You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY21 is not expected to be complete until September, 2022.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. STTR Phase II:Integrated Powered Knee-Ankle Prosthetic System

    SBC: Ekso Bionics Inc            Topic: EO

    This Small Business Technology Transfer (STTR) Phase II project proposes the development of an integrated powered knee-ankle prosthesis. The objective of this proposal is to investigate the use of integrated powered knee and ankle joints in trans-femoral prostheses that use sensory information from the ground and the wearer. The hypothesis is that a prosthesis with actively powered knee and ankle ...

    STTR Phase II 2010 National Science Foundation
  2. STTR Phase I:Structural properties of carbon nanotube polymer composites

    SBC: BOULDER NONLINEAR SYSTEMS, INC.            Topic: MM

    This Small Business Technology Transfer Phase I project will develop a new system for fabrication and manipulation of carbon nanotube (CNT) composites. The system will use holographic optical trapping (HOT) with a spatial light modulator (SLM) and a new form of nano-controlled photo-polymerization. This tool will allow the creation of a new class of carbon-nanotube polymer composite materials wit ...

    STTR Phase I 2010 National Science Foundation
  3. STTR Phase I: New Manufacturing Techniques to Produce High Quality Thin Films of Inherently Conducting Polymer Nanofibers Over a Large Area

    SBC: Fibron Inc.            Topic: MM

    This Small Business Technology Transfer (STTR) Phase I project aims to develop a manufacturing process that can coat a variety of substrates with uniform thin films of inherently conducting polymer (ICP) nanofibers over a large area. Traditionally, these nanostructured organic materials are difficult to process into thin films covering a large area, which has limited the commercial applicability ...

    STTR Phase I 2010 National Science Foundation
  4. Exploiting the Mating Phenotype of Chlamydomonas reinhardtii to Enhance Harvesting in Large-Scale Oil Production from Algae

    SBC: KENT SEATECH CORPORATION            Topic: A10

    This STTR Phase I project proposes to develop and establish a novel clumping (flocculation) strain of algal using an engineered extracellar protein that can be induced. The overarching goal is to provide the industry with a novel, energy efficient, and cost effective tool to dewater microalgae. What are the broader/commercial impacts of the proposed project? The broader/commercial impact of the p ...

    STTR Phase I 2010 National Science Foundation
  5. STTR Phase I: Design, Fabrication and Characterization of Ferroelectric Nanoparticle Doped Liquid Crystal/Polymer Composites

    SBC: MEADOWLARK OPTICS, INC.            Topic: MM

    This Small Business Technology Transfer Phase I project will address the critical need for low driving voltage, adaptive materials providing large phase retardation (for ultraviolet, visible, and infrared wavelengths) within a sub-millisecond time frame. Two technologically innovative tasks will be pursued in parallel and then merged, resulting in the creation of a new class of optical materials - ...

    STTR Phase I 2010 National Science Foundation
  6. STTR Phase I: Low Cost, High Efficiency Photovoltaics

    SBC: Ampulse Corporation            Topic: MM

    This Small Business Technology Transfer (STTR) Phase I project aims to develop roll-to-roll processing of highly efficient, thin film photovoltaics on inexpensive polycrystalline substrates. The innovation lies in an architecture that yields near-single-crystalline thin films even on polycrystalline substrates. This innovation will be combined with the benefits of hot wire chemical vapor deposit ...

    STTR Phase I 2010 National Science Foundation
  7. STTR Phase I: Post-Peltier Thermoelectrics for Power Generation

    SBC: ThermoDynamic Films LLC            Topic: MM

    This Small Business Technology Transfer (STTR) Phase I project will develop a new class of heat engines that can be used for electrical generation. These heat engines, which are based on thin films of pyroelectric materials, perform all the functions of conventional thermoelectrics, but are not constrained by the competition between thermal and electrical conductivity that has hampered the develop ...

    STTR Phase I 2010 National Science Foundation
  8. STTR Phase I: Bistable Electroactive Polymers for Refreshable Braille Displays

    SBC: Polyradiant            Topic: MM

    This Small Business Technology Transfer Program Phase I project aims to develop a refreshable Braille display for the blind. Existing Braille technologies require complicated mechanical designs that are bulky and too expensive for personal use. A new technology based on a new smart material (bistable electroactive polymer) will be developed to enable a Braille dot array on a thin flat panel. The ...

    STTR Phase I 2010 National Science Foundation
  9. STTR Phase I: Up-Cycling: Waste Acid for Green Products

    SBC: Clear Carbon Innovations            Topic: MM

    This STTR Phase I project will develop a process to produce silica products from the waste stream of a patent pending activated carbon manufacturing process (carbonxt process). The project focuses on using the silica for Silica-Titania Composites but would also take into account markets that employ precipitated or gel silica which would have differing properties than the silica used in Silica-Tit ...

    STTR Phase I 2010 National Science Foundation
  10. STTR Phase I: Low-cost naostructured anti-reflection coatings for solar energy applications

    SBC: CSD Nano            Topic: MM

    This Small Business Technology Transfer (STTR) Phase I project aims to fabricate anti-reflective coatings (ARC) for solar energy applications. The approach is to use a convective and evaporation-induced assembly to deposit organized nanostructures and create sub-wavelength quasi repeating structures at lower cost than the repeating structures from photolithography. In this project, a Microreacto ...

    STTR Phase I 2010 National Science Foundation
US Flag An Official Website of the United States Government