You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. High Pressure Fuel Injected Stoichiometric Engine System

    SBC: ADIABATICS INC            Topic: N/A

    Two major objectives of the U.S. Army is to increase power density and reduce heat rejection. Reducing airflow requirements of the deisel engine will contribute toward both of these objectives. Reducing air-fuel ratio requirements is one of the major cost effective approaches available for significantly increasing power output and reducing heat rejection in today's power output diesel engine. Po ...

    SBIR Phase II 1997 Department of DefenseArmy
  2. Advanced Ground Vehicle Propulsion Technology- High Temperature Tribological Considerations

    SBC: ADIABATICS INC            Topic: N/A

    The primary roadblock to the success of the high output Low Heat Rejection (LHR) diesel engine requiring little or no water cooling is the lack of effective liquid lubrication where target top ring reversal (TRR) temperatures between the cylinder liner and piston ring approach 1000 degrees F. Adiabatics, Inc. has developed a Thermo-sealed plasma sprayed Fe2O3 tribological coating which provides e ...

    SBIR Phase II 1997 Department of DefenseArmy
  3. Enhanced Ozone Treatment of Wastewater With Perfluoromembranes

    SBC: COMPACT MEMBRANE SYSTEMS, INC.            Topic: N/A

    Ozone treatment of wastewater to destroy organic contaminants prior to discharge into the environment is an extremely effective advanced oxidation technology. To date the use of this powerful technology has been limited in part by the relatively high capital costs of an efficient ozone to water, gas-liquid, mass transfer system. Existing ozone injection devices must overcome the inherently low m ...

    SBIR Phase I 1997 Environmental Protection Agency
  4. Reduced NOx/Hydrocarbon Emissions via Oxygen Enriched Lean Burn Engines

    SBC: COMPACT MEMBRANE SYSTEMS, INC.            Topic: N/A

    Lean burn spark engines are a promising technique to further reduce both NOx and hydrocarbon/carbon monoxide (HC/CO) engine emissions. Higher lean burn levels improve HC/CO oxidation while simultaneously reducing NOx formation. The NOx reduction is due to cooler flame temperatures. While the lean burn limit (beyond which combustion is poor) restricts further emission reductions, the use of oxyg ...

    SBIR Phase I 1997 Environmental Protection Agency
  5. Reduction of NOX from Diesel Engines Using Nitrogen Enriched Air

    SBC: COMPACT MEMBRANE SYSTEMS, INC.            Topic: N/A

    N/A

    SBIR Phase II 1997 Environmental Protection Agency
  6. Enhanced Processing of Green Solvents

    SBC: COMPACT MEMBRANE SYSTEMS, INC.            Topic: B

    Solvents are a valuable processing tool in the chemical and related industries. Solvent are used to enhance mass transfer, heat transfer and in most cases are a processing aid and eventually are not used in the final product but to enhance the fabrication of the final product. While solvents are very valuable, they also cause a significant problem with their volatility and associated emissions. ...

    SBIR Phase I 2013 Environmental Protection Agency
  7. Intelligent Power Management Module for Autonomous Power Generator Operation

    SBC: PC KRAUSE & ASSOCIATES INC            Topic: OSD12EP4

    The US Army and Marines rely significantly on fossil-fuel based tactical power generation to provide electrical energy to deployed troops in small camps and forward operation bases. These generators are sized to support the expected maximum power but are often operated far below rated power due to the dynamic nature of electrical loads. On average, the generators are loaded less than 50% of the ...

    SBIR Phase I 2013 Department of DefenseArmy
  8. A New Standard for Power-Aware Programming

    SBC: EM PHOTONICS INC            Topic: A13029

    New enhancements to mobile computers including smaller sensors, displays and powerful processors have made them much more attractive for the battlefield, not only as wearable systems for soldiers, but also unattended ground sensors a warfighter can leave behind for situational awareness. Unfortunately, while the technologies for hands-free interfacing have improved greatly, the challenge of limiti ...

    SBIR Phase I 2013 Department of DefenseArmy
  9. A Flexible and Extensible Solution to Incorporating New RF Devices and Capabilities into EW/ ISR Networks

    SBC: Adaptive Micro-Ware Inc.            Topic: ST13A004

    There are many different RF devices used in military networks. It is highly desirable to have scalable networks, where new devices can be readily installed without hardware or software changes elsewhere in the network. It is known that achieving this goal

    STTR Phase I 2013 Department of DefenseDefense Advanced Research Projects Agency
  10. Advanced Spectrally Selective Materials for Obscurant Applications

    SBC: LUMILANT, INC.            Topic: A13AT016

    As infrared (IR) electo-optical sensors improve in both availability and quality a strong need exists to have comparable improvements in the performance of military obscurants within the IR band. Conventional approaches for creating effective IR obscurants have relied primarily on shaped metal particles with high aspect ratios (e.g. rods, flakes). While efficient it is difficult to create very ...

    STTR Phase I 2013 Department of DefenseArmy
US Flag An Official Website of the United States Government