Award Data

The ultimate goal of this Commercialization Pilot Program (CPP) effort is to design, build, and integrate flight-ready custom electronics for a 220-channel MMW distributed-aperture imager. This work bases on a previous SBIR project, in which we constructed a single-channel prototype of the phase control electronics in a laboratory (breadboard) environment. To enable control of a 220-channel system ...

Sponsored by NAVAIR, Accudyne Systems completed a Phase 1 SBIR program, developing an equipment and process concept for cost-effective fabrication of composite rotary wing main rotor blade spars. The CH-53K spar was the study focus. The recommended work cell concept combines automated tape placement, woven fabric placement, and pick and place of 45° parallelograms to layup plies, then debulk and ...

The conventional process for making dry tetrahydrofuran is very energy intensive because of the need for azeotropic distillation. Substituting distillation by membrane drying can reduce the energy consumption for heating by a factor of 50. A membrane based process for purifying tetrahydrofuran with 98% less energy consumption than with a conventional azeotropic distillation process has been demons ...

There continues to be a need for production of fuel-grade ethanol from renewable sources. Ethanol from agricultural sources has many advantages including development of fuel independence. While there continues to be a significant need for ethanol, the cost of agricultural based ethanol is quite severe although existing and new legislation provides significant incentives for its use. This program ...

Bio-oil is a liquid fuel made from biomass such as wood chips and low grade wood byproducts by fast pyrolysis process. Presence of carboxylic acids in raw-bio-oil makes the bio-oil very acidic and corrosive. Raw bio-oil has low heating value primarily because of its high water content (up to 35 %). Oligomerization aldehydes and other compounds with an unsaturated carbon bond in raw bio-oil resu ...

Commodity graphics processing units (GPUs) offer tremendous computational throughput for relatively little cost. They have been shown to outperform microprocessors in the important metrics of FLOPS/dollar, FLOPS/Watt, and FLOPS/unit space and have already been applied to a wide range of numerically intense problems. In Phase I of this project, we demonstrated their potential to enhance complex C ...

Long-wavelength infrared (LWIR) imaging has significant importance in military surveillance and target recognition, since human body radiation peaks in LWIR. Despite the enhanced wavelength coverage, the GaSb/InAs type-II Strained Layer Superlattice (SLS) detector still exhibits relatively high surface leakage current and its associated noises. With an industrially proven nano-material, we propose ...

In phase I, we have proven the feasibility of using the microwave cavity perturbation technique to detect and quantify DoS in marine aluminum alloys. We implemented an alpha version sensor prototype, characterized and validated its performance using ASTM G67 method. We also identified methods to further enhance the sensor sensitivity, so that DoS in the low (a few mg/cm2) to moderate range can be ...

This SBIR Phase II proposal develops an innovative PTIR adhesive and process for bonding stud fasteners to composite surfaces in aircraft manufacturing and repair. The PTIR adhesive formulation has a low concentration of infrared emitter/absorber dispersed in a thermoset epoxy adhesive paste. The PTIR adhesive paste is applied to the base of a stud fastener and the stud is irradiated using a P-Wav ...

Ultrastable, narrow linewidth, high reliability MOPA sources are needed for high performance LIDARs in NASA for, wind speed measurement, surface topography and earth and planetary atmosphere composition measurements. Princeton Optronics is developing a MOPA laser source for these applications. Phase I experiments concluded that the optimum approach will use a DPSS microchip laser with the SOA. Th ...