Award Data

Leveraging their prior experience working with automated fiber placement (AFP) of thin-ply composite materials, NextGen Materials & Processing LLC and the University of Massachusetts Lowell will utilize a Design of Experiments approach, combined with analytical modeling, to identify the critical material, slitting, spooling, and AFP parameters that influence the repeatable, high quality laydown of ...

In this STTR Phase I program, Structured Materials Industries, Inc. (SMI) and Arizona State University (ASU) will develop a SiGeSn based light emitter device technology on Si, which will be a key ingredient for Si-based integrated photonics applications, such as in lab-on-a-chip integrated chemical and biological spectrometers for landers, astronaut health monitoring, front-end and back-end for re ...

This Multiband Software Defined Radio (SDR) sensor system proposal will demonstrate the ability to operate within multiple frequency bands and across multiple technology platforms in a single transceiver. The center frequencies and bandwidths chosen are representative of current demonstrated commercial or research devices and bands used: 400 MHz, 900 MHz, and 2.4 GHz ISM bands, with bandwidths of ...

Sensatek Propulsion Technology, Inc. proposes to demonstrate the feasibility of a wireless, passive, nanoparticle-based sensor system. The sensor in its current form can be used to measure real time temperatures and pressures wirelessly without the need of an external energy source. It should be noted that the same sensing principle can be used for strain monitoring as well. It comprises of a micr ...

Reducing the allowable concentration of carbon dioxide (CO2) in spacecraft is a critical need for NASA. The system now used on the International Space Station (ISS) is the carbon dioxide removal assembly (CDRA). While it has performed well on the ISS, managers have concluded that using the device to reach the new ppCO2 limit of 2.0 mm Hg is not practical and a new method is needed.In this projec ...

All rocket missions benefit from having lower structural mass and higher specific impulse, both of which contribute to larger payload fractions and therefore lower mission cost. High temperature materials such as ceramic matrix composites (CMCs) are an avenue to lower engine mass because of the low density and high specific strength of the material. They also have a high maximum temperature and so ...

Niobium alloy (C-103) reaction control system (RCS) chambers have been used on numerous NASA programs. However at elevated temperatures, the strength of C-103 decreases significantly. Higher strength niobium alloys have been developed, but these alloys lack the formability of C-103. Recently, Additive Manufacture (AM) of niobium and C-103 has been demonstrated using powder bed electron beam me ...

Opterus Research and Development, Inc. proposes to develop and validate multi-scale thin-ply High Strain Composites (HSCs) constitutive modeling tools for incorporation into commercial finite element analysis codes. The constitutive models will capture the time-temperature-load-deformation viscoelastic characteristics common to HSCs as well as the yielding or permanent deformation associated with ...

The landing surface damage and liberation of debris particles caused by rocket plume impingement flow during spacecraft propulsive landing on unprepared surfaces of Moon, Mars, and other celestial bodies poses a high risk for robotic and human exploration activities. Simply determining whether the plume induced loads exceed the bedrock bearing capacity threshold is not sufficient. An integrated m ...

The goal of the proposed Phase I work is to demonstrate the feasibility of the coordination and control of a low cardinality (n=12) swarm of smallsats that realizes a distributed Synthetic Aperture Radar (SAR) in low Earth orbit. Preliminary mission and spacecraft design work has shown that the swarm can support SAR imaging in the L-band (1.35 GHz) with a ground range resolution finer than 10 m wi ...