List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. RAMAN COVERTED MID-IR LASER

    SBC: ABIOMED, INC.            Topic: N/A

    N/A

    SBIR Phase I 1985 Department of DefenseArmy
  2. ACCURATE PASSIVE RANGING TECHNIQUES

    SBC: ADCOM SYSTEMS TECHNOLOGY,INC.            Topic: N/A

    N/A

    SBIR Phase I 1989 Department of DefenseNavy
  3. IMPROVEMENT OF TEST INSTRUMENTATION FOR FILAMENT WOUND STRUCTURES

    SBC: Advanced Composites Labs            Topic: N/A

    SEVERAL TECHNIQUES WHICH HAVE BEEN USED BY ACL TO MEASURE RESPONSE OF BOTH FILAMENT-WOUND AND BRAIDED GLASS, KEVLAR AND GRAPHITE EPOXY COMPOSITE TUBES WILL BE EMPLOYED IN THE INSTRUMENTATION OF A VARIETY OF FILAMENT-WOUND COMPOSITE STRUCTURES. THESE STRUCTURES WILL BE CHOSEN BY ACL AFTER TECHNICAL DISCUSSIONS WITH MICOM PERSONNEL, AND MAY INCLUDE GOVERNMENT FURNISHED STRUCTURES OF PARTICULAR INTER ...

    SBIR Phase I 1989 Department of DefenseArmy
  4. BEHAVIOR OF METAL MATRIX COMPOSITES AT CRYOGENIC TEMPERATURES

    SBC: Advanced Materials Laboratory            Topic: N/A

    METAL MATRIX COMPOSITES THAT MAY BE USED IN DEEP SPACE VEHICLES MIGHT HAVE SEVERE INTERNAL STRESSES DUE TO THE THERMAL EXPANSION DIFFERENCES BETWEEN THE MATRIX AND THE FIBERS. SINCE THE TEMPERATURES EXPERIENCED WITH THESE VEHICLES MAY BE AS LOW AS A FEW DEGREES ABOVE ABSOLUTE ZERO, IT IS NECESSARY TO KNOW THE THERMAL MECHANICAL BEHAVIOR OF METAL MATRIX COMPOSITES TO BE USED AS STRUCTURAL MATERIALS ...

    SBIR Phase II 1987 Department of DefenseNavy
  5. FLUIDIZED BED FOR PREVENTION OF FREEZING IN CRYOGENIC HEAT EXCHANGERS

    SBC: Advanced Mechanical Technology, Inc.            Topic: N/A

    A SERIOUS PROBLEM IN HEAT EXCHANGERS WHERE ATMOSPHERIC AIR IS COOLED TO CRYOGENIC TEMPERATURES IS THAT THE AMBIENT WATER VAPOR AND CO(2) FREEZE ONTO THE HEAT TRANSFER SURFACES. AS THE SOLID DEPOSITS ACCUMULATE THEY ADVERSELY AFFECT PERFORMANCE BY DECREASING HEAT EXCHANGER EFFECTIVENESS AND INCREASING PRESSURE DROP. AN INNOVATIVE APPROACH FOR DEALING WITH THE FREEZING PROBLEM WHICH OFFERS SIGNIFICA ...

    SBIR Phase I 1987 Department of DefenseAir Force
  6. HIGH TEMPERATURE TRIBOMETER

    SBC: Advanced Mechanical Technology, Inc.            Topic: N/A

    A MACHINE TO EVALUATE THE FRICTION AND WEAR PROPERTIES OF MATERIALS AT TEMPERATURES UP TO 1000 DEG C IS PROPOSED. BOTH LUBRICATED AND UNLUBRICATED TESTING WITH LIQUIDS AND SOLIDS WILL BE POSSIBLE USING A PIN-ON-DISC GEOMETRY. COMPLETE CONTROL OVER THE TEST ATMOSPHERE AND MANUAL OR COMPUTER-CONTROL OF ALL VARIABLES WILL BE POSSIBLE DATA ACQUISITION AND STORAGE WILL BE PERFORMED BY COMPUTER. THE TRI ...

