Award Data

The 3D-Flow Processor system is a new concept in very fast, real-time system architectures. The throughput of this system can reach up to 100 millin frames/sec, yet unlike currently available systems of comparable speed, it is fully programmable and extremely flexible. Algorithms for processing information from the input of multiple sensor can easily be implemented on a 3D-Flow system to achiev ...

Cured aircraft composite materials present a particularly difficult challenge for recycling technology. Those materials have mostly thermosetting epoxy matrices and occur in intimate association with metals, paints, and coatings. Current techniques for recycling thermoset composites, mostly for automotive sheet molding compounds (SMC), involve pulverizing the material for use as fillers. Th ...

A novel tertiary recycling process is proposed for investigation as an economical means for recycling shipboard plastic waste. Early development work has shown that this process can convert a wide variety of polymers and composites into low molecular weight hydrocarbons at temperatures below 200'C. The hydrocarbons produced can then be reused as chemicals, fuels, or monomers. Metal, glass, and fil ...

Functionally smart materials, which have to ability to perform both sensing and actuating operations, are being developed to perform many aircraft type of control events. Smart materials, fabricated suing "continuous ferroelectric fibers," are being consider for full flight control of subsonic missiles, as the servoactuator system, specifically, and for active aerodynamic surface cont ...

The goal of this program is to design and fabricate selected liquid rocket engine combustion components. This goal will be accomplished by developing a low-cost, near net-shape technology for fabrication and rapid densification of ablation and oxidation-resistant LRE components for a wide variety of Air Force missions. The material which will be used for this purpose is zirconium diboride/boron ...

This proposal is directed at creating discontinuous unidirectional composite from continuous unidirectional prepreg. The process, Selectively-Discontinuous-Fiber (SDF), introduces micro-cuts in preimpregnated unidirectional materials at specified locations. This process will allow unidirectional composite prepreg to be used for the fabrication of complex-compound components that have be ...

N/A

Current fire fighting training methods are possibly lacking maximum effectiveness due to increasing safety and environmental regulation. Additionally, performance measurement in large classes becomes difficult unless trainees have identical training scenarios and evaluations. This proposal details the analysis of current training methods and subsequent emulation of them using virtual reality (VR ...

AeroMed Software, L.L.C., proposes to develop an interactive virtual environment simulator for vertical aircraft signal training. The proposed system is intended to provide Landing Signal Enlisted (LSE) trainees with a dynamic training device similar to the operational flight trainers used by aviators. Recent advances in data acquisition, signal processing and graphics software, computer process ...

The AES International Corporation (AESI) of College Station, Texas, in concert with Texas A&M University personnel, can build an airborne ground-penetrating radar system to detect land mines from an Unmanned Airborne Vehicle (UAV). The radar itself will be a totally new and fully airworthy flight demonstration unit, the principles and characteristics of which will be conceptually similar to two p ...