You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Signal Processing at Radio Frequency (RF) for Position Navigation & Timing Co-Site Interference

    SBC: Metamagnetics Inc.            Topic: A17039

    Numerous operations in an increasingly congested electromagnetic spectrum, intensify demand for data at the tactical edge, and the diminishing extent of electromagnetic spectrum provisioned for the military has resulted in the need for advanced technologies to mitigate Global Positioning System (GPS) interference due to co-site interference and C4ISR. Metamagnetics proposes a powerful and adaptabl ...

    SBIR Phase II 2019 Department of DefenseArmy
  2. CMOS Compatible Deposition of Multi-Ferroic Films for Tunable Microwave Applications

    SBC: Winchester Technologies, LLC            Topic: A17019

    Built upon the progress in Phase I period, Winchester Technologies, LLC proposes to investigate practical magnetoelectric antennas during the Phase II period for different applications. State of the art antennas suffer from three major open challenges: (1) large antenna size, (2) antenna impedance mismatch; (3) ground plane effect. This is because state of the art antennas are based on oscillating ...

    SBIR Phase II 2019 Department of DefenseArmy
  3. Linear Efficient Broadband Transmitter Architecture at mm-wave frequencies

    SBC: Digital Analog Integration, Inc.            Topic: A17027

    There is an ever-increasing demand on low-cost high-throughput wireless front-ends. Such high-throughput front-ends support broadband data transmission (multi-Gbit/s) for a wide variety of sensors and unmanned platforms in situational awareness, monitoring, and reconnaissance. Their wideband nature also supports the deployment of broadband communication/radar combo-systems, as well as numerous eme ...

    SBIR Phase II 2019 Department of DefenseArmy
  4. FTL's FASCI, Forward Area Suspended Contaminant Identifier, Field Instrumentation to measure, quantify, and characterize fuel contaminants

    SBC: FTL Labs Corporation            Topic: A17116

    To avoid machine failure, diesel engine hardware manufacturers recommend limiting fuel contamination particles based on number and size distribution. Work performed by TARDEC has developed limits for particulate and free water contamination in fuel utilizing light obscuration particle counting; however, this approach is unable to differentiate between solid particulates, free water droplets, and a ...

    SBIR Phase II 2019 Department of DefenseArmy
  5. Compact Sanitation Center (CSC) for Expeditionary Field Feeding

    SBC: Yankee Scientific, Inc.            Topic: A17070

    Yankee Scientific proposes to develop a rugged and lightweight Compact Sanitation Center (CSC) System for the washing, rinsing and sanitation of kitchen wares in highly expeditionary military field feeding applications.Our approach is to develop a lightweight Steam Generator that can deliver low-pressure steam to Condensing Heat Exchangers (CHX) in the Wash, Rinse and Sanitation sinks.By using thi ...

    SBIR Phase II 2019 Department of DefenseArmy
  6. Development of a Military Hardened Expeditionary, Energy Efficient and Waterless/Low-Flow Laundry System

    SBC: TECHNICAL PRODUCTS, INC.            Topic: A17072

    In this effort Technical Products Inc. (TPI) will develop a High Efficiency Laundry System (HEELS) with reduced water, power, and waste support requirements and minimal transportation and logistics footprint whilst still enhancing the soldiers quality of life.TPIs HEELS system concept:can use almost any local water as an input (that is, it does need potable or even clean non-potable water as a res ...

    SBIR Phase II 2019 Department of DefenseArmy
  7. Utilizing Ground-Based Simulation to Validate High Altitude Plume Signature Codes in Support of Theater Missile Threat Detection and Tracking

    SBC: Physical Sciences Inc.            Topic: A17124

    The proposed SBIR program will employ Physical Sciences Inc.s (PSI) unique ground-based high altitude plume signature simulation facility to examine the interactions of hyperthermal oxygen atoms with specific plume constituents believed to contribute to plume emission in the ultraviolet and visible spectral regions. These reactions will include the multi-step O + CH4 reaction predicted to produce ...

    SBIR Phase II 2019 Department of DefenseArmy
  8. Anthropometry and Pose Observation using Low-dimensional Latent Optimization (APOLLO)

    SBC: Charles River Analytics, Inc.            Topic: A17064

    The US Army has identified a need for a modular perception system that detects and estimates the shape and pose of casualties in the battlefield. Such a system would enable existing and future unmanned systems to safely perform autonomous casualty extraction and evacuation tasks. Although multiple commercial solutions to pose estimation exist, they often require the use of active sensing technolog ...

    SBIR Phase II 2019 Department of DefenseArmy
  9. Development of Broadband Nanostructured Antireflection Coatings for Improved Infrared Focal Plane Arrays (IRFPA) Performance

    SBC: Magnolia Optical Technologies, Inc.            Topic: A15028

    Theproposed Sequential Phase II SBIR program will focus on the design, development and demonstration of high quality nanostructured antireflection coatings for infrared, ultraviolet detectors and optics. The nanostructured coatings will be deposited on silicon(Si), Germanium (Ge), SiC. and other substrates such as CdZnTe. These high quality antireflection coatings wil be characterized in detail, i ...

    SBIR Phase II 2019 Department of DefenseArmy
  10. Sequential PII- High Speed Characterization of Arena Test Fragments Embedded in Capture Media via 3-D X-ray

    SBC: ZKxKZ, LLC            Topic: A14010

    Quantification of fragments captured in 48-sheet bundles of -inch thick, 4x8 fiberboard during arena testing is expensive and labor-intensive. Technicians now spend thousands of hours finding and recovering fragments, measuring position in three dimensions, then cleaning and weighing each one. Inspecting a single bundle can take 30 hours, at $100/hour. Post-test data collection can exceed $500,000 ...

    SBIR Phase II 2019 Department of DefenseArmy
US Flag An Official Website of the United States Government