You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

  1. Advanced Li/CFx Primary Batteries with Non-Flammable Electrolytes

    SBC: CFX BATTERY, INC.            Topic: T601

    NASA seeks to develop high specific energy primary batteries that are safe and capable of performing under a wide temperature range, for manned space missions. To meet this goal, CFX Battery Inc. proposes to develop, characterize, and establish technological feasibility of a new Li/SF-CFx based high capacity lithium primary battery that offers higher rate capability and enhanced safety than conven ...

    STTR Phase I 2010 National Aeronautics and Space Administration
  2. Advanced Simulation Framework for Design and Analysis of Space Propulsion Systems

    SBC: STREAMLINE NUMERICS, INC.            Topic: T901

    The innovation proposed here is a high-performance, high-fidelity framework in the computational fluid dynamics (CFD) code called Loci-STREAM to enable accurate, fast and robust simulations of unsteady multiphase flows such as combustion involving liquid-gas phases in liquid rocket injectors and solid-gas phases in solid rocket motors, and cryogenic cavitation in delivery systems of liquid rocket ...

    STTR Phase II 2010 National Aeronautics and Space Administration
  3. Advanced Structural Health Monitoring System for Comprehensive Real-Time Vehicle Characterization

    SBC: AMERICAN GNC CORPORATION            Topic: T1

    In providing an innovative solution to improving information technologies and health management systems, AGNC is proposing a significant technological achievement with the Advanced Structural Health Monitoring System for Comprehensive Real-Time Vehicle Characterization. During in-flight conditions, this system is able to not only provide the status of information such as regarding the flight envel ...

    STTR Phase I 2010 National Aeronautics and Space Administration
  4. Advanced Unsteady Turbulent Combustion Simulation Capability for Space Propulsion Systems

    SBC: STREAMLINE NUMERICS, INC.            Topic: T901

    The innovation proposed here is a high performance, high fidelity simulation capability to enable accurate, fast and robust simulation of unsteady turbulent, reacting flows involving cryogenic propellants (such as LOX/LH2 and LOX/LCH4). The key features of this proposed capability are: (a) Hybrid RANS-LES (HRLES) methodology, and (b) flamelet modeling for turbulent combustion incorporated in a pr ...

    STTR Phase I 2010 National Aeronautics and Space Administration
  5. An LED-Based Solar Simulator for Research, Development, and Testing of Photovoltaic Space Power Systems

    SBC: Angstrom Designs, Inc.            Topic: T201

    Solar cells are the critical power source for the majority of space missions. The advancement from single junction silicon cells to current, state-of-the-art, triple junction, germanium cells enabled greater mission power per weight, stowed volume and deployed area. Near-term, advanced solar cell technologies will range from 4 to 6 junctions, and include a variety of band gaps.Solar cell testing ...

    STTR Phase I 2013 National Aeronautics and Space Administration
  6. A Reusable, Oxidizer-Cooled, Hybrid Aerospike Rocket Motor for Flight Test

    SBC: ROLLING HILLS RESEARCH CORP            Topic: T202

    The proposed innovation is to use the refrigerant capabilities of nitrous oxide (N2O) to provide the cooling required for reusable operation of an aerospike nozzle in conjunction with an N2O-HTPB (hydroxyl-terminated polybutadiene, a synthetic rubber that is used as a binder in solid rocket motors and as a fuel in hybrid rocket motors) hybrid rocket motor. The phase change cooling as liquid N2O i ...

    STTR Phase II 2010 National Aeronautics and Space Administration
  7. A Self-Regulating Freezable Heat Exchanger for Spacecraft

    SBC: TDA Research, Inc.            Topic: T601

    A spacecraft thermal control system must keep the vehicle, avionics and atmosphere (if crewed) within a defined temperature range. Since water is non-toxic and good for heat transport, it is typically used as the coolant that circulates within the crew cabin boundary. This loop then interfaces with another low freeze point fluid, such as ammonia, for transport of heat to a radiator where the tempe ...

    STTR Phase II 2013 National Aeronautics and Space Administration
  8. Attitude Control Enhancement Using Distributed Wing Load Sensing for Dynamic Servoelastic Control

    SBC: Systems Technology, Inc.            Topic: T402

    Fly-by-feel uses distributed sensing of forces along the lifting surfaces of an aircraft. Whether such measurements are made via hot films, pressure sensors, or strain gauges, all can provide distributed force information that must be intelligently fused and utilized to achieve performance goals. Fly-by-feel will be used to achieve robust disturbance rejection, mass property augmentation, and aero ...

    STTR Phase I 2013 National Aeronautics and Space Administration
  9. Biotemplated Nano-Structured Materials for Advanced Li-ion Batteries

    SBC: CFX BATTERY, INC.            Topic: T301

    NASA has identified a critical need for pioneering advances in battery technology to give high performance, low-weight, durable and long-life power sources for future missions. In this Phase I proposal, CFX Battery, Inc. and Georgia Institute of Technology propose the chemical conversion of micron-sized, nano-structured templates available from renewable resources into functional electrode materia ...

    STTR Phase I 2010 National Aeronautics and Space Administration
  10. Closed-Loop Control of the Thermal Stir Welding Process to Enable Rapid Process / Part Qualification

    SBC: Keystone Synergistic Enterprises, LLC            Topic: T901

    Thermal Stir Welding (TSW) provides advancement over the more conventional Friction Stir Welding (C-FSW) process because it separates the primary processes variables thereby allowing independent control of metal stirring and forging from the stir zone temperature. However, the feedback for precise control of the stir zone temperature, and hence the process parameters to sustain that temperature wi ...

    STTR Phase II 2013 National Aeronautics and Space Administration
US Flag An Official Website of the United States Government