Award Data

This Small Business Technology Transfer (STTR) Phase II project proposes the development of an integrated powered knee-ankle prosthesis. The objective of this proposal is to investigate the use of integrated powered knee and ankle joints in trans-femoral prostheses that use sensory information from the ground and the wearer. The hypothesis is that a prosthesis with actively powered knee and ankle ...

This Small Business Technology Transfer Phase I project will develop a new system for fabrication and manipulation of carbon nanotube (CNT) composites. The system will use holographic optical trapping (HOT) with a spatial light modulator (SLM) and a new form of nano-controlled photo-polymerization. This tool will allow the creation of a new class of carbon-nanotube polymer composite materials wit ...

This Small Business Technology Transfer (STTR) Phase I project aims to develop a manufacturing process that can coat a variety of substrates with uniform thin films of inherently conducting polymer (ICP) nanofibers over a large area. Traditionally, these nanostructured organic materials are difficult to process into thin films covering a large area, which has limited the commercial applicability ...

This STTR Phase I project proposes to develop and establish a novel clumping (flocculation) strain of algal using an engineered extracellar protein that can be induced. The overarching goal is to provide the industry with a novel, energy efficient, and cost effective tool to dewater microalgae. What are the broader/commercial impacts of the proposed project? The broader/commercial impact of the p ...

This Small Business Technology Transfer Phase I project will address the critical need for low driving voltage, adaptive materials providing large phase retardation (for ultraviolet, visible, and infrared wavelengths) within a sub-millisecond time frame. Two technologically innovative tasks will be pursued in parallel and then merged, resulting in the creation of a new class of optical materials - ...

This Small Business Technology Transfer (STTR) Phase I project aims to develop roll-to-roll processing of highly efficient, thin film photovoltaics on inexpensive polycrystalline substrates. The innovation lies in an architecture that yields near-single-crystalline thin films even on polycrystalline substrates. This innovation will be combined with the benefits of hot wire chemical vapor deposit ...

This Small Business Technology Transfer Program Phase I project aims to develop a refreshable Braille display for the blind. Existing Braille technologies require complicated mechanical designs that are bulky and too expensive for personal use. A new technology based on a new smart material (bistable electroactive polymer) will be developed to enable a Braille dot array on a thin flat panel. The ...

This STTR Phase I project will develop a process to produce silica products from the waste stream of a patent pending activated carbon manufacturing process (carbonxt process). The project focuses on using the silica for Silica-Titania Composites but would also take into account markets that employ precipitated or gel silica which would have differing properties than the silica used in Silica-Tit ...

This Small Business Technology Transfer (STTR) Phase I project aims to fabricate anti-reflective coatings (ARC) for solar energy applications. The approach is to use a convective and evaporation-induced assembly to deposit organized nanostructures and create sub-wavelength quasi repeating structures at lower cost than the repeating structures from photolithography. In this project, a Microreacto ...

This Small Business Technology Transfer (STTR) Phase I project aims to develop high efficiency polymers for organic photovoltaic cells (OPVs). OPVs based on polymers are ideal for environmentally-benign and affordable energy generation. However, the efficiency of OPVs is still low compared to their inorganic counterparts, currently at 7.9%. One of the major reasons is the lack of polymers with ...