Award Data

Metallic additive manufacturing (AM) is an attractive technology for the production of lethality test articles due to the potential for significantly reduced lead time and manufacturing cost. However, in order to be effective in providing accurate lethality data, the properties of the AM material have to match closely the properties of conventionally manufactured alloys found in real threat target ...

The proposed research and technical objectives in this project deal with computerized automatic delayering and polishing system that would be applicable to both commercial and government semiconductor device research and development with applications including Failure Analysis (FA), Fault Isolation (FI), and Reverse Engineering (RE) of semiconductor microelectronic devices. This project could hel ...

Using a combination of parallel processing and explorative visualization, a new and exciting solution for high-performance visual analysis of large multidimensional data is proposed. Steady volume flows are selected to demonstrate the strategy, methodology, techniques, and functionalities. Virtual Reality (VR) and Augmented Reality (AR) platforms will be adopted to unleash the power of explorative ...

High G Aerodynamic Controls | Approved for Public Release 18-MDA-9707 (3 Jul 18)

This proposed STTR program addresses the challenge of developing advanced absorptive baffles to minimize stray and reflected light across the visible and infrared wavebands for exo-atmospheric optical sensors and seeker telescopes. To achieve this goal Faraday Technology and Pacific Northwest National Laboratory will develop electrochemically textured pyramidal surfaces with CNT black coatings as ...

Development of novel propulsion systems in the past two decades has focused almost exclusively on cryogenic boost-phase systems (LOX/LH2, LOX/LCH4, and LOX/RP-1) for launchers and uppers stage engines, and Attitude / Reaction Control Systems (A/RCS) for in-space applications using green monopropellants such AF-M315E or LMP-103S. Basic research and development of scalable, non-toxic, non-cryogenic, ...

he Storable Clean Ethane-ethylene Nitrous Engine (SCENE) is a proposed technology designed to provide upper stages and spacecraft with non-toxic, liquid, non-cryogenic, high-performance propulsion with an Isp on the order of 300 seconds. The propellant components are stored as liquids under their saturated vapor pressures. With the SCENE, nitrous oxide is used as an autogenously pressurized oxidiz ...

Metallic additive manufacturing (AM) is an attractive technology for the production of lethality test articles due to the potential for significantly reduced lead time and manufacturing cost.However, in order to be effective in providing accurate lethality data, the properties of the AM material have to match closely the properties of conventionally manufactured alloys found in real threat targets ...

Reservoir Labs and Johns Hopkins University will develop alternative numerical solution techniques that improve computational loading, data storage, and data integrity for rocket vehicle trajectory modeling in MDA federated simulations.The objective of this program is to develop new techniques for trajectory propagation that are more suited for use in federated simulations than traditional methods ...

Magnesium alloys have 35% lower density compared to aluminum, with improved temperature stability compared to high strength aluminum.They can also be fabricated with minimum gauge thicknesses considerably thinner than fiber composites, and are weldable, with much higher impact resistance.Traditional magnesium alloys, however, have had lower strengths than more developed aluminum alloys.Powder meta ...