Award Data

During the Phase I program, MSC demonstrated a powerful new software tool designed for the analysis of bonded joints in General Aviation (GA) aircraft. The tool can handle the complex geometry and boundary conditions found in typical joints, and has been shown to be exceptionally accurate. An easy-to-use front end to the code was also demonstrated. In addition, Materials Sciences Corporation (M ...

THE FEASIBILITY OF SMART CARDS FOR THE PUBLIC TRANSIT INDUSTRY HAS NOT BEEN ESTABLISHED. THERE IS A PERCEPTION THAT SMART CARDS CAN BE USED TO REDUCE THE TOTAL TRANSACTIONCOSTS ASSOCIATED WITH FARE PAYMENT, TO IMPROVE SECURITY, REDUCE FRAUD AND IMPROVE SYSTEM PERFORMANCE AND RIDERSHIP. THE OBJECTIVE OF THIS PROGRAM IS TO DETERMINE THE APPROPRIATENESS OF THESE CLAIMS; THIS WILL BE ACCOMPLISHED BY R ...

THE OBJECTIVE OF THIS RESEARCH IS TO DEVELOP A METHODOLOGY AND A PROTOTYPE DESIGN FOR A SYSTEM CAPABLE OF PREDICTING FAILURE OF ROTATING PARTS IN TURBINE ENGINES. SCT PROPOSES AN INNOVATIVE, INTEGRATED APPROACH THAT ASSIMILATES DATA FROM MULTIPLE SOURCES TO TREND ENGINE PERFORMANCE AND HEALTH. INDICATIONS OF COMPONENET FAILURE WILL BE IDENTIFIED AND ACTUAL DATA WILL BE COMPARED AGAINST THE INDICAT ...

THE IDENTIFICATION OF THE TYPE OF PRECIPITATION (RAIN, SNOW, FOG/HAZE, HAIL) HAS TRACTIONALLY RELIED ON HUMAN JUDGMENT. RECENTLY, THE WAVE PROPAGATION LABORATORY OF DEVELOPED A TECHNOLOGY FOR AUTOMATIC WEATHER IDENTIFICATION USING LASER SCINTILLATION AND SCATTERING. THE TECHNIQUE HAS BEEN SUCCESSFULLY TESTED IN FIELD OPERATION. HOWEVER, THE SYSTEM IS TOO CLUMSY AND EXPENSIVE FOR LARGE-SCALE FIELD ...

A SIX MONTH PROGRAM TO DEVELOP A RUGGED NEW DEVICE FOR MONITORING THE ONSET OF ICE FORMATION ON SURFACES OF TRANSPORTATION VEHICLES, ROADS, BRIDGES AND AIRCRAFTS, WILL BE DEVELOPED AND A PROTOTYPE WILL BE LABORATORY TESTED. THE NOVEL GAGE AND ELECTRONIC SYSTEM IS PARTLY BASED ON THE TECHNOLOGY APPLIED TO MEASURE CONDUCTIVITY OF SOLUTIONS. BASED ON EXISTING TECHNOLOGY, AND ALREADY TESTED UNDER HIGH ...

THERE IS A CONSTANT NEED FOR LESS COSTLY AIRCRAFT ALTITUDE SENSORS, FOR WHICH LARGE NUMBERS OF THESE SENSORS ARE REQUIRED. THE PROPOSED PROGRAM IS TO PERFORM STUDIES LEADING TO THE DEVELOPMENT OF A SURFACE ACOUSTIC WAVE (SAW) ALTITUDE SENSOR FOR AVIONICS AIR-DATA INSTRUMENTATION. THE OBJECTIVE OF THE PROPOSED PROGRAM IS TO DEVELOP A HIGH PERFORMANCE ALTITUDE SENSOR WHICH WILL UTILIZE STATE-OF-THE ...