You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. Fast Response Fabric Test Setup and Dynamic Fabric Model for BURNSIM

    SBC: Advanced Cooling Technologies, Inc.            Topic: AF071025

    Advanced Cooling Technologies, Inc. (ACT) will develop a Fast Thermal Response Fabric Test Setup for various thermal hazard scenarios involving convection (hot gas impingement by the jet engine exhaust), radiation (fire) and combination of convection and radiation (post-crash fire of aircraft, fire flash or bomb blast). The fabric test setup will (i) measure the thermal response of various clothin ...

    SBIR Phase II 2008 Department of DefenseAir Force
  2. Develop High-Temperature, Low-Humidity Aromatic Hydrocarbon-based H2/O2 Membranes for Proton Exchange Membrane (PEM) Fuel Cells

    SBC: AKRON POLYMER SYSTEMS, INC.            Topic: AF071130

    In order to achieve high performance at acceptable cost, PEM fuel cells are required to work at elevated temperature and low relative humidity (near 0 RH) for extended periods of time. However, to date, no commercial PEMs or publicly reported PEMs can meet these requirements. The objectives of this work are: (1) to develop PEMs that have high proton conductivities (50-100 mS/cm) and low area-spec ...

    SBIR Phase II 2008 Department of DefenseAir Force
  3. Environmentally Friendly Cleaning for Titanium Welds and Brazing

    SBC: APPLICATIONS TECHNOLOGIES CO.LLC            Topic: AF06326

    The first critical step in welding or brazing is cleaning to remove surface contamination. The Air Force has a need for an environmentally cleaning method that has no waste stream, minimal requirements of personal safety protection, and does not impact component integrity. The Arc Scrubber is an emerging non-chemical cleaning technology that utilizes and electrical arc to remove surface contamin ...

    SBIR Phase II 2008 Department of DefenseAir Force
  4. Unresolved Resident Space Object Characterization Using Time-Frequency Analysis

    SBC: Applied Optimization, Inc            Topic: AF071283

    Applied Optimization, Inc. [AO] proposes to demonstrate full feature characterization of unresolved RSOs by performing spectral unmixing and time-frequency analysis of its time and spectrally resolved signature in the visible or infrared spectrum. The characterization will be performed step-by-step by following a taxonomy of feature extraction. Materials identification will be performed via spectr ...

    SBIR Phase II 2008 Department of DefenseAir Force
  5. HARV/LRF: Head-Aimed Remote Vision System for Surveillance and Targeting

    SBC: CHATTEN ASSOC., INC.            Topic: A07044

    This proposal addresses the need for a smart, network-compatible, enhanced head-aimed video sensor system to enable geo-location and target hand-off from robotic platforms. The sensor system provides enhanced remote situational awareness, with specific features aimed towards reconnaissance and surveillance, and target identification and designation missions. This same sensor is also applicable t ...

    SBIR Phase II 2008 Department of DefenseArmy
  6. High Sensitivity Rugged Array Detectors for Field Deployed Instruments: Low-Light Level Camera for Laser-Induced Breakdown Spectroscopy (LIBS) and Ram

    SBC: B & W Tek Inc.            Topic: A06065

    Laser-induced breakdown spectroscopy (LIBS) and Raman spectroscopy are developing rapidly for chemical and biochemical sensing applications. There is an urgent need for high-sensitivity detectors so as to minimize sample quantity and maximize detection range from the source. In most field-deployable spectrometers, a photo-detector array is used for analyzing the spectral contents. The sensitivitie ...

    SBIR Phase II 2008 Department of DefenseArmy
  7. Advanced NDE for SiC Optics Using Micromachined High Frequency Phased Array Ultrasound

    SBC: TRS CERAMICS, INC.            Topic: AF071142

    TRS is pleased to propose an in-situ NDE imaging tool for SiC mirror surface damage (SD), sub-surface damage (SSD) and trapped internal stress detection using piezo-composite based micromachined ultrasound transducer (PCMUT) phased array technology. PCMUT technology has been developed at TRS to fabricate high frequency ultrasound transducers with broad bandwidth and high sensitivity. Phased array ...

    SBIR Phase II 2008 Department of DefenseAir Force
  8. A Common, Low-Cost HF Submarine Sonar Projector

    SBC: TRS CERAMICS, INC.            Topic: N07066

    TRS Technologies, Inc. and Nothrop Grumman Undersea Systems (NGUS) propose to develop and test a single crystal sonar array that adds transmit capability to the currently proposed receive array for the Virginia-class submarine. The goal of this program will be to adapt the added capability to the current form factor, thereby getting maximum return for minimal modifications and interface changes. B ...

    SBIR Phase II 2008 Department of DefenseNavy
  9. Single Crystal 1-3 Composite Projectors for MCM Applications

    SBC: TRS CERAMICS, INC.            Topic: N07076

    TRS Technologies and the Applied Research Laboratory at Penn State propose to build on high frequency (>100 kHz) single crystal, 1-3 composite projector work developed in the Phase I program for sonar in unmanned vehicles. The high bandwidth exhibited by the composite, and potential for increased source level could greatly improve data collection, while limiting impact on vehicle volume. In the Ph ...

    SBIR Phase II 2008 Department of DefenseNavy
  10. Cost-Effective Fabrication of Piezoelectric Single Crystals Device Elements

    SBC: TRS CERAMICS, INC.            Topic: N06083

    For this Phase II effort TRS Technologies, Inc., in collaboration with Rochester University, the Pennsylvania State University Electro-Optics Center and Penn State Applied Research Laboratory, will develop manufacturing processes to fabricate single crystal piezoelectric components with Zero Surface Defects (ZSD). During Phase I we showed that such crystals have 3 times the mechanical strength of ...

    SBIR Phase II 2008 Department of DefenseNavy
US Flag An Official Website of the United States Government