Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Anion Exchange Resin for Chirality-based Separation of Single-wall Carbon Nanotubes

    SBC: Sepax Technologies, Inc.            Topic: N/A

    Sepax Technologies, Inc. has identified a new type of anoin-exchange resin which separates single-wall carbon nanotubes (SWCNTs) with >80% recovery yield and resolves in a single pass the chiral tubes of (6,5) well from commercial SWCNT starting materials by Chromatography. Improvement and scale up of the targeted resin production will facilitate the separation of chiral nanotubes for the academic ...

    SBIR Phase II 2012 Department of CommerceNational Institute of Standards and Technology
  2. Apps for Rapid Epidemiological Analysis (AREA)

    SBC: RENAISSANCE SCIENCES CORPORATION            Topic: OSD11H17

    The US Military seeks innovative means to analyze and forecast the health landscape of an area of interest. This knowledge is critical to support non-kinetic operations including Stabilization, Security, Transition, and Reconstruction Operations (SSTRO) and Humanitarian Aid/Disaster Relief Operations."Apps for Rapid Epidemiological Analysis"(AREA) system development enables commercially available ...

    SBIR Phase I 2012 Department of DefenseDefense Health Program
  3. Digital SQUID Array for Portable Low-Field MRI System for Combat Diagnostics

    SBC: HYPRES, INC.            Topic: OSD11H18

    Recent research has shown that Superconducting Quantum Interference Devices (SQUIDs) may be used to measure the very weak magnetic signal in Magnetic Resonance Imaging at ultra-low magnetic fields in the milli-tesla range or below. However, the signal-to-noise ratio (SNR) is quite low, requiring very long averaging times to obtain reasonable spatial resolution. The use of large arrays of SQUIDs wo ...

    SBIR Phase I 2012 Department of DefenseDefense Health Program
  4. Medical Modeling and Simulation Based Training Return on Investment Decision Model

    SBC: AEGIS TECHNOLOGIES GROUP, INC., THE            Topic: OSD11H19

    Many studies exist which validate M & S based medical training tools as effective in improving practitioner performance. There is little research addressing the cost effectiveness of such training solutions. A gap exists in the integration of cost, performance, schedule, risk, patient outcome improvement, and training efficiency and training transfer factors in assessing medical M & S based train ...

    SBIR Phase I 2012 Department of DefenseDefense Health Program
  5. Novel Pre-Fire Powering and Data Transfer Links for Munitions

    SBC: OMNITEK PARTNERS LLC            Topic: A12008

    The objective of this project is to investigate the feasibility of several novel wireless methods and related devices for pre-fire powering of munitions capacitors and/or super-capacitors and establishing one-way or two-way data transfer link to load firing information as well as health monitoring and the like. In the novel concepts being proposed the means of transferring power into the munitions ...

    SBIR Phase I 2012 Department of DefenseArmy
  6. Mitigation of Range/Doppler Straddle for Radar Coherent Processing

    SBC: Helios Remote Sensing Systems, Inc.            Topic: A12032

    The objective of this effort is to develop track-before-detect algorithms to provide greater signal processing gain for pulsed-Doppler radars. We will develop signal processing techniques to be used in next-generation ground-based radars to detect and track objects of interest. We will perform a feasibility analysis of the proposed technique on high-speed, low RCS targets. In addition, we will ...

    SBIR Phase I 2012 Department of DefenseArmy
  7. Electroless Plating of Indium Bumps for High Operating Temperatures (HOT) Mid-Wave (MW) Sensors

    SBC: EnerGaia            Topic: A12039

    Advanced hybrid packaging for MWIR FPA devices has considerable challenges in terms of increasing pixel density. These processes are based on Indium bumping; however, the current approach to deposition has scaling and cost issues. EnerGaia has a technology based on acoustic electroless deposition which can meet these requirements. Ultrasonic energy coupled to a plating solution has been proven ...

    SBIR Phase I 2012 Department of DefenseArmy
  8. Use of Electromagnetic Impedance Spectroscopy (EIS) and Tomography (EIT) for the Detection and Identification of Buried Explosive Hazards

    SBC: TransTech Systems, Incorporated            Topic: A12040

    The detection of buried explosive hazards (BEH) remains a critical problem. Current combined sensing modalities, like electromagnetic induction and ground-penetrating radar, have demonstrated BEH detection capabilities, but are not optimal. TransTech proposes a novel combination of electromagnetic impedance spectroscopy and tomography for BEH detection and identification. Previous attempts to us ...

    SBIR Phase I 2012 Department of DefenseArmy
  9. Improved Mobile User Objective System (MUOS) Metaferrite Based Antenna for SATCOM

    SBC: Minerva Systems & Technologies, LLC            Topic: A12045

    The objective of this proposal is to design and develop UHF Satellite communications (SATCOM) circular polarized antennas using advanced metamaterials to achieve high gain performance with smaller dimensions (i.e., size and weight). The metamaterials we propose belong to a class of magneto-dielectric materials. The advantages and disadvantages of dielectric loading applied to electromagnetic devi ...

    SBIR Phase I 2012 Department of DefenseArmy
  10. Advanced Small, Lightweight Multi-Fueled 1,000- 1,500 W Variable Speed Load Following Man-Portable Power Unit

    SBC: SPECTRUM RESEARCH CORP.            Topic: A12048

    The U.S. Army has long recognized the benefits of load following gensets in terms of substantially reducing both fuel consumption and acoustic noise signature. The overall goal for the proposed effort is to develop an advanced 1-man portable, multi-fueled, electric power unit with load following capability and selectable 120 VAC, 28 VDC, and battery charger outputs. The 1500W size range is parti ...

    SBIR Phase I 2012 Department of DefenseArmy
US Flag An Official Website of the United States Government