You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY21 is not expected to be complete until September, 2022.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. Epitaxial GaN on flexible metal tapes for low-cost transistor devices

    SBC: IBEAM MATERIALS, INC.            Topic: 1

    GaN-based devices are the basis of a variety of modern electronics applications, especially in optoelectronics and high-frequency / high-power electronics. These devices are based on epitaxial films grown on single-crystal wafers. The single-crystal wafer substrates are limiting because of their size, expense, mechanical properties and availability. If one could make GaN-based devices over large a ...

    STTR Phase I 2013 Department of EnergyARPA-E
  2. Polymer Nanowire Sensor Array for Subsurface CO2 Monitoring

    SBC: Innosense Llc            Topic: 17c

    The DOEs & quot;Monitoring Verification and Accounting (MVA) program goal is to confirm permanent storage of CO2 in geologic formations by real-time monitoring should CO2 leak. Remote technologies, effective for atmospheric or above ground CO2 monitoring, are ineffective for subsurface, and it is where leakage can be detected first. By the time leaked CO2 slowly appears on the surface, CO2 may hav ...

    STTR Phase II 2013 Department of Energy
  3. Realization of Mulitlayer High Temperature Capacitors with New Dielectric Materials and Novel Thermal Spray Deposition Route

    SBC: DRS Research            Topic: 01a

    The main focus of this STTR is to design, develop, and evaluate high temperature capacitors using novel thermal spray coating processes, which will allow the devices to meet the performance requirements. Multilayer coating architecture will be adopted and the electrodes and dielectric material selections will be screened in Phase I to note material compatibility and high temperature performance. ...

    STTR Phase I 2013 Department of Energy
  4. Novel Module Architecture Development for Increased Reliability and Reduced Costs

    SBC: Creative Light Source, Inc            Topic: 07a

    Statement of Problem: The US DOE has set a goal to advance photovoltaics (PV) technology to reach installed costs of less than $1/Watt. This requires module costs below $0.50/ Watt. Thin film PV provides the lowest documented production cost per watt ($0.67) of any PV technology. Module reliability has a direct impact on the levalized cost of energy (LCOE), or the cost of the energy produced by ...

    STTR Phase I 2013 Department of Energy
  5. Practical Fiber Delivered Laser Ignition Systems for Vehicles

    SBC: Seaforth LLC            Topic: 08b

    Improved ignition methods are needed for advanced vehicle combustion systems, in particular those that allow reliable ignition of lean mixtures in gasoline engines at elevated pressures. Laser ignition is a candidate technology having the potential to address these needs. However, despite more than 40 years of laser ignition research, the technology is not yet in commercial use. A critical proble ...

    STTR Phase I 2013 Department of Energy
  6. Advanced Spectroscopic Capabilities for 3-D Synchrotron X-Ray Microscopes

    SBC: Xradia            Topic: 09a

    Many important technology challenges today such as the capacity and life time of batteries require new characterization techniques to understand and improve performance. In the STTR Phase II project, novel x-ray microscope techniques and software are developed to be able to image samples in three dimensions and determine chemical composition and function on a microscopic level. As known from ubi ...

    STTR Phase II 2013 Department of Energy
  7. Resonant Enhanced Infrared Nano-Spectroscopy (REINS)

    SBC: Anasys Instruments Corp.            Topic: 14b

    Infrared spectroscopy is the most widely used technique for chemical characterization with a worldwide market of over $1B annually. Conventional infrared spectroscopy suffers, however, from fundamental spatial resolution limits that prohibit its application at the nanoscale. This has prevented widespread use of IR spectroscopy in the growing field of nanoscale materials. The atomic force microsc ...

    STTR Phase II 2013 Department of Energy
  8. Complete Muon Collider Cooling Channel Design and Simulations

    SBC: MUPLUS INC            Topic: 28b

    Considerable progress has been made in developing promising subsystems for muon beam cooling channels to provide the great reduction of emittances required for an Energy-Frontier Muon Collider; but an end-to-end design is lacking. Meanwhile, the recent discovery of a Higgs-like boson has created interest in the high-energy physics community for a Higgs Factory to investigate whether its propertie ...

    STTR Phase II 2013 Department of Energy
  9. Advance Additive Manufacturing Method for SRF Cavities of Various Geometries

    SBC: Radiabeam Technologies, LLC            Topic: 34a

    Current state-of-the-art SRF accelerating cavities require the use of many complex and expensive techniques throughout their fabrication/performance cycle. This project will utilize a novel Additive Manufacturing (AM) process to produce nearly monolithic SRF niobium cavities of arbitrary shape with features such as optimized wall thickness and/or integrated stiffeners, greatly reducing the cost a ...

    STTR Phase II 2013 Department of Energy
  10. REBCO Coated Conductor Cables for Fusion Magnets

    SBC: ADVANCED CONDUCTOR TECHNOLOGIES LLC            Topic: 22c

    The feasibility for fusion as a practical energy source needs to be enhanced significantly by removing some of the restrictions that low-temperature superconductors put on the fusion magnet systems. This can be done by using high-temperature superconductors, allowing for much larger temperature margins, a higher magnet performance and less mechanical degradation during operation. There are curren ...

    STTR Phase II 2013 Department of Energy
US Flag An Official Website of the United States Government