You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. Production of NIST/UCSF Breast Phantom for Magnetic Resonance Imagaing (MRI)

    SBC: Phantom Laboratory            Topic: N/A

    his project involves the commercialization of the breast phantom designed by NIST and University of California, San Francisco (UCSF) for quantitative magnetic resonance imaging (MRI). The breast phantom consists of two independent phantoms, one focused on diffusion MRI measurements and the other focused on accurate measurements of fat and fibroglandular tissue properties. The proposed phantom is o ...

    SBIR Phase I 2014 Department of CommerceNational Institute of Standards and Technology
  2. Dynamic Frequency Passive Millemeter-Wave Radiometer Based on Optical Up-Conversion

    SBC: Phase Sensitive Innovations, Inc.            Topic: 94

    Passive microwave sensors aboard satellites provide valuable information regarding weather conditions by measuring atmospheric attenuation over a broad range of frequencies from 0-200 GHz. Additional ground-based sensors are desirable to provide complementary upward looking measurements that can be used to refine existing attenuation models. Operating over such a large bandwidth, however, places ...

    SBIR Phase II 2014 Department of CommerceNational Oceanic and Atmospheric Administration
  3. IM Green Propulsion Development

    SBC: Ogden Engineering & Associates, Llc            Topic: MDA13032

    Liquid fuel based Divert Attitude and Control Systems (DACS) or LDACS propulsion offers superior performance for future flight systems compared to solids (SDACS) or compressed gas systems. The need for improved system performance while meeting strict safety and insensitive munitions (IM) standards represents a unique opportunity for Ogden Engineering & Associates, LLC to showcase the team"s novel ...

    SBIR Phase I 2014 Department of DefenseMissile Defense Agency
  4. Improved Techniques for Optimistic Modeling

    SBC: Decibel Research, Inc.            Topic: MDA11031

    With discrete event or time stepped techniques, modeling and simulation (M & S) systems inefficiently utilize their expensive hardware platforms by idly waiting for results from slower model elements. Optimistic execution allows faster elements to"work ahead"but makes implementations much more complex, e.g., support for hypothetical timelines and speculative results that may need to be undone or r ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  5. Decision Support for Software Code Analysis

    SBC: Sentar, Inc.            Topic: MDA09030

    The Sentar veriScan tool is a software assurance product for analyzing and assessing both source and binary software files for the presence of program vulnerabilities, coding weaknesses, and malicious intent. VeriScan automates the execution of a critical mass of analysis programs for verifying large scale, implicitly trusted software systems; performs risk assessments; reports on those risks in ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  6. Smart Sensing for Integrated Low Power Radiological Protection

    SBC: RADIANCE TECHNOLOGIES, INC.            Topic: MDA12006

    The focus of Phase I of this project was to develop a materials based sensor to provide a novel approach to x-ray detection which is low power, cost effective, and highly integratable. Phase II of this project will further develop the design of the sensor and set the stage for a production level prototype. Phase II includes the investigation of the sensor"s capabilities and the optimization of sy ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  7. Marking of Components for Avoidance of Counterfeit Parts (Phase II)

    SBC: Applied DNA Sciences, Inc.            Topic: MDA12026

    Applied DNA Sciences (APDN) has developed a reliable DNA-optical adduct that is impervious to copying and is required by the Defense Logistic Agency (DLA) for the marking of FSC 5962 electronic components. Commercial inks supplemented with optical markers and proprietary APDN DNA, trademarked SigNature DNA, ink provide authentication marks that are of a higher standard relative to other taggant t ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  8. Modeling High Explosive (HE) Detonation Response and Resulting Debris/Shrapnel Generation from Submunitions Warheads

    SBC: PeopleTec, Inc.            Topic: MDA12008

    PeopleTec, Inc., a Woman-Owned Small Business (WOSB), teamed with SECOTEC and ITT Exelis, developed an innovative and economical solution for evaluating high explosive detonation response to impact through a Phase I SBIR. The Phase II program goals are to fabricate and demonstrate an end-to-end checkout of an innovative, low-cost test instrument enabling the assessment of a wide variety of high e ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  9. Automated Target Characterization and Correlation with Heterogeneous Kinematic and Feature Data for Sensor Hand-Over

    SBC: Andro Computational Solutions LLC            Topic: MDA12005

    In Phase I, our team applied their extensive experience in this area to develop and implement a unified target characterization and correlation framework focused on sensor hand-over (SHO) between electro-optic/infrared (EO/IR) and radar. The SHO system is designed to operate in an environment with multiple heterogeneous sensors where detection, classification and localization information is exchan ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
  10. Thermal Isolation of Solid Rocket Motor Exit Cone and Nozzle

    SBC: Plasma Processes, LLC            Topic: MDA12027

    Primary missile structures, ancillary mechanical and electrical sub-components of missile propulsion systems must be thermally isolated from hot propulsion gases. Silica-cloth phenolic and carbon-cloth phenolic are the go-to legacy insulator materials of choice. However, these materials have limited temperature use; mechanical degradation with decomposition of the matrix; and high thermal condu ...

    SBIR Phase II 2014 Department of DefenseMissile Defense Agency
US Flag An Official Website of the United States Government