    SBIR Phase II 1989 Department of DefenseAir Force
  7. QUANTITATIVE LUBRICATING OIL DEBRIS MONITORING AND ANALYSIS

    SBC: Advanced Mechanical Technology, Inc.            Topic: N/A

    THE OBJECTIVE OF THE PROPOSED PROJECT IS TO EVALUATE THE FEASIBILITY OF AN ON-LINE MONITOR OF OIL CONDITION WHICH WOULD DETECT THE PRESENCE AND NATURE OF DEBRIS PARTICLES IN LUBRICATING OIL SYSTEMS. THIS WOULD PROVIDE A MORE TIMELY AND LESS LABOR INTENSIVE METHOD OF OIL CONDITION MONITORING THAN PRESENT METHODS THAT INVOLVE OFF-LINE ANALYSIS. THE PROPOSED APPROACH WOULD CONSIST OF MEASURING THE FO ...

    SBIR Phase I 1989 Department of DefenseNavy
  8. COMMUNICATIONS

    SBC: Aes Corp            Topic: N/A

    THE AES CORPORATION HAS DEVELOPED A NOISE PROCESSOR (NP). THE PROCESSOR HAD THE ABILITY TO DETECT A SIGNAL OF KNOWN PULSE WIDTH BURIED DEEP WITHIN THE R.F. NOISE FLOOR OR ELECTRONIC JAMMING. THE COMBINATION OF PROPRIETARY HARDWARE AND SOFTWARE ALLOWS THE NP TO SEARCH FOR A VERY EXACT SIGNAL. THE SIGNAL PARAMETERS ARE PROGRAMMED INTO THE SOFTWARE. THE TWO CONCURRENT PROCESSORS ARRIVE AT THE PROBABI ...

    SBIR Phase I 1985 Department of DefenseAir Force
  9. ADVANCED PERMEABLE MEMBRANE OBIGGS/OBOGS SYSTEM

    SBC: A/g Technology Corp.            Topic: N/A

    THE OVERALL OBJECTIVE OF THE PHASE I PROGRAM IS TO DEMONSTRATE THE FEASIBILITY OF NEWLY DEVELOPED ADVANCED PERMEABLE MEMBRANES FOR THE COMBINED DUTIES ON MILITARY AIRCRAFT OF NITROGEN GENERATION TO INERT FUEL TANKS AND OXYGEN GENERATION FOR PILOT BREATHING IN A UNIQUE SYSTEM ARRANGEMENT. THESE COMPACT AND LIGHTWEIGHT MEMBRANES LEND THEMSELVES TO A MORE EFFICIENT OBIGGS/OBOGS DESIGN COMBINATION THA ...

    SBIR Phase II 1987 Department of DefenseAir Force
  10. DESIGN SPECIFICATION FOR A MICROWAVE MOISTURE SOUNDER

    SBC: ATMOSPHERIC & ENVIRONMENTAL RESEARCH, INC.            Topic: N/A

    A RESEARCH PROGRAM TO PROVIDE SIMULATION MODELS APPLICABLE TO THE DESIGN SPECIFICATION OF A MICROWAVE MOISTURE SOUNDER OPERATING AT 183 GHZ IS DESCRIBED. THE DESIGN SPECIFICATION PROCESS CONSISTS OF INSTRUMENT RESPONSE SIMULATION, SENSITIVITY ANALYSES, AND MOISTURE RETRIEVAL PERFORMANCE ASSESSMENT. THE OBJECTIVE OF THE INITIAL EFFORT IS TO DEVELOP COMPUTER ALGORITHMS CAPABLE OF TREATING THE RESPON ...

    SBIR Phase II 1985 Department of DefenseAir Force

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government