List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until April, 2020.

  1. High Bandwidth Towed Array Modem

    SBC: QorTek, Inc.            Topic: N181045

    QorTek plans to utilize commercial RF communication chipsets paired with state of the art GaN-based RF amplifiers as to deliver a novel solution that is form fact compatible with legacy equipment yet will allow the Navy to realize target >500MBPS data transmission rates without any need to replace existing towed sonar cabling. The solution has distinct advantages of having a well-supported supply ...

    SBIR Phase II 2019 Department of DefenseNavy
  2. Rapid Prototype Portable Combat and Launch System

    SBC: SYSTEMS ENGINEERING ASSOCIATES CORPORATION            Topic: N95053

    SEA CORP will leverage the innovative technologies developed under the prior SBIR Phase II project and extend the Research & Development (R&D) activities to the development of critical submarine combat system payload integration efforts. In the previous effort, components were successfully developed facilitating integration of Improved Submarine Launched Mobile Mine (ISLMM) capability aboard subma ...

    SBIR Phase II 2019 Department of DefenseNavy
  3. Non-collinear Wave-front Curvature Range Measurement

    SBC: MIKEL, INC.            Topic: N02025

    The goal of this Phase II SBIR is to extract more information from existing submarine acoustic sensors through a highly innovative inter- and intra-sensor correlation algorithmic, in order to provide U.S. submarines with increased acoustic superiority over increasingly quiet adversaries. U.S. adversaries are continuously improving their acoustic quieting technologies through efforts such as marine ...

    SBIR Phase II 2019 Department of DefenseNavy
  4. Ignition Modeling for Present and Future Combustors and Augmentors

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: N17AT003

    The primary objective of this effort is to develop a tractable computational tool to assess the probability of ignition within aircraft combustors and augmentors during routine igniter and/or system design analysis. This computational tool will provide for the off-line assessment of ignition probability given flowfield simulation data, characteristic igniter geometric and physical parameters, and ...

    STTR Phase II 2018 Department of DefenseNavy
  5. Low Noise Torpedo Power Supply

    SBC: QorTek, Inc.            Topic: N131032

    QorTek and Lockheed Martin are together proposing a new advanced integrated topology converter architecture that would significantly improve both low frequency rejection, the high frequency switching noise content and still fit within the confines of the design envelope. As the prime contractor for the MK48 CBASS torpedoMS2 is uniquely positioned to work with QorTek in both assuring that the devel ...

    SBIR Phase II 2018 Department of DefenseNavy
  6. Time-Resolved, Reynolds-Average Navier Stokes (RANS) / Large Eddy Simulation (LES) Flow-Modeling Tools Suitable for Gas Turbine Engine Sand and Dust M

    SBC: COMBUSTION RESEARCH AND FLOW TECHNOLOGY INC            Topic: N171034

    A Reactive Solids Tool concept will be developed which can be interfaced with a modern high-fidelity Computational Fluid Dynamics code to predict sand and ash behavior in high temperature combustor environments, and the potential for deposition of solid and molten particulate on gas turbine internal surfaces. This effort will utilize state-of-the-art knowledge of the material, chemical, morphologi ...

    SBIR Phase II 2018 Department of DefenseNavy
  7. Advanced Human-Machine Interface (HMI) for Dynamic Sensor Control

    SBC: Lambda Science, Inc.            Topic: N171014

    xxx

    SBIR Phase II 2018 Department of DefenseNavy
  8. Advanced Arresting Gear Water Twister Diagnostics and Health Monitoring

    SBC: Fbs, Inc.            Topic: N171011

    The arresting system is a critical component to ensure mission readiness and pilot safety during landing operations on an aircraft carrier. The Advanced Arresting Gear (AAG) Water Twister is the most critical mechanical component for absorbing kinetic energy from landing aircraft and as such it is necessary to ensure its reliability and health status. Issues have previously been identified with th ...

    SBIR Phase II 2018 Department of DefenseNavy
  9. Nickel Aluminum Bronze for Additive Manufacturing Alloy Development

    SBC: QUESTEK INNOVATIONS LLC            Topic: N171088

    QuesTek Innovations LLC, a leader in the field of Integrated Computational Materials Engineering (ICME), proposes to design and optimize a new Nickel Aluminum Bronze (NAB) alloy for use as feedstock material in directed energy deposition (DED)-based additive manufacturing (AM) in order to enable the development of AM technologies for quicker, cheaper, and more reliable production and repair of NAB ...

    SBIR Phase II 2018 Department of DefenseNavy
  10. Interferometric ISAR Imaging of Maritime Targets for Improved Classification

    SBC: Lambda Science, Inc.            Topic: N171094

    xxx

    SBIR Phase II 2018 Department of DefenseNavy

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government