Award Data

This project addresses the specific need for an improved method for cleaning insulators that electrically isolate the third rail. Current methods are labor intensive and expensive, but the insulators should be cleaned regularly to avoid even greater expense. This project is to adapt an innovative photolytic paint stripper to cleaning insulators for the third rail. The overall objective is to de ...

An optical, non-contact roof deformation monitoring system will be designed based on an existing multi-point, non-contact, multi-axis optical sensor-based measurement system that is currently used to measure chest deflection in crash-test dummies. The research involves determining suitable components to be used in the optical path, from high-power LED arrays through lenses and optical sensors. T ...

This proposal describes the application of a mature nanotechnology-based crack arrest / structural repair technology as a novel crack arrestor tool for high-strength pipelines. The crack arrestor would comprise a thin layer or sleeve of electrodeposited nanocrystalline material applied to the outside of the pipe either in the coating mill during fabrication or in-field during or following constru ...

More that 52% of the U.S. highway congestion in urban areas is a direct result of highway incidents. Federal and State transportation authorities are searching for quick, low-cost and efficient highway incident detection and warning systems. Several solutions have been proposed but none could meet the requirements of transportation authorities. Central Signal, funded by federal agencies, has done ...

Laser Technology Inc. (LTI) proposes a Phase II SBIR research project to further develop a Compact Shearography System, Analysis Method and Software for micro-crack detection in concrete. There is an urgent need to detect and characterize fine cracks in concrete that form because of various damage mechanisms including alkali-silicate reaction, delayed ettringite formation or frost damage. Fine s ...

Research is proposed to develop a locking mechanism for intercity (Amtrak) rotating seats that can be retro-fit to existing seats. Current intercity rail seats, according to the National Transportation Safety Board (NTSB), present a safety hazard to the riding public. Post accident investigations show that passenger rail seats were found to have been uncontrollably rotated even though current se ...

The FRA has identified cab car end door kick panels as possible emergency egress panels. They could be used in circumstances where the convential emergency exits are unusable. The industry has operational and maintenance concerns. The objectives of this SBIR are to define the requirements for end door emergency egress panels and identify alternative design approaches and assess their effectiven ...

Railroad freight car safety and maintenance cost is directly related to knowledge of the actual braking force provided by a brake shoe. If the brake force is too low, safety is at risk. If the brake shoe is replaced before the end of it's lifetime to ensure safety, maintenance and thus operating costs are increased. Currently there is no system in place to monitor brake shoe force during train ...

Development of the basic EMAT based transverse rail defect detector has progressed toward finished form, as envisioned in the original solicitation. This modification is intended to produce a demonstratable version of a 2-rail detection system with automated signal interpertation. The objectives of this work are to: a. Further develop the system into a functioning 2-rail detection system, as ori ...

During Phase 1 of the project, Sharma & Associates, Inc. developed a concept for high speed freight truck intended for 70-ton, regular freight and bi-modal operation, at speeds up to 150 mph. The truck uses a rigid frame and an indpendent, compliant, primary suspension for its basic architecture. Constant contact side-bearings and yaw dampers were also added to improve dynamic performance. Vehi ...