Award Data

PROJECT SUMMARY / ABSTRACTThe objective of this Phase II proposal is to further develop a novel device for ocular anesthesia based on thermo-electric cooling. Intravitreal injection therapy (IVT) is one of the most commonly performed procedures in all of medicine, with approximately 7 million injections in the USA in 2016. Ocular anesthesia is required, both for patient safety and for tolerability ...

Project Summary/Abstract Prospective evaluation of a surgical solution for breast cancer-associated lymphedema The proposed project will complete remaining key research and technology requirements that are needed to commercialize a ground-breaking interventional device for treating secondary lymphedema -- a chronic and debilitating disease that currently has no cure and impacts an estimated 15-30% ...

Aircraft structure nondestructive testing (NDT) is performed in a field or depot setting depending primarily on the amount of disassembly required to gain access to the inspection area. In order to reach set field and depot inspection intervals, the minimum detectable flaw size (Andi) must be sufficiently small. Legacy NDT methods with Andi's that are too large require out of cycle inspections whi ...

Systems & Technology Research (STR) proposes the development and maturation of a state-of-the-art multi-target tracking software for processing operational data. The proposed software consists of the Multi-Stage Multiple Hypothesis Tracker (MS-MHT) for efficient and accurate target tracking and the Parameter Optimization Tool (PAROPT) for optimization of tracking parameters. The goal for the Phase ...

Many of the US Department of Defense (DOD) electrical connectors, back-shells and components currently contain cadmium (Cd).Cadmium is a known carcinogen.Furthermore, the cadmium is typically conversion coated with a hex-chromate which is also hazardous.Both the cadmium plating process and its subsequent conversion coating have been proven to be toxic (unlike other processes such as chromium plati ...

3D printing has recently taking a lead role as a potential solution for future manufacturing. However, there are still many problems and limitations to the technology for cost effective high resolution, high throughput manufacturing.Derived from the SBIR Phase I effort, Digibeam is presenting an innovative solution using a different beam and growth process that directly addresses both resolution a ...

Air Force landing gear systems are subjected to surface treatment processes (e.g., chrome plating, cadmium plating, anodizing) an indefinite number of times throughout their service life. During these processes, components are exposed to environments and chemicals which affect material surface conditions (e.g., roughness, residual stresses, microstructure) and reduce fatigue life. This reduction i ...

To address the Air Force need for advanced radar characterization of fighter aircraft, Physical Optics Corporation (POC) is developing a new Near Field Scanner (NeFS) based on novel RF/microwave sensing and scanning technologies. Specifically, innovations in sensor miniaturization and broadband functionality, combined with an innovative 3D scanning platform, enable NeFS to measure near-field radia ...

To address the Air Force need for an automated target recognition (ATR) capability that uses Light Detection and Ranging (LIDAR), Physical Optics Corporation (POC) proposes to advance the development of the Highly Parallel LIDAR-based Automated Target Recognition (PLATR) system, which was proven feasible in Phase I. PLATR is based on an innovative combination of target isolation, target pose estim ...

Cancer survivors commonly report cognitive impairments following chemotherapy. With a growing number of cancer survivors comes an increased urgency to better understand the precise etiology and prevalence of cognitive changes associated with cancer and cancer treatment. This pursuit is impeded by a lack of assessment tools that can accurately detect the full scope of cognitive deficits. To address ...