Award Data

The cost of dewatering particles is inversely proportional to particle size. Costs dramatically increase as particle size approaches 10

Coal is an abundant source of energy in the USA, but is not currently utilized effectively. Recently, the DOE has begun a carbon sequestration program is to develop advanced CO2 capture and compression technology for existing coal-fired plants with increased efficiency with no more than a 35% increase in the cost of electricity. This will require new approaches and technologies to be successful. N ...

Solid state lighting is being promoted as the ultimate lamps of future. Though the internal quantum efficiency of OLED devices is almost 100%, external efficiency is a mere 36% mainly because of poor light out-coupling (~40%) from the device. Improvement in light out-coupling to >70% and further reducing the manufacturing cost will rapidly accelerate the commercialization of the OLED technology. T ...

The fabrication of high-quality ultra thin (~20 micron) diamond crystals targets for 9 GeV highly polarized photon beams is an outstanding challenge. Current state of the art polishing/thinning techniques are not successful in thinning single crystal diamond to such dimension because of its extreme hardness and chemical inertness. These techniques create significant stresses surface and sub-surfac ...

Providing a reliable, clean and economical energy source is a priority of the US government. The challenge is to use coal, a secured and economical energy source, to produce clean hydrogen fuel to support domestic and global green economy with near-zero emission. Conventional separation technology and even developmental technology do not satisfy all of the requirements for hydrogen production from ...

Formic acid (FA, CH2O2) is the simplest carboxylic acid. It is mainly used as a preservative and antibacterial agent in livestock feed. A significant fraction of FA is used in the leather-processing, textile and rubber industries and a small fraction of formic acid is used as a cleaning agent replacing mineral acids. Aqueous FA is a promising liquid hydrogen-storage carrier with a hydrogen storage ...

DoEs recent emphasis on increasing fuel economy requires electrification of the vehicle powertrain, thus leading to extended range electric vehicles (EREVs), hybrid electric vehicles (HEVs), battery electric vehicles (BEV) and fuel cell electric vehicles (FCEV). All electric propulsion systems require high current, high-voltage (600 V-1200 V), low-loss power semiconductor switches. Present electri ...

Computer-aided Engineering software that apply the Finite Element Method to perform a multi-physics analysis have received widespread acceptance for traditional macro-scale material systems. Challenges persist in the modeling of complex coupled processes in environmental/thermal barrier coatings (E/TBCs) used to protect substrate material against the corrosive environment in the hot section parts ...

High performance supercritical carbon dioxide (sCO2) turbo-expanders/power turbines will provide significant increases in efficiency and compactness, while reducing greenhouse gases and water usage. However, the needed operation in a 900°C environment is a challenge for this type of turbomachinery. While magnetic bearings have many advantages over foil bearings, including no wear during startups, ...

The majority of hybrid electric vehicles and electric vehicles (HEV/EV) products use interior permanent magnet (IPM) synchronous machines for traction purpose due to the efficiency and power density consideration. IPM machines use high energy density rare earth based magnet materials such as neodymium and dysprosium. Variable flux (VF) machines using abundant and cheaper soft magnets such as AlNiC ...