Award Data

Current ground penetrating radar based root analysis techniques have been mainly targeted for coarse root analysis. In order to extend the GPR technology to fine root analysis, it is necessary to design an unconventional GPR system that provides root information in the entire area under observation with greater accuracy and penetration depth. Specialized signal/image processing algorithms applicab ...

SixPoint Materials will create low-cost, high-quality vertical gallium nitride (GaN) substrates using a multi-phase production approach that employs both hydride vapor phase epitaxy (HVPE) technology and ammonothermal growth techniques to lower costs and maintain crystal quality. Substrates are thin wafers of semiconducting material needed for power devices. In its two-phase project, SixPoint Mate ...

Statement of Problem: The US DOE has set a goal to advance photovoltaics (PV) technology to reach installed costs of less than $1/Watt. This requires module costs below $0.50/ Watt. Thin film PV provides the lowest documented production cost per watt ($0.67) of any PV technology. Module reliability has a direct impact on the levalized cost of energy (LCOE), or the cost of the energy produced by ...

The Exascale Computing Project is tasked to develop the next generation of high performance computing systems capable of computing at 50 to 100 times faster than current HPC systems. Computing at this extreme-scale will significantly enhance the value of materials modeling and simulation to basic materials research and engineering In particular, computing at the extreme scale will enable a higher ...

Understanding the genomic basis of economically important plants for growth time, crop yield, responses to drought and disease resistance is of critical importance to sustaining and improving food supplies for humans and livestock, as well as insuring sufficient raw material availability for industries that depend on plant materials, such as biofuel manufacture. Current computational methods for a ...

Generating and screening multiple combinations of genes, enzymes, and other biological parts has become vital to next generation biofuel development and production. This currently requires large personnel costs and sizeable capital investments in robotics equipment. Commercial adoption of the synthetic biology technology will require high throughput capabilities, low cost, product reliability, and ...

Computer-aided Engineering software that apply the Finite Element Method to perform a multi-physics analysis have received widespread acceptance for traditional macro-scale material systems. Challenges persist in the modeling of complex coupled processes in environmental/thermal barrier coatings (E/TBCs) used to protect substrate material against the corrosive environment in the hot section parts ...

Tristructural isotropic (TRISO) fuel is a key component of advanced small modular nuclear fission reactors due to its inherent safety at high temperatures and irradiation levels and decreased proliferation risk relative to current reactor fuels. A more efficient cooling method for TRISO fuel compacts would increase heat transfer, allow for an increase in fuel density, and further improve accident ...

Development of new instrumentation for measuring volatile organic compounds (VOC) and intermediate volatility organic compounds (IVOC) that may react to form secondary organic aerosols (SOA) has been identified as a vital need by DOE. Revealing the detailed mechanisms leading to SOA formation from gas phase precursors is best achieved by measuring both phases with sufficient temporal resolution to ...

Vast amounts of impaired waters are produced in gas and oil wells. Energy-efficient desalination systems are needed to treat these waters to produce fresh water and concentrated brines. Mineral recovery systems can also yield valuable critical materials as byproducts. Savengy Technologies and University of Central Florida (UCF) will develop and commercialize an energy efficient system to treat sha ...