You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. N/A

    SBC: ADVANCED FUEL RESEARCH, INC.            Topic: N/A

    This subtopic solicited Phase I R&D for an advanced Fourier transform infrared (FT-IR) system that would provide fast-scanning high resolution (3 scans/sec at 1cm-1 resolution), low noise, mid-infrared measurements for characterization of spray flames. In Phase I, Advanced Fuel Research, Inc. (AFR) demonstrated FT-IR emission/transmission (E/T) measurements from the NIST spray combustion faci ...

    SBIR Phase I 2001 Department of Commerce
  2. N/A

    SBC: ADVANCED FUEL RESEARCH, INC.            Topic: N/A

    This subtopic solicited Phase I R&D for an advanced Fourier transform infrared (FT-IR) system that would provide fast-scanning high resolution (3 scans/sec at 1cm-1 resolution), low noise, mid-infrared measurements for characterization of spray flames. In Phase I, Advanced Fuel Research, Inc. (AFR) demonstrated FT-IR emission/transmission (E/T) measurements from the NIST spray combustion faci ...

    SBIR Phase II 2001 Department of Commerce
  3. Integrated Power Electronics Cooling System Using EHD- Enhanced Microchannel Technology

    SBC: ATEC, Inc.            Topic: N/A

    ATEC and TA&T, in collaboration with the University of Maryland, will develop a light-weight, low-cost ceramic-based, high heat flux microchannel heat sink device suitable for power electronics cooling applications. The combination of our uniquefabrication process and the incorporation of an active heat transfer enhancement technology(electrohydrodynamics, EHD) will provide an enabling technology ...

    SBIR Phase II 2001 Department of DefenseMissile Defense Agency
  4. Bilayer 157nm Bottom Anti-Reflective Coatings

    SBC: Brewer Science Incorporated            Topic: N/A

    This SBIR Phase I will develop novel chemistry platforms for 157nm bottom anti-reflective coatings (BARC's). Recent improvements in BARC's, photoresist's, and optical processes at deep ultra-violet have enabled resolution targets approaching 0.12 microns.The semiconductor industry technology roadmap calls for the introduction of 193nm processes to 0.07 microns, and BARC's are essential in achievi ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
  5. Novel Materials for IR Microbolometer Arrays

    SBC: Brewer Science Incorporated            Topic: N/A

    Ion implanted, thin polymer films exhibit a large temperature coefficient ofresistance which suggest their application in microbolometer arrays used for infrared(IR) imaging and temperature mapping. Compared to current microbolometer designswhich require a series of difficult deposition steps, an ion implanted polymer-baseddevice requires only a single layer which can be applied by spin coating a ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
  6. Advanced Regenerators for Cryocoolers Operating at 10-100 Kelvin

    SBC: Chesapeake Cryogenics, Inc.            Topic: N/A

    The performance of high speed cryocoolers is highly dependent on an effective regenerator which has high heat capacity, large surface area, and low pressure drop. These factors can increase refrigeration capacity, lower operating temperatures and improveefficency. Parallel plate regenerators have been shown to be the most effective geometry possessing most of these characteristics. However, implem ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
  7. Inspection of Composite Adhesive Bonds with an Electrochemical Sensor

    SBC: DACCO SCI, INC.            Topic: N/A

    DACCO SCI, INC., (DSI), together with the Composite Materials and Structures Center of Michigan State University, proposes a Phase I SBIR program to use an electrochemical impedance spectroscopy (EIS)-based corrosion sensor to monitor the integrity of anadhesive bondline between two composites or one composite and a metal. Using this sensor approach to detect moisture intrusion into a bondline wi ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
  8. N/A

    SBC: DYNAFLOW, INC.            Topic: N/A

    N/A

    SBIR Phase I 2001 Department of Commerce
  9. Holographic 3D ISAR Imaging for Improved Discrimination of Ballistic Targets

    SBC: Epic Sales, Inc. Dba Epic Systems            Topic: N/A

    The goal of this project is to define and pursue novel ISAR-based coherent processing techniques to advance discrimination techniques and improve the performance of NMD radars against the emerging C2 and C3 threats. Essex plans to augment traditional ISARprocessing capabilities by extending the resolution and bandwidth via coherent combination of ISAR multi-band, multi-platform, and multi-static ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
  10. Novel Broadband Materials and Components

    SBC: Epitaxial Technologies, LLC            Topic: N/A

    Epitaxial Technologies proposes to develop novel material technologies for the realization of broadband components such as oscillators, mixers and preamplifiers. We will achieve this by performing device designs to determine suitable material structures,epitaxial growth and device fabrication processes.The primary goal of this proposed Phase I effort is to demonstrate the feasibility of broadband ...

    SBIR Phase I 2001 Department of DefenseMissile Defense Agency
US Flag An Official Website of the United States Government