List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. SBIR Phase I: In Situ Three-dimensional Surface Roughness Gauge

    SBC: 4 D Technology Corporation            Topic: MI

    This Small Business Innovation Research Phase I project will demonstrate feasibility of the first metrology system capable of quantifying surface roughness in three dimensions in situ in production environments. Current shop floor systems are almost entirely two-dimensional stylus-based systems that are fragile, incapable of measuring complex geometries and have high cost of ownership. A shop-floo ...

    SBIR Phase I 2018 National Science Foundation
  2. SBIR Phase II: Novel Radar Using 3D Printed Luneburg Lens for Autonomous Transportation

    SBC: LUNEWAVE INC.            Topic: EW

    The broader impact/commercial potential of this project will be that this research will address the resolution and detection range requirements of autonomous driving in complex environments such as urban scenarios. The next major revolution of transportation is undoubtedly autonomous driving, which will increase safety, mobility and productivity. Fully autonomous transportation may eliminate human ...

    SBIR Phase II 2018 National Science Foundation
  3. SBIR Phase I: Advancing HIgh-Power Diamond Devices Towards Commercialization

    SBC: ADVENT DIAMOND, LLC            Topic: S

    The broader impact/commercial potential of this Small Business Innovation Research (SBIR) Phase I project is the innovation of diamond technologies that will enhance the efficiency and reliability of electric vehicles, thus supporting the development of green technology and reduction of CO2 emissions. Specifically, diamond diodes will reduce powertrain losses by about a third and thus directly tr ...

    SBIR Phase I 2018 National Science Foundation
  4. SBIR Phase I: High Rate Composite Tooling

    SBC: ADVANCED CERAMICS MANUFACTURING, LLC            Topic: MI

    This Small Business Innovation Research Phase I project will develop new low cost, high performance tooling materials for composite manufacturing. The use of advanced fiber reinforced composites in aircraft has become a necessity to achieve higher performance and greater fuel efficiencies. Boeing?s 787 and Airbus?s A350 are two such aircraft that exemplify the push to increase composite content ab ...

    SBIR Phase I 2018 National Science Foundation
  5. SBIR Phase II: High multiplex visual mapping of heterogeneity in FFPE biospecimen

    SBC: BIOSYNTAGMA, LLC            Topic: BM

    This SBIR Phase II project aims to facilitate understanding of cellular diversity in tumors, a phenomenon that contributes to acquired drug resistance. Quantifying and understanding this diversity may help predict a patient?s response to certain drugs which would allow the selection of ideal drug combinations for an individual patient?s tumor, thus enabling personalized medicine. This Phase II pro ...

    SBIR Phase II 2018 National Science Foundation
  6. AM of Layered Structures

    SBC: ATS-MER, LLC            Topic: 13a

    Materials for modern nuclear reactors should meet multiple requirements- They have to be strong enough to reliably provide temperature oxidation, and be compatible with other nuclear reactor materials- Only the steels and alloys listed in Section III Division 5 of the ASME Boiler and Pressure Vessel Code are permitted for usage in nuclear reactors, but they may not be resistive enough against chem ...

    SBIR Phase I 2018 Department of Energy
  7. Automated Monitoring of the Rhizosphere using a Microbial Sensor

    SBC: BURGE ENVIRONMENTAL, INC.            Topic: 22a

    An automated, real-time monitoring system for the determination of redox and microbial activity in unsaturated zone and/or the rhizosphere environments- This would allow for improved characterization of the subsurface environments- The sensor system is based on microbial fuel cell technology- The sensor system is composed of an anode, cathode and measurement circuitry- Neither the anode or cathode ...

    SBIR Phase I 2018 Department of Energy
  8. High-Efficiency Radiation-Hard Solar Array Interface to Spacecraft Power System

    SBC: Alphacore, Inc.            Topic: AF162-007

    The Phase II SAI prototype will be developed using COTS GaN switches and CMOS drivers. During Phase II Alphacore will design and fabricate a rad-hard CMOS driver ASIC to provide electrical and on-chip algorithmic control of the GaN switches. The SAI and its components will be tested and measured under varying environmental conditions, including across temperature and radiation extremes. The GaN de ...

    SBIR Phase II 2018 Department of DefenseAir Force
  9. Low Voltage Radiation Hardened Optoelectronics for Optical Interconnects

    SBC: QuantTera            Topic: DTRA152-001

    The Defense Threat Reduction Agency (DTRA) recognizes the need for low-power high-bandwidth radiation-hard optical interconnects to process more data more quickly and to replace electronic data.Our companys core development in optical communications with semiconductor materials is a unique fit for DTRAs low-power consumption high-bandwidth radiation-hard intra-chip communication components for sat ...

    SBIR Phase II 2018 Department of DefenseDefense Threat Reduction Agency
  10. Thermally Efficient Emitter Technology for Advanced Scene/Simulation Capability in Hardware in the Loop Testing

    SBC: ROBERT A. RICHWINE, LLC            Topic: MDA15-014

    We introduce a concept and a design for a high-speed, high-temperature infrared scene projector for midwave (MWIR) and longwave infrared (LWIR) application. Results from study of carbon nanotube (CNT) material characteristics, along with field emission and electro-thermal modeling show that higheffective MWIR temperatures can be sustained and projected by a CNT pixel with little or no spillover to ...

    SBIR Phase II 2018 Department of DefenseMissile Defense Agency

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government