List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Development of Corrosion Resistant Prestressed Concrete Strands Utilizing Liquie Plasma Technology

    SBC: CAP Technologies LLC            Topic: 141FH6

    This proposal is to prove the feasibility of a new and novel zinc-based alloyed coating on both the manufactured Grade 270 0.5 and 0.6 low-relaxation strands and for the individual wires used to make the 7-wire strand for prestressed concrete used in bridge construction. The application of the coating will use CAP Technologies LLC [CAP] proprietary and patented foam plasma technology also kn ...

    SBIR Phase I 2014 Department of Transportation
  2. Hybrid Laser Arc Welding for Thick Plate High Performance Steels

    SBC: TECHKNOWSERV CORP            Topic: 132FH1

    High performance steels were developed in a cooperative program between the Federal Highway Administration (FHA), the American Iron and Steel Institute (AISI), and the U.S. Navy Carderock Division of the Naval Surface Warfare Center. HPS70W high strength steel is currently being used in bridge structures. HPS is stronger than conventional 70W steel and has less than 15% of the sulfur and 60% of th ...

    SBIR Phase I 2014 Department of Transportation
  3. Novel CO2 Gas Sensors for Autonomous Measurement of Ocean Carbon

    SBC: DIOXIDE MATERIALS, INC.            Topic: 82

    The objective of the proposed work is to determine whether Dioxide Materials' miniature C02 sensors have the potential to be adapted for autonomous measurement of ocean carbon. The existing sensors have many advantages for measurements of ocean carbon. They are much smaller and less costly than the existing sensors, work with much smaller gas samples, and use much less power. The sensors were d ...

    SBIR Phase I 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  4. 120-X-2 Unmanned Aircraft System-Borne Atmospheric & Sea Surface Temperature (SST) Sensing

    SBC: Piasecki Aircraft Corporation            Topic: 84

    To capture critical weather and SST data in the Tropical Cyclone Boundary Layer (TCBL), Piasecki Aircraft proposes to evaluate existing meteorological sensor packages, integrate new off-the-shelf MEMS sensors, and design an air-launched UAS to improve the resolution of observations captured in the TCBL. Capturing latent and sensible heat fluxes can be achieved reliably with a powered UAS (compare ...

    SBIR Phase I 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  5. Self-Contained Sub-Centimeter Positioning Platform

    SBC: TRUNAV LLC            Topic: 81

    The goal of this project is to develop, implement, and experimentally validate a new Differential Global Navigation Satellite System (DGNSS) capable of providing sub-centimeter positioning accuracy for quasi-static scientific, mapping, and survey applications. The main feature of the proposed DGNSS solution is that it leverages GNSS reference data from existing NOAA's Continuously Operational Ref ...

    SBIR Phase I 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  6. Dynamic Frequency Passive Millemeter-Wave Radiometer Based on Optical Up-Conversion

    SBC: Phase Sensitive Innovations, Inc.            Topic: 94

    Passive microwave sensors aboard satellites provide valuable information regarding weather conditions by measuring atmospheric attenuation over a broad range of frequencies from 0-200 GHz. Additional ground-based sensors are desirable to provide complementary upward looking measurements that can be used to refine existing attenuation models. Operating over such a large bandwidth, however, places ...

    SBIR Phase II 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  7. Crack Arrest and Structural Repair of High Strength Steel Piping by In-Situ Sleeving of Nanostructural Materials

    SBC: Integran Technologies U.S.A. Inc.            Topic: 07PH1

    This proposal describes the application of a mature nanotechnology-based crack arrest / structural repair technology as a novel crack arrestor tool for high-strength pipelines. The crack arrestor would comprise a thin layer or sleeve of electrodeposited nanocrystalline material applied to the outside of the pipe either in the coating mill during fabrication or in-field during or following constru ...

    SBIR Phase I 2008 Department of Transportation
  8. Structural Repair of Steel Piping by In-Situ Sleeving of Nanostructured Materials

    SBC: Integran Technologies U.S.A. Inc.            Topic: N/A

    This proposal describes the application of a mature nanotechnology-based crack arrest/structural repair technology as a novel in-field pipeline repair tool. The repair would be comprised of a thin layer or sleeve of electrodeposited nancrystalline material applied to the damaged region of the pipe in order to utilize the "crack filling" characteristic of the process. The concept proposed has alr ...

    SBIR Phase I 2008 Department of Transportation
  9. Locking Mechanism for Rotating Seats

    SBC: Kustom Seating Unlimited Inc. (KSU)            Topic: 07FR1

    Research is proposed to develop a locking mechanism for intercity (Amtrak) rotating seats that can be retro-fit to existing seats. Current intercity rail seats, according to the National Transportation Safety Board (NTSB), present a safety hazard to the riding public. Post accident investigations show that passenger rail seats were found to have been uncontrollably rotated even though current se ...

    SBIR Phase I 2008 Department of Transportation
  10. Compact Laser Shearography System for Crack Detection

    SBC: Laser Technology Inc.            Topic: 05FH1

    Laser Technology Inc. (LTI) proposes a Phase II SBIR research project to further develop a Compact Shearography System, Analysis Method and Software for micro-crack detection in concrete. There is an urgent need to detect and characterize fine cracks in concrete that form because of various damage mechanisms including alkali-silicate reaction, delayed ettringite formation or frost damage. Fine s ...

    SBIR Phase II 2008 Department of Transportation

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government