Award Data

Additive manufacturing (AM) has rapidly evolved into a valuable technique for making parts which, at times, cannot be fabricated through conventional machining methods, or for fabrication of small quantities of complex parts. One challenge in the area of AM is the lack of real-time feedback on the fabrication process and the quality of the part being made. This is especially critical given the rel ...

This Phase II project aims to assemble the key set of sensor modalities that are needed to reliably view the key process anomalies and properties of laser powder bed fusion. The research team will down-select from the Phase I sensors investigated and integrate the sensors into a sensor fusion software package that facilitates data collection and synchronization, and eventually feedback control of ...

Traumatic injuries account for 30% of all life years lost in the US and is the leading cause of death for people under 46 years of age. Uncontrolled bleeding or hemorrhage constitute 30-40% of trauma related deaths and are considered to be a major cause o

The proposed research and technical objectives in this project deal with computerized automatic delayering and polishing system that would be applicable to both commercial and government semiconductor device research and development with applications including Failure Analysis (FA), Fault Isolation (FI), and Reverse Engineering (RE) of semiconductor microelectronic devices. This project could hel ...

Most standard-of-care tools and techniques for evaluating neck disorders are subjective, unreliable, and do not provide actionable information for providers, payers, and organizations to deliver efficient and effective care. This lack of objective neck he

Thegoal is to develop asoftwaretool that implementsa novelapproach applicableto fitgeneral pharmacologic, toxicology, or other biomedical data, that mayexhibita non-monotonic dose-responserelationship for which thecurrent parametricmodels fail. Thesoftwareexplores dose-responserelationships using both monotonicand non-monotonicmodels,and estimates theassociated doseresponsecurves,which can further ...

Universal Technology Corporation (UTC) has teamed with the University of Dayton Research Institute (UDRI), Stratonics, and Macy Consulting to demonstrate not only the transitionability into commercial systems, but also to develop the data analytics and monitoring and control requirements to extract the full value fromseveral sensors, including the Stratonics ThermaViz, acoustic and profilometry se ...

Marburg virus (MARV) is a filamentous enveloped non-segmented negative sense RNA virus. This viruse is considered to be extremelydangerous with case fatality rates as high as 88-90%. Extensive efforts have gone towards effective vaccines for MARV prevention, however,none have been successfully established as licensed vaccines. Glycoprotein (GP) is the only surface protein of MARV. There are substa ...

Additive manufacturing (AM) has rapidly evolved into a valuable technique for making parts which, at times, cannot be fabricated through conventional machining methods.One challenge in the area of AM is the lack of real-time feedback on the fabrication process and the quality of the part being made.This is especially critical given the relatively long periods of time that complex parts can require ...

In resource limited settings, rapid and accurate diagnosis of infections is critical for managing potential exposures to highly virulent pathogens,whether occurring from an act of bioterrorism or a natural event. This is especially important for hard to detect intracellular bacterial andalphavirus infections, that overlap symptomatically and often treated empirically due to a lack of reliable and ...