Award Data

Apptronik Systems in cooperation with the University of Texass Human Centered Robotics Lab (HCRL), Carnegie Mellon Universitys Robotics Institute and Italys National Research Institute (CNR), will collaborate to develop a new type of exoskeleton that is founded upon Apptroniks Visco-Elastic Liquid Cooled Actuator (VLCA). The fundamental goal of this program is the development of a powered exoskel ...

This is an Addendum to previously submitted proposal that includes the addition of a powered upper body portion of an exoskeleton. In this addendum we propose the additional requirements of researching, fabricating and integrating a powered upper body to the previously outlined lower body. These two systems together will comprise the entire exoskeleton proposed by the contractor. Through this ...

The S-351 mini-sub is a prototype of the Dry Combat Submersible (DCS). This prototype was established as a means of risk reduction prior to a full commitment to the DCS program. Both of these platforms have an operational need to transit with minimum operator fatigue safely to a pre-defined point and covertly deploy and retrieve SEALS. To meet these operational needs, these platforms require upgra ...

Apptronik Systems Inc., in cooperation with the University of Texas Human Centered Robotics Lab (HCRL) and Huston-Tillotson University Robotics Lab (a historically black college and university HBCU), endeavor to advance the movement capabilities and modularity of the exoskeleton being developed under contract #H92222-17-C-0050. The primary goal of this program is to optimize the range of movement ...

Cost-effective application of advanced commercial electronics technologies in DoD space systems requires early development of radiation-hardened-by-design (RHBD) techniques, and use of simulations is critical to the efficiency of this process. CFDRC has developed an integrated, mixed-mode simulation approach allowing their NanoTCAD device physics simulator to interface with commercial circuit simu ...

Compact Electromagnetic Pulse Module (EMP) capable of being arranged in series-parallel planar or cylindrical arrays is needed to simulate nuclear weapon effects. High gain optically triggered photoconductive semiconductor switches (PCSS) based on Gallium arsenide (GaAs) with low timing jitter enables the development of planar or phased arrays of modular EMP or High Power Microwave (HPM) sources. ...

Nalas Engineering and Johns Hopkins University collaborated in a Phase I STTR program to study reactive mixtures of HI3O8 and nanocomposite fuels previously developed by the Weihs Group. These fuel/oxidizer mixtures are uniquely able to simultaneously produce heat and biocidal iodine gas, a combination designed to destroy biological weapons. The team at Nalas focused on evaluating conditions for p ...

To Counter Weapons of Mass Destruction (CWMD), DTRA must analyze data from numerous sources about a diverse set of technologies and activities. The extreme diversity in content and the volume of DTRAs data combine to produce one of the most challenging analysis problems in the government. The CWMD mission therefore requires deep analysis - an in-depth understanding of all available data and correl ...

The modern warfighter faces the constant threat of endemic infections, multi-drug resistant bacteria and Biological Warfare Agents. In order to provide accurate front-line treatment that will curtail the overuse of antibiotics, a rapid and robust molecula

MATSYS proposes to adapt emerging additive manufacturing techniques (so-called 3-D Printing) for use with reactive structural materials and demonstrate this capability to rapidly fabricate reactive case. Our concept incorporates two major manufacturing steps: 3D printing of green compacts from pure Al or Al-based reactive powder blend; and Microwave (MW) sintering of green compacts into net-shaped ...