Award Data

Traditional methods of manufacturing ceramic domes with an embedded grid involves manufacturing two thin and precise domes that fit together, placing a grid between them, and bonding the assembly together. This method is costly as the optician has to make two precise domes to make embedded grid dome". For the Low Cost Finishing of optical Ceramic Domes with Embedded Grid, phase I SBIR, we plan to ...

The team of Monolith Semiconductor, X-FAB Texas, Rensselaer, United Technologies and Univ. of Arkansas will provide breakthrough advances in switch performance and manufacturing cost reduction to deliver cost-effective 100Amp, 1200V SiC power MOSFETs to enable widespread adoption. Based on the combined expertise in both Silicon and SiC power device design and processing, Monolith Semiconductor is ...

Because of the overwhelming migration to composites, particularly exotic thermoset materials from the bismaleimide (BMI) family, the PNTS team is focusing its work on this topic on composite structures. The team's high level approach will be to demonstrate an innovative and practical design using dielectric spectroscopy at millimeter wave through terahertz frequencies that will provide compos ...

Millimeter-wave RADAR imaging holds significant promise for many applications from rotorcraft DVE mitigation to standoff security screening. A key challenge of this imaging modality, however, has been the implementation of an effective method for creating an image without relying on either mechanical scanning or expensive, high SWAP phased array techniques. Herein, we present a concept for creat ...

We propose a meta-surface consisting of a periodic array of metal-like patches that will allow focusing and steering a radiation beam in the millimeter frequency range. The direction of the beam will be controlled by controlling the phase change acquired by the beam as it is transmitted through this metasurface. The phase change at the surface is controlled by the shape and capacitance of metall ...

New enhancements to mobile computers including smaller sensors, displays and powerful processors have made them much more attractive for the battlefield, not only as wearable systems for soldiers, but also unattended ground sensors a warfighter can leave behind for situational awareness. Unfortunately, while the technologies for hands-free interfacing have improved greatly, the challenge of limiti ...

In the proposed effort, we will leverage this extensive experience and capabilities to realize a frequency agile mmW radiometer that can cover the range of DC-110 GHz and can be scaled to DC-200 GHz under Phase II. Ours is a photonic system that multiplies and up-coverts a low-frequency reference signal onto an optical carrier (laser) using EO modulation, then uses the modulation sidebands to inj ...

Accurate flow calculation is crucial to the development and support of air platforms, and CFD has been successful at predicting aerodynamic performance for a variety of flows. The accuracy of CFD is governed by the quality of the surface mesh, and much work has been undertaken to automatically generate surface grids from CAD. Unfortunately, quality is quantified in terms of conformance to the surf ...

This SBIR Phase I proposal is aimed at the development of the ultra-sensitive detector for the far infrared (FIR) and terahertz (THz) bands of electromagnetic radiation. The device is inherently optical, operates at room temperature and of submillimeter size. The proposed technology is based on coupling the radiation to be measured to the mechanical degree of freedom of an optical microcavity and ...

As new applications arise for small gas turbine engines, the need to advance engine component technologies becomes essential, since they are required to run faster, hotter, and longer. Particularly critical in this regard are the shaft bearings. Since they operate without lubricant, air foil bearings have been identified as viable replacements to conventional liquid lubricated bearings. An adva ...