Award Data

Modern DoD applications are benefiting from the proliferation of EO/IR sensor technology. As imagers become cheaper and smaller, they are being more widely deployed for a variety of scenarios. This trend is exemplified by the Navys Future Targeting System (FTS), which will provide laser designation, laser spot imaging, and some target location functions in a single 5.5-pound unit, replacing discre ...

The primary objective of this Phase I proposal is to design, develop, and demonstrate the feasibility of a power factor compensation device for a 65 kVA, 115V, 400-Hz aircraft power system. Based on identified power factor conditions in the F-18 Super Hornet platform, the compensation system must correct an existing leading 0.98 power factor to a target lagging 0.93 (minimum objective lagging 0.97 ...

This Phase II SBIR project will continue the development of an optical sorter that will be used to estimate drop sizes in sprays. The optical sorter will determine the size of drops in the 0.1 to 10 microns range. Drops in this size range are prevalent in the automobile industry, where the fuel injection pressures have increased tremendously over the past two decades. These newer injectors provide ...

To reach the end user, oil and gas production at the wellhead must be transmitted through the country and distributed to a wide range of customers. This logistical system requires natural gas gathering lines, processing facilities, product storage tanks and lots of other equipment. What results is air pollution caused by industry losses during these operations and the use of continuous or intermit ...

The goal of this project is the formulation a rigid, insulating, low-density wood composite, with physical and thermal properties comparable to fossil fuel derived foams. _x000D_ _x000D_ To achieve energy conservation standards mandated by certification agencies such as Passive House and LEED, high performance buildings require multiple shells of insulation – an inner shell that contains electri ...

The Candent Technologies “Reduced Cavitation, High Efficiency Outboard Propulsor for Small Planing Craft” Phase II program is structured to develop an advanced waterjet propulsor for the Combat Rubber Raiding Craft (CRRC). This new axial flow waterjet propulsion system is designed as a “bolt on” assembly that replaces the lower unit of the existing MFE 55 outboard motor. This new propulsio ...

To reduce size, weight, power and cost (SWaP-c), military platforms have been evolving towards more integrated platforms that utilize all available space. For radiating systems, this will require exploring innovative design methods, materials and manufacturing approaches to realize cost-effective, customizable and conformal antennas. An attractive solution to this challenge is offered by additive ...

This project aims to develop a low-cost millimeter-wave (mmW) imaging system for ground vehicles, to operate in combination with a long-wave infrared (LWIR) camera. Such a system will mitigate the challenges of driving in degraded visual environments (DVE) including night time, fog, dust, or smoke by providing real-time image of the vehicle surrounding independent from the presence of naturally oc ...

The purpose of this proposal is to demonstrate the feasibility, through modeling and simulation, of integrating engineered polyhedral Phase Transforming Cellular Matrix (PXCM) materials as a dynamic, elastically deformable solution for non-pneumatic tires that can; 1) resist loss of mobility due to hazards that include ballistic/explosive threats, and road debris, 2) extend capability allowing the ...

The objective of this project is to develop a modular, open-architecture, physics-based ground vehicle mobility prediction software tool for world-wide terrains that are encountered in military applications including on-road and off-road soft soil terrains. The tool will integrate three modules: (1) Physics-Based Vehicle-Terrain Modeling tool; (2) Geographic Information System (GIS); and (3) Stoch ...