List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. A Novel Growth Technique for Large Diameter AlN Single Crystal

    SBC: Fairfield Crystal Technology            Topic: 22

    Nitride-based, high-brightness, ultraviolet, visible, and white light emitting diodes are candidate devices for replacing incandescent light bulbs and fluorescent light fixtures in general illumination applications, due to their tremendous energy saving potential, long lifetime, and high efficiency. However, the poor crystalline quality of the nitride epilayers, resulting from severely lattice-mi ...

    SBIR Phase II 2006 Department of Energy
  2. Ferroelectric Switch for a High-Power Ka-Band Active Pulse Compressor

    SBC: Omega-P, Inc.            Topic: 37

    A future multi-TeV collider requires the development of new technology to achieve a much higher acceleration gradient. An active pulse compressor would enable this development by multiplying the power of Ka-band microwave pulses to obtain peak power levels that are unattainable from a single source. This active pulse compression can be achieved by rapidly switching the coupling between delay li ...

    SBIR Phase II 2006 Department of Energy
  3. Dielectric-Lined High-Gradient Accelerator Structure

    SBC: Omega-P, Inc.            Topic: 37

    A future multi-TeV collider requires the development of new technology to achieve its high acceleration gradient. An accelerator structure that embodies a dielectric-lined waveguide, which offers the promise of sustaining a high acceleration gradient, is currently under development. However, the all-metal structures used to achieve the high acceleration gradient have encountered limits from micr ...

    SBIR Phase II 2006 Department of Energy
  4. Foil Gas Bearing Supported High Speed Centrifugal Blower

    SBC: R&D Dynamics Corporation            Topic: 14

    The efficiency of solid oxide fuel cells can be increased with anode gas recycling, leading to a lower overall system cost. Therefore, in this project, a motor driven, high-speed, high-temperature Anode Gas Recycle Centrifugal Blower will be designed, manufactured and demonstrated. A high-speed direct drive motor, combined with foil gas bearing technology, will result in a low cost, efficient, s ...

    SBIR Phase II 2006 Department of Energy
  5. A New PIT Nb3Sn Process, Toward Improved Cost-Performance for HEP High Field Magnets

    SBC: Supramagnetics, Inc.            Topic: 35

    The development of improved, cost-effective Nb3Sn superconductors would have an immediate benefit for high field magnets in High Energy Physics (HEP) applications. This project will develop and demonstrate an economical powder-in-tube (PIT) Nb3Sn process for use in magnets for future HEP accelerator research. In Phase I, a low-cost, intermetallic, phase-pure Cu5Sn4 powder was developed, a PIT Nb ...

    SBIR Phase II 2006 Department of Energy
  6. N/A

    SBC: Advanced Fuel Research, Inc.            Topic: N/A

    This subtopic solicited Phase I R&D for an advanced Fourier transform infrared (FT-IR) system that would provide fast-scanning high resolution (3 scans/sec at 1cm-1 resolution), low noise, mid-infrared measurements for characterization of spray flames. In Phase I, Advanced Fuel Research, Inc. (AFR) demonstrated FT-IR emission/transmission (E/T) measurements from the NIST spray combustion faci ...

    SBIR Phase II 2001 Department of Commerce
  7. Advanced Cathode Structure for Oxygen Reduction in PEM Fuel Cells

    SBC: FuelCell Energy, Inc.            Topic: N/A

    60774 In order to be commercially competitive, Proton Exchange Membrane (PEM) fuel cells have to meet an acceptable level of performance and cost targets for building applications. Most fuel cell performance losses occur at the cathode oxygen reduction reaction (ORR). Improvements in cathode performance are needed in order to increase fuel cell efficiency and reduce stack cost. This proje ...

    SBIR Phase II 2001 Department of Energy
  8. Plasma Switch for High-Power Active Pulse Compressor

    SBC: Omega-P, Inc.            Topic: N/A

    60059 A previously built Active Bragg Compressor (ABC) had been shown capable of rapid switching of 11.4 GHz microwave energy stored in a resonant cavity, in order to produce a compressed 50-100 nsec pulse with a peak power gain of 10-12. However, the peak output power in the ABC was limited to about 100 MW due to spontaneous breakdown of the switch. This project will develop a modified pl ...

    SBIR Phase II 2001 Department of Energy
  9. Dielectric Wake Field Resonator Accelerator Module

    SBC: Omega-P, Inc.            Topic: N/A

    60975 The wake field induced by passage of a high charge bunch along a dielectric-lined wavequide is attractive for high-gradient electron acceleration, such as used in high energy physics research, since no external source of radiation is needed. Recently, it was pointed out that a train of short moderate charge bunches can be arranged to induce cumulative buildup of wake fields. Howeve ...

    SBIR Phase II 2001 Department of Energy

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government