You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. IM Modeling/Simulation Tool for KEI Dynamic/Thermal Loads Associated with Stage Separation

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: MDA06041

    Intense dynamic and thermal loads will occur during stage-separation events that are of major concern from both operational and safety viewpoints. The insensitive-munitions (IM) stimuli and thermal/dynamic response associated with such events has received very little attention, yet this is of major concern for the KEI vehicle undergoing Stage 1 to Stage 2 separation. The KEI event is at lower alti ...

    SBIR Phase II 2008 Department of DefenseMissile Defense Agency
  2. Optimal Sensor Scheduling for Ballistic Missile Defense

    SBC: DANIEL H. WAGNER ASSOCIATES, INCORPORATED            Topic: MDA06009

    Our Phase I research involved the development of an innovative sensor scheduling algorithm in support of Ballistic Missile Defense. This algorithm schedules multiple diverse and distributed sensors to perform time-critical tasks relating to multiple moving targets; specifically, to detect, classify, localize, track, support the interception of, and conduct BDA for ballistic missiles throughout t ...

    SBIR Phase II 2008 Department of DefenseMissile Defense Agency
  3. Compact Laser Shearography System for Crack Detection

    SBC: Laser Technology Inc.            Topic: 05FH1

    Laser Technology Inc. (LTI) proposes a Phase II SBIR research project to further develop a Compact Shearography System, Analysis Method and Software for micro-crack detection in concrete. There is an urgent need to detect and characterize fine cracks in concrete that form because of various damage mechanisms including alkali-silicate reaction, delayed ettringite formation or frost damage. Fine s ...

    SBIR Phase II 2008 Department of Transportation
  4. Safe High Power (High Rate) Lithium Battery for MKV (Missiles) with Long storage Life

    SBC: LithChem Energy / Div. of TOXCO, inc.            Topic: MDA06026

    r

    SBIR Phase II 2008 Department of DefenseMissile Defense Agency
  5. Low Cost Transverse Rail Defect Detector

    SBC: Mide Technology Corporation            Topic: 02FR1

    Development of the basic EMAT based transverse rail defect detector has progressed toward finished form, as envisioned in the original solicitation. This modification is intended to produce a demonstratable version of a 2-rail detection system with automated signal interpertation. The objectives of this work are to: a. Further develop the system into a functioning 2-rail detection system, as ori ...

    SBIR Phase II 2008 Department of Transportation
  6. Lethality Enhancement by Hi-Therm Reactive Materials

    SBC: GENERAL SCIENCES INC            Topic: N/A

    "The Phase I effort produced very important and encouraging results in terms of interceptor lethality enhancement. This was achieved by the innovative development and testing of high density reactive composites which as projectiles or impacting structurescan deliver large amounts of chemical energy to the target in addition to kinetic, in a non-parasitic manner. This effort proved that (a) these ...

    SBIR Phase II 2002 Department of DefenseMissile Defense Agency
  7. Evaluation of Composite Joints in General Aviation Structures

    SBC: Materials Sciences LLC            Topic: N/A

    During the Phase I program, MSC demonstrated a powerful new software tool designed for the analysis of bonded joints in General Aviation (GA) aircraft. The tool can handle the complex geometry and boundary conditions found in typical joints, and has been shown to be exceptionally accurate. An easy-to-use front end to the code was also demonstrated. In addition, Materials Sciences Corporation (M ...

    SBIR Phase II 2002 Department of Transportation
  8. Innovative Multi-cellular Pultruded Composite Guardrail

    SBC: Creative Pultrusions, Inc            Topic: N/A

    N/A

    SBIR Phase II 2001 Department of Transportation
  9. High Performance 2:17 Permanent Magnets for Traveling Wave Tubes

    SBC: Electron Energy Corporation            Topic: N/A

    The objective of this effort is to develop high performance rare earth permanent magnets with essentially constant magnet properties over a wide temperature range of -50 to 350oC, and which can survive temperatures as high as 500oC, for TWT applications.The combination of a light rare earth (Sm) with heavy rare earths (Gd, Er, and Ho) provides very low temperature coefficients of magnetic properti ...

    SBIR Phase II 2001 Department of DefenseMissile Defense Agency
  10. LOW COST MODULE DEVELOPMENT (kTC k016)

    SBC: k Technology Corporation            Topic: N/A

    kTC's high performance thermal core technology offers the potential of significant cost savings by allowing the use of low cost commercial components without the need for liquid flow through thermal cores. kTC's encapsulated APG thermal core is a highconductivity (>1000WmL) macrocomposite comprised of annealed pyrolytic graphite (AG) encapsulated within an aluminum sheet. In Phase I, k Technolog ...

    SBIR Phase II 2001 Department of DefenseMissile Defense Agency
US Flag An Official Website of the United States Government