You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. A CubeSat-Compatible Neutral Wind Sensor

    SBC: CREARE LLC            Topic: AF121066

    ABSTRACT: CubeSats provide a new, low-cost platform for space weather missions. They enable new mission paradigms, such as the ability to perform multiple measurements of the same physical phenomena globally from several satellites, in contrast to high-accuracy measurements of multiple phenomena on the same spacecraft. Flight-tested neutral wind sensors must be miniaturized to fit into these mu ...

    SBIR Phase II 2014 Department of DefenseAir Force
  2. Acoustically Synchronized Store Ejection/Release Technology (ASSERT)

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: AF093007

    The Acoustically Synchronized Store Ejection/Release Technology (ASSERT) test process was developed by CRAFT Tech. This research has produced a capability to conduct small scale dynamic drop tests instrumented with stereo-photogrammetry to track store motion and synchronize this with unsteady weapons bay flowfield measurements. An advanced pneumatic ejection system has been developed which support ...

    SBIR Phase II 2014 Department of DefenseNavy
  3. Highly Compact Supersonic Cruise Missile (SSCM) Engine Inlet

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: N121028

    As air vehicle speeds increase, air breathing engine and inlet technology follow through concurrent supersonic performance requirements. The recent ability to build smaller supersonic engines has established a void in small air vehicle inlet capability. A solution to decrease the overall footprint of supersonic inlets within the Next Generation TOMAHAWK (NGT)/Supersonic Cruise Missiles (SSCM) is d ...

    SBIR Phase II 2014 Department of DefenseNavy
  4. Nondestructive Concrete Characterization System

    SBC: NLA DIAGNOSTICS LLC            Topic: A12aT013

    During covert operations, the U.S. Army may be required to breach a concrete structure using a controlled explosion. When choosing the most effective charge size and placement, it is vital to perform a rapid field assessment of the material and structural properties of the target structure. However, high strength concrete materials (such as Ultra-High Performance Concrete), including steel fiber r ...

    STTR Phase II 2014 Department of DefenseArmy
  5. Hybrid Veil Material for ESD/EMI Applications

    SBC: NanoTechLabs Inc.            Topic: AF083C071

    The objective of this proposal is to develop a hybrid conductive veil technology for use in UCASS or FA/xx and also as a replacement or repair of the existing conductive metallic ground planes on legacy platforms. The hybrid veil system can be made into a prepreg and bonded directly to the composite airframe. As a composite system, it is tougher and stronger than the current ground plane system, l ...

    SBIR Phase II 2014 Department of DefenseNavy
  6. Safe, High-Power Battery for Sonobuoys

    SBC: MaxPower, Inc.            Topic: N092110

    The Navy has established a need to update the battery capability of the present Active Source sonobuoy used in Anti Submarine Warfare(ASW) systems. The technology which is currently deployed achieves up to 14, 10 second pulses providing 2400 watts of power at 75 volts. The present battery, a primary lithium/SO2 system, suffers from safety concerns and limited power capability relating to excessive ...

    SBIR Phase II 2014 Department of DefenseNavy
  7. A Low Cost Electromagnetic Induction Ground Fault Detector

    SBC: CREARE LLC            Topic: N112133

    Machinery Control System (MCS) cabling faults can be difficult to identify and locate since as many as 3,000 to 5,000 I/O points are used and multiple junctions exist in each cable. A single MCS fault can require as many as four maintainers and a full day of troubleshooting to isolate and resolve, and MCS capability can be substantially reduced during this process. Creare is developing a low-cost ...

    SBIR Phase II 2014 Department of DefenseNavy
  8. Real Time 3-D Modeling and Immersive Visualization for Enhanced Soldier Situation Awareness

    SBC: Carnegie Robotics LLC            Topic: A12aT003

    We propose a rapid mapping and 3-D visualization system especially suited for inside buildings, tunnels, urban canyons, and other environments where GPS may be poor or not available. The system--which was fully demonstrated in our Phase I effort-- includes mobile Sensor Nodes that wirelessly supply compressed 3D range data and color imagery to a central Fusion Node. The Fusion Node runs 3D recon ...

    STTR Phase II 2014 Department of DefenseArmy
  9. Autonomous UAV Aerodynamic Performance Analysis for the Near-Ship Environment

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: N07T004

    The overall goal of this STTR program is to develop an efficient, high-fidelity, CFD-based design tool for the simulation of ship-board flight testing of autonomous UAV systems. In the first phase of this program, an overall flight simulation framework that employs a modular approach to the flight simulation problem was developed. Phase II of the program demonstrated a fully coupled aircraft/ship ...

    STTR Phase II 2014 Department of DefenseNavy
  10. Enabling Flexible Materials, Devices and Processes for Defense

    SBC: American Semiconductor, Inc.            Topic: AF121003

    ABSTRACT:Emergence and feasibility for flexible body-worn electronics and particularly medical patches requires high performance electronics capability.The problem is that these new technologies must have flexible and conformal physical formats and conventional electronic components are not in any way flexible. In the CLAS Phase I program, a new flexible high-performance manufacturing and material ...

    SBIR Phase II 2014 Department of DefenseAir Force
US Flag An Official Website of the United States Government