Award Data

The US Navy is moving towards a Single Sortie Detect to Engage (SSDTE) paradigm to implement in-stride minehunting and mine prosecution. Integrating in-stride Mine Search and Mine Prosecution functions is a key requirement to achieve the SSDTE paradigm. Mine Target Reacquisition between the mine search operations and mine prosecution phases poses a particular challenge, as planned mine prosecution ...

As the complexity of threats and emerging warfare capabilities increase, so do the number of Tactics, Techniques, and Procedures (TTPs) and the corresponding training regimes. Instructors are increasingly in need of automated tools to enable training that scales with complexity. Aptima, Inc., and our partners, Aviation Systems Engineering Company, Inc. (ASEC) and the University of Southern Califor ...

Current cervical spine assessment methodologies are focused on subjective measures (i.e. pain reports) and range-of-motion (ROM) measures that only measure maximum head excursion and reach, but not dynamic motion. Due to report bias and existing incentive

Traumatic injuries account for 30% of all life years lost in the US and is the leading cause of death for people under 46 years of age. Uncontrolled bleeding or hemorrhage constitute 30-40% of trauma related deaths and are considered to be a major cause o

Current prosthetic feet produce much less peak mechanical power than the able-bodied foot/ankle and release only about half of the mechanical energy generated during gait. This leads to higher energy expenditure among amputees as compared to able-bodied i

Manufacturing of structural composites traditionally employs autoclaves to achieve high quality parts, including high fiber-volume-fractions and low porosity. A laminate comprised of stacked prepreg plies are cured under a vacuum in addition to ~7 bar of pressure to prevent formation of voids, particulalry in interlaminar (inter-sheet/ply) regions. However, manufacturing composites within an autoc ...

For this research program, Mainstream will collaborate with Colorado State University (CSU) to develop a nanostructured heater capable of curing aerospace grade composites out-of-autoclave (OOA). The use of autoclaves is the primary cost driver in composite manufacturing due to size limitations, long processing times, and inefficient energy usage. Therefore, the Navy is looking to develop a nanost ...

SSCI and MIT (Prof. Julie Shah) propose to develop and test a system that provides real-time assurance and trust in decisions made by autonomous collaborating vehicles. The proposed system is referred to as the RESTORE and represents a decision support tool which facilitates decision making by the operator in cases when decisions by the Collaborative Autonomy (CA) system results in deviations from ...

HPM (high power microwave) weapons could disable vehicles, enable vehicle recovery, and reduce collateral damage. Metamagnetics, in partnership with Professor Jane Lehr (University of New Mexico), and General Atomics propose a completely solid-state HPM system based on their work in Gyromagnetic Nonlinear Transmission Lines (gNLTL) and compact High-Gain Slotted Waveguide Antennas. The system will ...

Composites are often used in aerospace applications due to their superior specific strength and stiffness properties, as well as their resistance to fatigue and corrosion. In particular for rotorcraft, composites offer additional benefits for their versatility in tailoring material properties for such components as rotor blades. However, rotors introduce additional challenges by including multiple ...