List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. Multiple-ping High Resolution Minehunting Sonar for High Speed, Wide Area Searches

    SBC: Datasonics, Inc.            Topic: N/A

    There is a requirement for a seafloor mapping system that will provide high resolution imagery in very shallow water when rigidly mounted to a 24 foot boat that is advancing at up to 10 knots. In this Phase I effort we propose to determine the feasibility of meeting this requirement with a prototype multiple-ping chirp side-scan sonar to operate at high frequencies and high ping rates, where multi ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  2. Small Virtual Receiving Antenna

    SBC: Delfin Systems            Topic: N/A

    The Phase I technical objective is to design a small "virtual" receiving antenna which will operate in the HF, VHF, and UHF frequency ranges (approximately 1 MHz to 1500 MHz) and then to build and test a laboratory prototype. The virtual antenna will be capable of duplicating electrically, but not physically, the wide variety of antennas necessary to receive HF, VHF, and UHF signals. The virtual a ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  3. Miniature RF Receiving Antennas

    SBC: Delfin Systems            Topic: N/A

    N/A

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  4. Application of EFP Warheads with Enhanced Effects Material for Mine Neutralization

    SBC: Dyna East Corp.            Topic: N/A

    We propose to develop an improved Explosively-Formed Penetrator (EFP) warhead that in its basic application projects a slug that pentrates the mine's case and detonates the iner explosive. In an advanced, alternate mode, the warhead will project a penetrator capable of neutralization through deflagration. The alternative mode employs reative intermetallic materials in the warhead's main component, ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  5. Acoustic Pressure Gradient Imager For Divers

    SBC: EMPIRICAL TECHNOLOGIES CORPORATION            Topic: N/A

    The contractor has patented technology for a unique process that directly converts a two-dimensional acoustic disturbance, such as a wave front, into an intensity-mapped visible image in real-time without electronic circuitry; that is, it is a direct pressure gradient imager. The imager relies on the piezo-dichroic properties of a continuous layer of a dichroic material thin film that serves as bo ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  6. Photovoltaic Case for Electrical Equipment

    SBC: ENERGY CONVERSION DEVICES, INC.            Topic: N/A

    The objective of this project is to design, fabricate, and test a prototype photovoltaic (PV) case for electrical equipment used in field operations. The PV case could charge the equipment's batteries and/or directly operate low power equipment such as receivers and computers without a battery. The case would incorporate ECD's unique lightweight, flexible, and very rugged amorphous silicon PV modu ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  7. Investigation of Molded Photovoltaic Case

    SBC: ENERGY CONVERSION DEVICES, INC.            Topic: N/A

    N/A

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  8. Very Shallow Water Mine Countermeasures Diver Sonar-Lidar Sensor

    SBC: Hendrickson & Associates            Topic: N/A

    N/A

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  9. Advanced Combat Rubber Raiding Craft (Small) Design and Development

    SBC: Kepner Plastics Fabricators,            Topic: N/A

    The objective of this study is to design an advanced inflatable boat that will meet the special needs of U.S. Navy SEALs and be deployable from a submerged submarine in hostile waters. For "Stealth", radar, sonar, infra-red and audio signatures will be suppressed by incorporating features such as hydrodynamic shaping to minimize wake and spray generation and by selecting materials and structures h ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command
  10. Advanced Combat Rubber Raiding Craft (Small)

    SBC: Maravia Corp            Topic: N/A

    The Combat Rubber Raiding Craft (Small) (CRRC(S)) is used by Special Operations Forces (SOF). The current craft, underway, produces a highly discernible bow wave that enhances its probability of detection. A primary means of reducing the detect- ability of the CRRC(S) is to decrease the bow wave and wake of the craft that will enhance the survivability of the craft and crew in the combat arena. To ...

    SBIR Phase I 1994 Department of DefenseSpecial Operations Command

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government