List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. Traffic Intersection Simulation of IntelliDrive, J2735, and DSRC/WAVE with eTEXAS

    SBC: Harmonia Holdings Group, LLC            Topic: 101FH3

    We accelerate the maturity of IntelliDrive applications and unlock the storehouse of modeling detail in TEXAS to organizations building IntelliDrive applications J2735/Dedicated Short Range Communication (DSRC) signal controllers and on-board IntelliDrive systems. We add four SAE J2735 messages: SPAT MapData Basic Safety Messages and Signal Request Message for emergency vehicle preemption. Mapping ...

    SBIR Phase II 2011 Department of Transportation
  2. Stress and Geometry Imaging from Outside the Pipeline

    SBC: Jentek Sensors, Inc.            Topic: 111PH1

    There is a well defined, yet unfulfilled need for a convenient (non-contact, light weight) and rapid imaging tool for multi-directional, thru-wall stresses (both applied and residual) from the outside of a pipeline. Quantitative stress imaging is needed at mechanical damage and corrosion sites, as well as at other critical locations (dents, bends, etc.). JENTEK is uniquely positioned to deliver ...

    SBIR Phase I 2011 Department of Transportation
  3. Response-Based Parameter Estimation for Determining Unknown Bridge Foundations

    SBC: Infrasense, Inc.            Topic: N/A

    Evaluation of bridges for vulnerability to scour or other potential sources of damage requires knowledge of foundation conditions beneath piers and abutments that are often unknown. INFRASENSE proposed to develop and demonstrate a response-based parameter estimation method (RPEM) which will address the need for a simple, low-cost system for unknown foundation evaluation. The RPEM system is based ...

    SBIR Phase II 1998 Department of Transportation
  4. Portable Active Thermographic Coating Inspection System

    SBC: Fuchs Consulting Inc            Topic: 091FH2

    This proposal seeks to produce a unique thermographic coating inspection system that is customized for the inspection of bridge coatings.  The system uses active thermography where IR sources are used to provide controlled heating to a coating system.  The presence of a defect in a coating system will result in differences in heat flow, which can be imaged with an infrared camera.  ...

    SBIR Phase II 2011 Department of Transportation
  5. N/A

    SBC: Luna Innovations Incorporated            Topic: N/A

    N/A

    SBIR Phase I 1998 Department of Transportation
  6. Intellifusion- A System for Augmenting Inductive Loop Vehicle Sensor Data with SPAT and GrID (MAP) via Data Fusion

    SBC: Harmonia Holdings Group, LLC            Topic: 111FH2

    Our goal is to create a demonstrable prototype system at the end of Phase I which fuses IntelliDrive (SM) data with data from traditional inductive loop detectors and uses this data in a modified NEMA TS2 traffic signal controller within eTEXAS Model for Intersection Traffic to reduce traffic delay at intersections.  Our work will improve the safety of intersections and improve the mobility of traffic through adaptive traffic control which uses data produced by IntelliFusion, the product of our research.   The process of data fusion involves merging data obtained fr

    SBIR Phase I 2011 Department of Transportation
  7. Development of Native Kelp Culture System Technologies to Support Sea Vegetable Aquaculture in New England Coastal Waters

    SBC: Ocean Approved, LLC            Topic: 817

    This Phase II research expands Phase I research on Saccharina latissima and is to design and develop “seed” nursery methodologies for the development of commercial-scale production of juvenile kelp plants including Alaria esculenta and Laminaria digitata. The project objectives include: 1. Isolate and maintain cultures of New England species of Alaria esculenta and laminaria digitata to be use ...

    SBIR Phase II 2011 Department of CommerceNational Oceanic and Atmospheric Administration
  8. Automated User-Friendly Advanced Handbrake for Use on Railroad Freight Cars

    SBC: UTD, INC.            Topic: N/A

    N/A

    SBIR Phase I 1998 Department of Transportation
  9. Automated Production of Composite Energy Absorbing Utility Poles

    SBC: KaZaK Composites Incorporated            Topic: N/A

    KaZaK Composites, Kaman Sciences and Dr. Malcolm Ray of the University of Iowa propose to investigate the design of energy absorbing utility poles made from composite materials. This team has considerable experience in the multiple technologies needed to successfully complete the proposed program, including design of high performance composite products for automated production and design, analysi ...

    SBIR Phase II 1998 Department of Transportation
  10. A Single Aperature Dual-Wavelength Dual Polarized Antenna for AWRAP

    SBC: REMOTE SENSING SOLUTIONS, INC.            Topic: 834D

    Severe weather impacts our daily lives, society and nation’s economy. From an average of $10B (2005 dollars) annual loss due to tropical cyclones since 1900 to $200B in the commercial shipping industry that is threatened by severe ocean storms to the hundreds of lives and assets being lost in the $20B recreational boating industry. In these cases and many more, accurate now-casting and forecasti ...

    SBIR Phase I 2011 Department of CommerceNational Oceanic and Atmospheric Administration

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government