You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY21 is not expected to be complete until September, 2022.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. Thin Film Deposition of Highly Conductive Metals for Sensor Applications- Phase II

    SBC: Summit Information Solutions, Inc.            Topic: A17AT001

    Deposition of highly conductive, continuous thin film metals has proven to be a significant challenge. There are several techniques that allow deposition of these metals, but their application is limited to planar surfaces and only offer complete line of sight deposition. During a recent Phase I STTR project, Summit Information Solutions, Inc. (Summit), in partnership with University of Alabama in ...

    STTR Phase II 2019 Department of DefenseArmy
  2. A Novel, Microscale, Distributable Sensor Technology for Ionizing Radiation

    SBC: CFD Research Corporation            Topic: DTRA14B004

    Terrorist use of radioactive nuclear materials via nuclear and/or radiological dispersion devices (dirty bombs) is a serious threat. Therefore, it is crucial to detect proliferation of nuclear material. Critical challenges include: (a) high sensitivity detection of signature emissions from radioactive isotopes, and (b) cost-effectiveness for deployment of sensor networks across large storage facil ...

    STTR Phase II 2019 Department of DefenseDefense Threat Reduction Agency
  3. Rapid Prototyped 3D Printed Filters for CW Agent Protection

    SBC: TDA Research, Inc.            Topic: A18BT018

    Defense against chemical weapons is a critical DoD requirement. An effective defense requires the development of unique respirator systems that prevent inhalation of chemical warfare (CW) agents. In addition, the protective equipment exposed to CW agents must not pose a residual hazard after use in the battlefield. Existing respirator canisters remove CW agents, but they do not self-decontaminate ...

    STTR Phase I 2019 Department of DefenseArmy
  4. Printable Radar Absorbent Materials/Structures for Soldier Uniforms & Other Army Textiles

    SBC: Luna Innovations Incorporated            Topic: A18BT023

    Portable Advanced Battlefield and Ground surveillance radar can now provide effective detection of small targets, posing challenges for troop movement and stealth missions. Radar absorbent strategies have been achieved in composites and larger textile objects, but effective light-weight solutions for current operational clothing and individual equipment systems such as uniforms, knapsacks and body ...

    STTR Phase I 2019 Department of DefenseArmy
  5. Design of Easy-To-Use Structural Alloy Feedstocks for Additive Manufacturing

    SBC: Elementum 3D, Inc.            Topic: A18BT003

    There is a need for easy-to-use, versatile alloys for additive manufacturing that print consistently regardless of the specific process or machine, or the metallurgical and manufacturing knowledge of the user. Such capability is especially critical for soldiers to be able to make every day items on demand in the theater of war. Toward meeting this need, recent successes developing high performance ...

    STTR Phase I 2019 Department of DefenseArmy
  6. High Linearity RF Amplifiers from Carbon Nanotubes

    SBC: Carbon Technology, Inc.            Topic: A18BT004

    The Key to further improving the data rate in data communication while minimizing the power consumption is to improve the linearity of a power amplifiers in the system. Carbon Nanotube (CNT) offer intrinsically linear behavior, but to realize advanced linearity in a practical device requires high quality CNT material, and a fabrication process that can take the full advantage of the superior prope ...

    STTR Phase I 2019 Department of DefenseArmy
  7. Carbon Nanotube Based Monolithic Millimeter-wave Integrated Circuits

    SBC: ATOM INC            Topic: A18BT004

    In this project, we propose to develop a high-performance carbon nanotube (CNT) based millimeter-wave transistor technology and demonstrate monolithic millimeter-wave integrated circuits (MMICs) based on this technology with improved power efficiency, linearity, noise and dynamic range performance over existing GaAs, SiGe and RF-CMOS technologies. The goal of this topic is to leverage Professor St ...

    STTR Phase I 2019 Department of DefenseArmy
  8. Membraneless Water Purification via Continuous, Self-Contained, Vacuum-Assisted Diffusiophoresis

    SBC: MAINSTREAM ENGINEERING CORPORATION            Topic: A18BT005

    We propose the development of a membraneless water purification system using continuous, self-contained, vacuum-assisted diffusiophoresis. Using diffusiophoresis allows the system to clean water contaminated with particulates and bacteria without membranes or filters, while producing a stream of fresh, drinkable water. The system will operate using only electricity supplied by portable batteries/s ...

    STTR Phase I 2019 Department of DefenseArmy
  9. Deep Ultraviolet Light Sources for Water Purification and Surface Sterilization

    SBC: TRIPLE RING TECHNOLOGIES, INC.            Topic: A18BT006

    This proposal is related to the development of high efficiency ultraviolet (UV) light emitting devices (LEDs) operating at 265 nm and 219 nm, which have the potential to replace conventional mercury lamps for many applications including dinsinfection and water purification. To date, the wall-plug efficiency of commercial LEDs operating at 265 nm is in the range of 2-3%, which has been limited by t ...

    STTR Phase I 2019 Department of DefenseArmy
  10. Runnable Environment for Team Effectiveness and Assessment Metrics (re-TEAM)

    SBC: Modus Operandi, Inc.            Topic: A18BT008

    The most critical component of any modern enterprise is effective use of its human resources. The rise of productivity-boosting applications and wearable sensors has provided individual users with data-driven insights into their own effectiveness. Despite these advancements there has not been a corresponding rise in tools for evaluating and improving the effectiveness of teams as a whole. New wear ...

    STTR Phase I 2019 Department of DefenseArmy
US Flag An Official Website of the United States Government