You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Advanced Instrumentation for Non-Nulling Stack Velocity Testing

    SBC: AIRFLOW SCIENCES CORPORATION            Topic: 90

    Industrial facilities, manufacturing plants, and electric power plants that burn fossil fuels exhaust the combustion products to atmosphere through their smokestacks. Stack pollutant emissions are quantified using manual testing methods developed in the 1960s, which are prone to error if complex flow patterns exist, which is common. Recently, NIST has been working on an improved technique of perfo ...

    SBIR Phase II 2020 Department of CommerceNational Institute of Standards and Technology
  2. Dual Plane 3D Compton Scattering Imager with Pixelated CZT Detectors for 1-10MeV Gamma Ray

    SBC: H3D            Topic: None

    Phase I has proven that the current setup achieves better than 8mm spatial resolution for 2.2MeV prompt gammas. However, 1mm spatial resolution presents a significant challenge for the current setup due in part to limited timing resolution and count rate. A new analog ASIC will be developed to replace the current analog ASIC that will have better timing resolution and deliver higher count rates. I ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  3. IF Conversion System for High-Bandwidth Multiplexed Sensors Arrays

    SBC: Alphacore, Inc.            Topic: None

    Alphacore will develop an Intermediate Frequency (IF) Conversion System for High-Bandwidth Multiplexed Sensors Arrays for Phase II of NIST's 2018 soliciation for Exploratory Measurement Science Topic 9.04.02.68.The proposing team has already successfully developed and evaluated a prototype board in Phase I.The goal in Phase II is therefore to achieve three primary objectives:1) Optimize the design ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  4. HQ-55 VTOL UAS for Ship Based Operation

    SBC: Latitude Engineering, LLC            Topic: 832

    TECHNICAL ABSTRACT: The Hybrid Quadrotor concept, developed by Latitude Engineering, combines the high power density of electric motors and propellers with the high energy density of a piston engine and liquid fuel. Together, each technology enables maximum performance in HQ's two regimes of flight: the electric system is responsible for lift while hovering (high power, short endurance), and the g ...

    SBIR Phase II 2018 Department of CommerceNational Oceanic and Atmospheric Administration
  5. High Temperature High Resolution in-situ Differential Pressure Sensor

    SBC: Innoveering, LLC            Topic: NA

    Chemical manufacturers require high accuracy/high sensitivity pressure sensors to efficiently monitor the various manufacturing systems and processes in the chemical plant, to ensure any changes proceed in a safe and reliable manner, adhering to expected standards and practices. NIST also has a need for highly accurate pressure measurements, especially determining the thermo-physical properties of ...

    SBIR Phase II 2017 Department of CommerceNational Institute of Standards and Technology
  6. Dynamic Frequency Passive Millemeter-Wave Radiometer Based on Optical Up-Conversion

    SBC: Phase Sensitive Innovations, Inc.            Topic: 94

    Passive microwave sensors aboard satellites provide valuable information regarding weather conditions by measuring atmospheric attenuation over a broad range of frequencies from 0-200 GHz. Additional ground-based sensors are desirable to provide complementary upward looking measurements that can be used to refine existing attenuation models. Operating over such a large bandwidth, however, places ...

    SBIR Phase II 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  7. Anion Exchange Resin for Chirality-based Separation of Single-wall Carbon Nanotubes

    SBC: Sepax Technologies, Inc.            Topic: N/A

    Sepax Technologies, Inc. has identified a new type of anoin-exchange resin which separates single-wall carbon nanotubes (SWCNTs) with >80% recovery yield and resolves in a single pass the chiral tubes of (6,5) well from commercial SWCNT starting materials by Chromatography. Improvement and scale up of the targeted resin production will facilitate the separation of chiral nanotubes for the academic ...

    SBIR Phase II 2012 Department of CommerceNational Institute of Standards and Technology
  8. Technology Transfer of Multimodal Biometric Application Resource Kit (MBARK)

    SBC: Ad Harmony            Topic: N/A

    The technical objective of this project is to develop a prototype of a face recognition application in a cloud computing environment utilizing MBARK as the middleware. The application will have a client piece that will run on a mobile device such as a laptop and a server piece that will run on a higher-performance computing cluster. The specific objectives of this development project can be enumer ...

    SBIR Phase II 2011 Department of CommerceNational Institute of Standards and Technology
  9. Decision Support Tools for Sustainable Manufacturing

    SBC: BIMCON Inc.            Topic: 907012R

    Our vision is that of an integrated decision support solution that transforms the current time-consuming and reactive (post-design) sustainability assessment of a product into a proactive approach available in the early design phases. This solution called Sustainability Integrated into Early Design (SIED) will deliver lifecycle sustainability data into early design processes and focus primarily on ...

    SBIR Phase II 2011 Department of CommerceNational Institute of Standards and Technology
  10. Phase-Stabilized 1-GHz Fiber-Laser Frequency Combs at 2~5um for Coherent Fourier Transform Spectroscopy

    SBC: AdValue Photonics Inc            Topic: N/A

    The GHz-rate phase-stabilized fiber-laser frequency comb system is proposed to be used as a light source for coherent Fourier transform spectroscopy. The system will be developed based on our proprietary glass/fiber technology, which features a low-cost, robust, highly stable, mid-infrared light source that enables the development of a robust portable c-FTIR spectrometer for absorption measurement ...

    SBIR Phase II 2010 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government