objective of this proposal is to investigate the use of integrated powered knee and ankle joints in trans-femoral prostheses that use sensory information from the ground and the wearer. The hypothesis is that a prosthesis with actively powered knee and ankle ...

New material systems are required as a result of advanced performance criteria for the next generation destroyer program and other Navy ships. As a part of these requirements there is high demand for high strength structural composites. The objective of the STTR Phase II project is to develop high strength and light weight structural composites utilizing functionalized single-walled carbon nanotub ...

We propose to demonstrate and advance several key aspects of our novel, scalable ammonothermal technology for growth of high quality single crystal gallium nitride. Specifically, we propose to demonstrate a high growth rate and high crystalline quality, to design and analyze a pilot-scale reactor, and to construct and validate a quantitative model to describe the fluid dynamics of the growth envi ...

We need transformational manufacturing technologies for fabrication of nanomaterials for manufacturing batteries and capacitors that will have a huge impact on improving the energy and power density of batteries and capacitors for transportation, energy storage and consumer electronics applications. Development of novel nanomaterials with high energy and power capability and a novel, nontraditiona ...

The Phase I effort was successful in experimentally showing feasibility of a combined isotope transmitter that can be developed and demonstrated under the Phase II program. The initial experimental results give the window of gas mixtures for a stable discharge. Laser extraction tests were accomplished with C12/C13 mixtures to give guidance for further work to increase laser gain. For application ...

Results of the Phase I work showed that an advanced, compact Point Sensor can be built with good sensitivity for detection of both biological agents and chemical aerosol and vapor agents. This will be the first point sensor capable of this dual role. The

Early detection of virulent infectious pathogens is critical to blocking the devastating epidemic spread of the pathogen and the potential harm this could have on our armed forces and general populations. In Phase I, we have utilized the state-of-the-art QuantiGene 2.0 technology to establish an assay for the sensitive quantification of SARS (epidemic spread in 2001) and assessing plasma DNA level ...