Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Production of NIST/UCSF Breast Phantom for Magnetic Resonance Imagaing (MRI)

    SBC: Phantom Laboratory            Topic: N/A

    his project involves the commercialization of the breast phantom designed by NIST and University of California, San Francisco (UCSF) for quantitative magnetic resonance imaging (MRI). The breast phantom consists of two independent phantoms, one focused on diffusion MRI measurements and the other focused on accurate measurements of fat and fibroglandular tissue properties. The proposed phantom is o ...

    SBIR Phase I 2014 Department of CommerceNational Institute of Standards and Technology
  2. Dynamic Frequency Passive Millemeter-Wave Radiometer Based on Optical Up-Conversion

    SBC: Phase Sensitive Innovations, Inc.            Topic: 94

    Passive microwave sensors aboard satellites provide valuable information regarding weather conditions by measuring atmospheric attenuation over a broad range of frequencies from 0-200 GHz. Additional ground-based sensors are desirable to provide complementary upward looking measurements that can be used to refine existing attenuation models. Operating over such a large bandwidth, however, places ...

    SBIR Phase II 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  3. Anion Exchange Resin for Chirality-based Separation of Single-wall Carbon Nanotubes

    SBC: Sepax Technologies, Inc.            Topic: N/A

    Sepax Technologies, Inc. has identified a new type of anoin-exchange resin which separates single-wall carbon nanotubes (SWCNTs) with >80% recovery yield and resolves in a single pass the chiral tubes of (6,5) well from commercial SWCNT starting materials by Chromatography. Improvement and scale up of the targeted resin production will facilitate the separation of chiral nanotubes for the academic ...

    SBIR Phase II 2012 Department of CommerceNational Institute of Standards and Technology
  4. Rapid Additive Manufacturing of Very Low Cost 3-Dimensional Titanium Alloy Components

    SBC: ATS-MER, LLC            Topic: DLA10001

    The designers, manufacturers, and end users of metal components are increasingly turning to titanium (Ti) alloys, which can provide a substantial increase in performance. However, for most of these applications, the cost of Ti components is prohibitively high. The cost of Ti sponge powder is still a small portion (e.g. 5%) of the final Ti64 component cost. The predominant cause of the high cost ...

    SBIR Phase II 2012 Department of DefenseDefense Logistics Agency
US Flag An Official Website of the United States Government