Award Data

N/A

The 3D-Flow Processor system is a new concept in very fast, real-time system architectures. The throughput of this system can reach up to 100 millin frames/sec, yet unlike currently available systems of comparable speed, it is fully programmable and extremely flexible. Algorithms for processing information from the input of multiple sensor can easily be implemented on a 3D-Flow system to achiev ...

THERMOPLASTIC ELASTOMER (TPE) BY INJECTION MODLING OFFERS AN ALTERNATE METHOD FOR FORMING CHEMICAL PROTECTIVE GLOVES A SOCMPARED TO THE CONVENTONAL DIP PROCESS USING BUYTL RUBBER SOLUTIONS. THE ADVENT OF VARIOUS TPES WITH OLEFINIC, STYRENIC, URETHANE, ENGINEERING RESINS AND ALLOYS AND BLENDS OFFER THE ADVANTAGE OF INJECTION MODLING PRODUCTS WHICH HAVE BEEN CONVENTIONALLY MADE BY ELASTOMER COMPOUND ...

This proposal is directed at creating discontinuous unidirectional composite from continuous unidirectional prepreg. The process, Selectively-Discontinuous-Fiber (SDF), introduces micro-cuts in preimpregnated unidirectional materials at specified locations. This process will allow unidirectional composite prepreg to be used for the fabrication of complex-compound components that have be ...

Standard U.S. Navy fiber optic assemblies require that the fiber be bonded to the connector using an adhesive that is labor intensive and heat controlled (MIL-A-24792). Advanced Material Systems (AMS) proposes a study that could solve this problem through the development of an adhesive system that would cure at room temperature in less that 3 minutes and yet meet all of the in-service req ...

Current fire fighting training methods are possibly lacking maximum effectiveness due to increasing safety and environmental regulation. Additionally, performance measurement in large classes becomes difficult unless trainees have identical training scenarios and evaluations. This proposal details the analysis of current training methods and subsequent emulation of them using virtual reality (VR ...

THE PROJECT WILL DEVELOP A NOVEL MINIATURE PULSE WIDTH MODULATED POWER DRIVER FOR ACTUATORS, I.E. DC MOTOR. THE POWER DRIVER WILL DELIVER 50 AT 50VDO IN A DOUBLE INON PACKAGE. THIS COMPACT DESIGN CAN ONLY BE ACHIEVED THROUGH THE INNOVATIVE COMBINATION OF MODER POWER SEMICONDUCTOR TECHNOLOGIES, PROPRIETORY CIRCUIT DESIGN, AND STATE-OF-THE-ART PACKAGING TECHNOLOGY WHICH UTILIZES NEW HEAT CONDUCTIVE ...

The AES International Corporation (AESI) of College Station, Texas, in concert with Texas A&M University personnel, can build an airborne ground-penetrating radar system to detect land mines from an Unmanned Airborne Vehicle (UAV). The radar itself will be a totally new and fully airworthy flight demonstration unit, the principles and characteristics of which will be conceptually similar to two p ...

AMI utilizes a technique known as the "ribbon wind" approach to manufacture infrared fiber image bundles. The ribbon wind approach provides a unique opportunity to manufacture relatively low cost, large format, medium resolution infrared fiberoptic image bundles for industrial, commercial and military applications. Indeed, this approach has been applied successfully by numerous fiberoptic manufa ...

COMMERCIAL AND GOVERNMENT SPACE TRANSPORTATION SYSTEMS DEPEND ON GROUND SUPPORT FOR NAVIGATION. THE GROUND SOLUTION CAN BE COSTLY AND MAY PROVIDE LESS ACCURACY THAN NEEDED. A GPS-BASED REAL-TIME AUTONOMOUS SPACECRAFT NAVIGATION SYSTEM IS PROPOSED. AN ALGORITHM WILL BE DEVELOPED WHICH COMBINES GPS-DERIVED POINT POSITION ESTIMATES WITH A PROPAGATED A PRIORI POSITION ESTIMATE. THE POINT POSITIONS ARE ...