List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until June, 2020.

  1. DEVELOPMENT OF A HIGHLY RELIABLE COST-EFFECTIVE CONTINUOUS MCONTINUOUS EMISSION MONITOR

    SBC: ADA Technologies, Inc.            Topic: N/A

    N/A

    SBIR Phase I 1985 Environmental Protection Agency
  2. Recycling Process for Poultry Litter

    SBC: Adherent Technologies, Inc.            Topic: N/A

    Not Available We propose to investigate the feasibility of manufacturing a simple waveguide laser that would demonstrate all of the qualities of fiber lasers while utilizing the simple pumping scheme of an side pumped Nd:YAG laser. The Phase I effort will involve modeling of the system and Phase II will be construction of a prototype. We will investigate a wound single mode rare earth doped fiber ...

    SBIR Phase I 1999 Environmental Protection Agency
  3. "REDUCTION OF ELECTRONICS INDUSTRY TOXIC AIR EMISSIONS THROUGH THE USE OF A NOVEL VENT GAS SCRUBBER"

    SBC: Advanced Technologies/Laboratories Intl            Topic: N/A

    THE RAPID GROWTH OF THE AMERICAN MICROELECTRONICS INDUSTRY HAS SPAWNED NEW ENVIRONMENTAL PROBLEMS ASSOCIATED WITH THE PROCESSES USED TO PREPARE SEMICONDUCTOR CHIPS, THE KEY COMPONENTS OF SOPHISTICATED ELECTRONIC DEVICES. MOST OF THESE PROBLEMS HAVE BEEN IGNORED BECAUSE RELATIVELY LOW VOLUMES OF CHEMICALS ARE ASSOCIATED WITH SEMICONDUCTOR FABRICATION. HOWEVER, THE EXCEPTIONALLY HIGH TOXICITY OF THE ...

    SBIR Phase II 1988 Environmental Protection Agency
  4. N/A

    SBC: Advanced Fuel Research, Inc.            Topic: N/A

    N/A

    SBIR Phase II 1999 Environmental Protection Agency
  5. Gas Turbine Engine Performance Monitor for Reduce Emissions

    SBC: Advanced Fuel Research, Inc.            Topic: N/A

    Not Available The intent of this research is to develop an advanced nozzle for mixing and reacting iodine (I (sub 2) or I) and singlet-delta oxygen [O (sub 2) ((sup 1) increment)] flows in COIL devices. The ultimate goal is to develop a more efficient COIL. Specific avenues for the proposed research are: (1) Current COIL nozzles typically inject a mixture of diluent gas and molecular iodine into ...

    SBIR Phase I 1999 Environmental Protection Agency
  6. ELECTROTHERMAL REFORMING OF HAZARDOUS ORGANICS AND WATER- SOLUBLE WASTES

    SBC: A1-chem Fuels Inc.            Topic: N/A

    A1-CHEM FUELS, INC. HAS A PATENT PENDING FOR AN ELECTROTHER-MAL DEVICE TO PRODUCE MEDIUM TO HIGH BTU FUEL GAS FROM WASTEHYDROCARBON SOURCES. THIS UNIT OPERATES BY PRODUCING A HIGH-VOLTAGE ALTERNATING CURRENT ELECTRIC DISCHARGE ACROSS THE INTERFACE BETWEEN A WASTE HYDROCARBON AND WATER. THE EXTREMELY HIGH TEMPERATURE WITHIN THE ELECTRICAL DISCHARGE IS SUFFICIENT TO CAUSE LOCALIZED FAST PYROLYSIS OF ...

    SBIR Phase II 1988 Environmental Protection Agency
  7. A Non-Cryogenic Tunable Diode Laser Monitor for On-Road Vehicle Emissions

    SBC: Aerodyne Research, Inc.            Topic: N/A

    Not Available This proposal addresses the problem of placement or rearrangement of antennas and ground stations in a satellite support network that will provide good network performance at low cost. The problem is motivated by the economic concerns associated with consolidation of satellite support network resources. The solution to this problem is extremely complex and requires juggling many dif ...

    SBIR Phase I 1999 Environmental Protection Agency
  8. Environmental Monitoring Comapct Raman Lidar System Utilizing APD Array Detectors

    SBC: Radiation Monitoring Devices, Inc.            Topic: N/A

    Not Available We propose to develop a novel, low-cost, amorphous silicon (a-Si:H) based modular to be integrated with a spacecraft thermal blanket for an auxiliary spacecraft power system. This new design is unique from ECD's present multi-junction module design in that an ultralight kapton substrate material and a monolithic cell interconnect design will be used which will allow for potential en ...

    SBIR Phase I 1999 Environmental Protection Agency
  9. Polymer-Based Competitive Flow Sensor Detects Contaminants in the Field

    SBC: American Research Corporation of Virginia            Topic: N/A

    Not Available NEA Electronics, Inc. (NEA) is a manufacturer of electro-mechanical products, specializing in the development of innovative hold down and release mechanisms for the aerospace industry. NEA has designed and manufactured two prototype release mechanisms with unique capabilities. The Model 9111 rod release mechanism is simple, highly reliable, light weight and cost effective. It is cap ...

    SBIR Phase I 1999 Environmental Protection Agency
  10. Hydrothermal/Thermal Decompostion of Perchlorate

    SBC: Applied Research Associates, Inc.            Topic: N/A

    Not Available The proposed effort utilizes the experience gained from over 20 years of work performed by the Optical Sciences Company in the area of atmospheric propagation, wavefront sensing and adaptive optics technology to develop new wavefront compensation algorithms that advance the state-of-the-art and provide new improved levels of performance when propagation through the turbulence of int ...

    SBIR Phase I 1999 Environmental Protection Agency

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government