You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. Tunable Active HEterodyne Terahertz Imager (TAHETI)

    SBC: LONGWAVE PHOTONICS LLC            Topic: A17AT007

    LongWave Photonics, Massachusetts Institute of Technology and Virginia Diodes are proposing the use of the Terahertz Quantum-Cascade Lasers (QCL) combined with a Schottky diode detector for high dynamic range heterodyne imaging. Two single-mode, distributed feedback (DFB) QCLs with milliwatt power levels will be used as local oscillator and illumination for imaging. The QCLs will be downconverte ...

    STTR Phase I 2017 Department of DefenseArmy
  2. 3D Tomographic Scanning Microwave Microscopy with Nanometer Resolution

    SBC: Alcatera Inc.            Topic: A17AT008

    Near-Field Scanning Microwave Microscopy (SMM) is a technique relying on a raster scan of a microwave probe across a sample surface, while measuring its reflected microwave signal. The existing technologies are limited to the surface analysis, and are not compatible with liquid environment. These limitations are addressed by the proposed wideband 3D tomography SMM with sub-surface analysis capabil ...

    STTR Phase I 2017 Department of DefenseArmy
  3. Developing a Clostridium molecular toolkit for bioconversion of food waste

    SBC: SYNVITROBIO, INC.            Topic: A17AT011

    Waste generation at forward bases creates significant challenges; its disposal presents an economic cost with no direct benefit and its accumulation or burning is a health hazard. The bioconversion of waste into useful compounds could save thousands annually for every soldier and tens of millions in capital expenditure. However, widespread adoption is impeded by low conversion efficiency. We propo ...

    STTR Phase I 2017 Department of DefenseArmy
  4. Engineered Strain for Bioconversion of Food Waste to Fuels

    SBC: Technology Holding, LLC            Topic: A17AT011

    The proposed strategy in this STTR proposal for bioconversion of food waste to butanol uses the well-described Clostridium acetobutylicum organism to convert the carbohydrate to the fuel molecule butanol. Based on our teams many years of work with butanol formation and genetic studies of the organism and the advancement of recently developed genetic methods, the team will develop a set of genetic ...

    STTR Phase I 2017 Department of DefenseArmy
  5. Scalable Manufacturing of Graphite Yarns via Wet Spinning Process

    SBC: STORAGENERGY TECHNOLOGIES INC            Topic: A17AT013

    Recently, fiber/yarn-based energy-storage systems have attracted enormous attention due to their remarkable promises in smart textiles and high-tech sportswear etc., mainly as more pliable energy-storage units being truly wearable. Storagenergy Technologies Inc. proposes to develop graphite fibers (GFs), which are fabricated by a scalable and cost effective wet spinning approach, and later chemica ...

    STTR Phase I 2017 Department of DefenseArmy
  6. Biosensor for Detection of Synthetic Cannabinoids

    SBC: NANOCOMPOSIX, INC.            Topic: A17AT014

    Recreational drug use by military personnel can impact soldier preparedness and performance especially in difficult and demanding environments. One challenge for monitoring illicit drug use is that current tests rely on the identification of specific chemical structures. Small variants in the chemistry of a drug can evade detection. In this Phase I SBIR, we will develop a lateral flow test that ...

    STTR Phase I 2017 Department of DefenseArmy
  7. Method for Locally Measuring Strength of a Polymer-Inorganic Interface During Cure and Aging

    SBC: SURFORCE, LLC            Topic: A17AT016

    Achieving strong and durable polymer adhesion to inorganic substrates under various environmental conditions is challenging. The required long-term durability tests are over long time- and length-scales, beyond the capability of current modeling, and extensive experimental testing is needed. Currently, no commercially available method exists for monitoring how a polymer/substrate system evolves du ...

    STTR Phase I 2017 Department of DefenseArmy
  8. Method for Locally Measuring Strength of a Polymer-Inorganic Interface During Cure and Aging

    SBC: METNA CO            Topic: A17AT016

    A robust, versatile and portable test system will be developed based on the NMR relaxometry/diffusomtry principles for thorough, reliable, expedient and economical nondestructive evaluation of the polymer/inorganic interface structure and properties. NMR relaxometry/diffusometry probes sensitive volumes that can be moved to scan the interface. This nondestructive test measures a number of paramete ...

    STTR Phase I 2017 Department of DefenseArmy
  9. Dismounted Soldier Positioning, Navigation and Timing (PNT) System Initialization

    SBC: Integrated Solutions for Systems, Inc.            Topic: A17AT017

    Integrated Solutions for Systems, Inc. (IS4S) and teammate Auburn University (AU) propose to develop a PNT initialization system for dismounted soldiers. The proposed system will enhance warfighters ability to operate immediately in a GPS denied environments once their mission begins and has wide commercialization potential outside of DoD. In Phase I, the feasibility and expected benefits of inte ...

    STTR Phase I 2017 Department of DefenseArmy
  10. Two-color Infrared Laser Arrays for Scene Projection

    SBC: ATTOLLO ENGINEERING, LLC            Topic: A17AT018

    Current scene projection hardware is challenged to simultaneously meet the requirements for high peak temperature (> 2000K), high resolution (> 1Kx1K), response time < 1 ms, cryogenic and temporally uniform photon flux. MEMS, Resistor arrays, liquid crystals, and photonic crystals all suffer in one or more areas. MEMS suffer from flicker and low dynamic range. Resistor arrays suffer from low frame ...

    STTR Phase I 2017 Department of DefenseArmy
US Flag An Official Website of the United States Government