Award Data

Direct Internal Reforming Solid Oxide Fuel Cells require an anode material with good catalytic reforming and electrochemical reactivity. Although the current state-of-the-art solid oxide fuel cell anode consisting of nickel and yttrium-stabilized zirconia (Ni-YSZ) has excellent catalytic properties and stability for the H2 oxidation at the usual operation conditions, the use of Ni-YSZ anode with c ...

"The next generation of very high field accelerator magnets (20 T or more) are expected to be made with high-temperature superconductors (HTS) along with conventional low-temperature superconductors (LTS) to reduce cost. The operation and protection of these magnets becomes very challenging particularly if the HTS coils are made with the tapes and operate at a much lower current than the LTS coils ...

To increase the utilization of electric vehicles, the US Department of Energy is seeking to reduce the cost of electric vehicle batteries to less than $125/kWh by 2022. To achieve this goal, the costs of cathode materials, which account for approximately 30% of the cost of vehicle batteries, must be reduced significantly. To address the challenge of lowering the costs of advanced lithium battery c ...

This proposal is submitted in response to the SBIR/STTR Office of Science related to Quantum Information Science (QIS) Supporting Technologies. There is the need for fabrication techniques for scalable 3D Superconducting Radio Frequency (SRF) Structures for Quantum Information Systems. In this proposal we will develop an additive manufacturing approach to developing superconducting 3D microwave re ...

The majority of hybrid electric vehicles and electric vehicles (HEV/EV) products use interior permanent magnet (IPM) synchronous machines for traction purpose due to the efficiency and power density consideration. IPM machines use high energy density rare earth based magnet materials such as neodymium and dysprosium. Variable flux (VF) machines using abundant and cheaper soft magnets such as AlNiC ...

Sn-doped In2O3 (ITO) is the industry standard and most widely used transparent conducting electrode (TCE) because of its good electrical and optical properties. However, ITO has a number of disadvantages: ITO is not a suitable TCE for next-generation, high-efficiency, flexible OLEDs, because of its inappropriate work function, difficulty in creating desired patterns, low stability, delaminantion d ...

The mechanisms guiding nanocatalysis are poorly understood and extremely hard to model. Proposed effort attempts to provide a machine learning based platform that would guide the design of nanocatalytic materials for a variety of applications, beginning with the use of case of chloro-organic contaminant remediation. The current approaches either use conventional molecular dynamics coupled with ab ...

Tall towers and foundations for modern offshore and land-based wind turbines are too large to transport over roads or rail due to their extremely large dimensions. Existing “one-off” on-site construction methods are too expensive, and are too slow for manufacturing foundations and towers in the large numbers needed, especially for offshore components manufactured in ports with limited lay-down ...

Fusion plasma devices at various DOE and international facilities need high-speed diagnostic tools to understand, predict, and control fusion plasmas. Thomson scattering (TS) at tens of Hz has routinely measured electron temperature (Te) and electron number density (ne) inside the plasma system. However, at these data rates traditional TS can obtain only a sparse data set, which significantly limi ...

The power output of the high power lasers used in physics research is limited by the materials available for making the gain media in the laser. Future increases in power will require new and better materials. Operation at high power creates great thermal stresses that can lead to effects such as birefringence, thermal lensing or even physical fracture damage to the host itself. Effective cooling ...