List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. Absolute Distance Interferometer for Manufacturing Metrology Applications

    SBC: Bridger Photonics, Inc.            Topic: NA

    Bridger Photonics, Inc. proposes to develop an absolute length metrology sensor that will simultaneously provide >1,000 measurements per second, 0.5 m maximum measurement distance. Bridger’s solution is will fill a gap in precision measurement technology for applications that require rapid monitoring of macroscopic distances such as positioning and calibration of surface metrology systems (CMM, ...

    SBIR Phase II 2017 Department of CommerceNational Institute of Standards and Technology
  2. Absolute Distance Interferometer for Manufacturing Metrology Applications

    SBC: Bridger Photonics, Inc.            Topic: 90101

    Bridger Photonics, Inc. will develop an absolute length metrology sensor that will simultaneously provide >1,000 measurements per second, 0.5 m maximum measurement distance. Bridger’s solution is will fill a gap in precision measurement technology for applications that require rapid monitoring of macroscopic distances such as positioning and calibration of surface metrology systems (CMM, AFM, SE ...

    SBIR Phase I 2016 Department of CommerceNational Institute of Standards and Technology
  3. Fabrication of Advanced Waveguide Structures for Efficient Violet and Near-UV Generation

    SBC: ADVR, Inc            Topic: N/A

    This SBIR Phase I effort will establish the feasibility of fabricating advanced waveguide structures in potassium titanyl phosphate (KTP) capable of efficiently generating 25 to 40 mW of frequency converted light in the 395 to 480 nm. The key innovation in this effort is to utilize KTP waveguides in a single-pass frequency doubling device to efficiently produce the desired laser wavelengths and po ...

    SBIR Phase I 2009 Department of CommerceNational Institute of Standards and Technology
  4. High Efficiency Up conversion Single-Photon-Detector for 1550 nm Signal

    SBC: ADVR, Inc            Topic: N/A

    This NIST Phase II SBIR effort will two low noise single photon detectors using MgO doped LiNbO3 (LN) periodically poled waveguides and a 980nm (or similar appropriate wavelength) pump to up convert 1550nm photons to 600nm to allow for detection by photomultiplier tube (PMT). The key innovation is using low noise periodically poled waveguides with a long wavelength (1800nm) pump leading to higher ...

    SBIR Phase II 2009 Department of CommerceNational Institute of Standards and Technology
  5. High Efficiency Single Photon Up-Conversion in Waveguides and Pump Wavelength Longer than the Signal Wavelength

    SBC: ADVR, Inc            Topic: N/A

    This NIST Phase 1 SBIR effort will demonstrate the feasibility of low noise single photon up conversion using KTiOPO4 (KTP) or LiNbO3 (LN) or Stoichiometric LiTaO3 (SLT) periodically poled waveguides and an 1800nm pump for a high efficiency single photon detector. The key innovation is using low noise periodically poled waveguides with a long wavelength (1800nm) pump leading to higher efficiency s ...

    SBIR Phase I 2008 Department of CommerceNational Institute of Standards and Technology

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government