Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. Intellifusion- A System for Augmenting Inductive Loop Vehicle Sensor Data with SPAT and GrID (MAP) via Data Fusion

    SBC: Harmonia Holdings Group, LLC            Topic: 111FH2

    Our goal is to create a demonstrable prototype system at the end of Phase I which fuses IntelliDrive (SM) data with data from traditional inductive loop detectors and uses this data in a modified NEMA TS2 traffic signal controller within eTEXAS Model for Intersection Traffic to reduce traffic delay at intersections.  Our work will improve the safety of intersections and improve the mobility of traffic through adaptive traffic control which uses data produced by IntelliFusion, the product of our research.   The process of data fusion involves merging data obtained fr

    SBIR Phase I 2011 Department of Transportation
  2. Traffic Intersection Simulation of IntelliDrive, J2735, and DSRC/WAVE with eTEXAS

    SBC: Harmonia Holdings Group, LLC            Topic: 101FH3

    We accelerate the maturity of IntelliDrive applications and unlock the storehouse of modeling detail in TEXAS to organizations building IntelliDrive applications J2735/Dedicated Short Range Communication (DSRC) signal controllers and on-board IntelliDrive systems. We add four SAE J2735 messages: SPAT MapData Basic Safety Messages and Signal Request Message for emergency vehicle preemption. Mapping ...

    SBIR Phase II 2011 Department of Transportation
  3. Portable Active Thermographic Coating Inspection System

    SBC: Fuchs Consulting Inc            Topic: 091FH2

    This proposal seeks to produce a unique thermographic coating inspection system that is customized for the inspection of bridge coatings.  The system uses active thermography where IR sources are used to provide controlled heating to a coating system.  The presence of a defect in a coating system will result in differences in heat flow, which can be imaged with an infrared camera.  ...

    SBIR Phase II 2011 Department of Transportation
  4. Long Term Behavior, Failure Analysis & In-Service Testing of Composite Cylinders

    SBC: Texas Research Institute, Austin, Inc.            Topic: 101PH1

    TRI proposes to develop reliable methodology and protocols for in-service inspection,recertifying and retiring DOT COPVs to maximize service life while ensuring personnel safety. This method must be sufficiently robust to prevent in-service failures, while being straightforward and affordable enough to be conducted at cylinder recertification facilities. To accomplish this with a high degree of co ...

    SBIR Phase I 2011 Department of Transportation
  5. Development of a non-destructive, quantitative residual stress assessment tool

    SBC: Generation 2 Materials Technology Llc            Topic: 111PH2

    A nondestructive tool will be developed to quatitatively assess residual stress in pipelines from the exterior and through coatings. Residual stress is a critical factor that determines the cracking susceptibility of pipeline steels, but existing methods for measuring mechanical damage in pipeline steels are incapable of quantifying the residual stress levels. A larger gouge or dent does not nec ...

    SBIR Phase I 2011 Department of Transportation
  6. DYNAMIC GPS ATTITUDE DETERMINING SYSTEM FOR MARINE APPLICATIONS

    SBC: Adroit Systems, Inc.            Topic: N/A

    A 3-DIMENSIONAL ATTITUDE SENSOR WHICH USES GPS CARRIER PHASEINTERFEROMETRY IS PROPOSED FOR ANALYSIS AND CONCEPT TESTING IN PHASE I, AND PROTOTYPING IN PHASE II. THE RESULTING SENSOR WILL BE ACCURATE AT ANY LATITUDE. ADROIT SYSTEMS PROPOSES TO ENHANCE ITS SUCCESSFUL 2-DIMENSIONAL, STATIC GPSATTITUDE DETERMINING SYSTEM (ADS) SO THAT IT WILL OPERATE UNDER DYNAMIC CONDITIONS WHILE MEASURING 3-DIMENSIO ...

    SBIR Phase II 1992 Department of Transportation
  7. AN INNOVATIVE OBSTACLE DETECTION SYSTEM FOR HIGH SPEED GUIDED GROUND TRANSPORTATION

    SBC: Adroit Systems, Inc.            Topic: N/A

    AN INNOVATIVE OBSTACLE DETECTION SYSTEM BASED ON A RAIL-GUIDED PROPELLER-DRIVEN POD CONTAINING A MICROWAVE RADAR SENSOR IS PROPOSED. THE SENSOR POD WILL TRAVEL A FEW MILES AHEAD OF THE HIGH SPEED TRAIN OR MAGLEV VEHICLE, DETECT POTENTIAL OBSTACLES, AND ENACT AN APPROPRIATE WARNING OR AVOIDANCE PROCEDURE. THE PROPOSED OBSTACLE DETECTION SYSTEM HAS MANY HIGHLY DESIRABLE FEATURES INCLUDING: A VERY LO ...

    SBIR Phase I 1992 Department of Transportation
  8. SHIP MANEUVERING SIMULATION FOR PASSAGE PLANNING AND TRAINING

    SBC: Advanced Marine Enterprises,            Topic: N/A

    THE ULTIMATE OBJECTIVE OF THIS RESEARCH EFFORT IS THE DEVELOPMENT OF A SHIP MANEUVERING SIMULATION SOFTWARE PACKAGE FOR SHIPBOARD USE IN MANEUVERING ASSESSMENT, PASSAGE PLANNING AND TRAINING. THE SOFTWARE MUST OPERATE IN A STAND ALONE MODE AND/OR INTEGRATED WITH THE SHIP'S NAVIGATION AND CONTROL SYSTEM. THE PHASE 1 EFFORT INCLUDES THE INITIAL DETERMINATION OF THE REQUIREMENTS FOR THIS SOFTWARE PAC ...

    SBIR Phase I 1992 Department of Transportation
  9. GPS-BASED AUTONOMOUS SPACE NAVIGATION

    SBC: Arrowsmith Technologies Inc            Topic: N/A

    COMMERCIAL AND GOVERNMENT SPACE TRANSPORTATION SYSTEMS DEPEND ON GROUND SUPPORT FOR NAVIGATION. THE GROUND SOLUTION CAN BE COSTLY AND MAY PROVIDE LESS ACCURACY THAN NEEDED. A GPS-BASED REAL-TIME AUTONOMOUS SPACECRAFT NAVIGATION SYSTEM IS PROPOSED. AN ALGORITHM WILL BE DEVELOPED WHICH COMBINES GPS-DERIVED POINT POSITION ESTIMATES WITH A PROPAGATED A PRIORI POSITION ESTIMATE. THE POINT POSITIONS ARE ...

    SBIR Phase I 1992 Department of Transportation
  10. EMBEDDED PAVEMENT STRESS SENSORS CONTAINING PIEZOELECTRIC COMPOSITES

    SBC: Fiber Materials, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1992 Department of Transportation
US Flag An Official Website of the United States Government