Award Data

To further advance the characterization and utility of microcantilevers, next generation optical detectors with higher frequency response, improved displacement resolution and lower noise for weak signal detection are needed. Consequently, Radiation Monitoring Devices, Inc. (RMD) will develop a turnkey optical detector module for use in characterizing the displacement and resonant frequencies of m ...

NIST needs a complete residential energy monitoring system to convey real-time comprehensive energy consumption data by particular end-use to occupants. POC developed a new Comprehensive Wireless Residential Energy Monitoring (CORE) system that integrates multiple wireless sensor modes with a unique radio board into an innovative wireless network architecture. Key Phase I developments were a first ...

Based on our success in developing the world’s first commercial 10 W femtosecond fiber laser system and our leading technology development in ultrashort pulsed fiber laser, PolarOnyx proposes, for the first time, a compact high power dual band integrated fiber laser source. The integrated system will be the first extremely compact comprehensive system to address NIST’s current and future needs ...

In Phase 1, TIAX developed and demonstrated a residential energy monitoring system (R-EMS) with potential national energy savings of $20 billion annually. Based on user requirements and well-established systems engineering methodology, TIAX’s R-EMS solution is inexpensive, easy to install and operate, and is supportive of intuitive decision making about energy usage. In Phase 2, TIAX will extend ...

A back-illuminated planar InGaAs photodiode tested to have 95% quantum effiiency (QE) at 1550 nm, area greater than 1 mm2, low capacitance (125 MHz) will be improved. Although the existing Phase I device exhibited bulk material dark current generation better than commercially available devices, the sidewall-generated dark current was found to dominate the noise equiva ...

We propose the definition, design, and prototype development of a software tool for use by the U.S. manufacturing community to enable the automated production of design-based measurement strategies of know reliability and high economic efficiency for coordinate measuring machines (CMMs). The measurement strategies so generated will meet the objective of reducing overall costs to near-minimal value ...

Development of LEDs for various applications, such a vehicle lighting, signage, and commercial and residential solid state lighting is progressing at a rapid pace. Various methods exist for measuring the performance of LEDs, but variations in test configurations, thermal management, T&M equipment, and operator experience lead to significant variation in measured performance. The project will desig ...

Junctional and inguinal bleeding is a significant and challenging problem on the battlefield. Inventors have developed new types of tourniquets, including the Abdominal Aortic Tourniquet (AAT) and the Combat Ready Clamp (CRoC) to address these abdominal and pelvic injuries. While these hemorrhage control technologies have been developed, validated, and approved for use, training systems that teach ...

Junctional and non-compressible bleeding is a life-threatening injury that requires immediate intervention. Therefore it is best to train even non-medics in the application of the life-saving methods to stop these hemorrhages. The ideal system would enable training on multiple injury types, react realistically to properly applied intervention, utilize the adjuncts as would be used in the field, ...

This proposal is to develop an adaptable and expandable simulation-based training system for teaching and training the soon-to-be-deployed medics in junctional and non-compressible hemorrhage control and other point of injury care trauma control scenarios using Combat Ready Clamp, Abdominal Aortic Tourniquet or similar devices. Training system will include: 1. A model of a torso mimicking anat ...