You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY20 is not expected to be complete until September, 2021.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

  1. CORC; Cable Based High Field Hybrid Magnets for Future Colliders

    SBC: Advanced Conductor Technologies LLC            Topic: 26b

    "The next generation of very high field accelerator magnets (20 T or more) are expected to be made with high-temperature superconductors (HTS) along with conventional low-temperature superconductors (LTS) to reduce cost. The operation and protection of these magnets becomes very challenging particularly if the HTS coils are made with the tapes and operate at a much lower current than the LTS coils ...

    STTR Phase II 2018 Department of Energy
  2. Scaleup of a Combined Spray Pyrolysis and Fluidized-bed Reactor Method for the Production of High Performing Layered Nickel- rich Cathode Materials as a Continuous Process

    SBC: HAZEN RESEARCH, INC.            Topic: 14a

    To increase the utilization of electric vehicles, the US Department of Energy is seeking to reduce the cost of electric vehicle batteries to less than $125/kWh by 2022. To achieve this goal, the costs of cathode materials, which account for approximately 30% of the cost of vehicle batteries, must be reduced significantly. To address the challenge of lowering the costs of advanced lithium battery c ...

    STTR Phase II 2018 Department of Energy
  3. Small Team Command, Control, Communications and Situational Awareness (C3SA), SOCOM08-001

    SBC: CEEBUS TECHNOLOGIES, LLC            Topic: SOCOM08001

    SOF combat swimmers have a need for the continuous monitoring of each others relative position while diving and for the capability of being able to communicate with each other to help establish a common operational picture (COP).The C3SA system was previously developed under SBIR Topic SOCOM08-001 thru the receipt of both Phase I and Phase II SBIR awards.The C3SA established a stand-alone network ...

    STTR Phase II 2018 Department of DefenseSpecial Operations Command
  4. Multi-Channel Readout IC for Nuclear Physics Experiments

    SBC: Alphacore, Inc.            Topic: 24b

    Readout integrated circuits (ROICs) for Nuclear Physics science experiments are very expensive and generally have performance flaws that make it difficult to collect all the data that researchers seek from the detectors that they use in their facilities. General statement of how this problem or situation is being addressed. Alphacore is developing multi-channel ROICs that have high performance, ad ...

    STTR Phase II 2018 Department of Energy
  5. A Concrete Additive Manufacturing Process for Fixed and Floating Wind Turbine Foundations and Towers

    SBC: JC Solutions            Topic: 14b

    Tall towers and foundations for modern offshore and land-based wind turbines are too large to transport over roads or rail due to their extremely large dimensions. Existing “one-off” on-site construction methods are too expensive, and are too slow for manufacturing foundations and towers in the large numbers needed, especially for offshore components manufactured in ports with limited lay-down ...

    STTR Phase I 2018 Department of Energy
  6. Development of a Connected and Automated EV with 4 In-Wheel Motors

    SBC: Local Motors, Inc.            Topic: 13c

    Local Motors (https://localmotors.com/) is an automotive OEM that is currently developing a connected and automated vehicle for various shuttle bus applications. The OlliTM vehicle is intended to be an electric vehicle driven by four in-wheel electric motors that allow for independent actuation and control for increased traction stability and operation efficiency. This electric vehicle shuttle des ...

    STTR Phase I 2018 Department of Energy
  7. Low-cost, time-resolved chemical characterization of atmospheric aerosols

    SBC: Aerosol Devices Inc.            Topic: 23b

    Currently the chemical composition of atmospheric particulate matter is measured either by off-line analyses of time-integrated filter samples, or by in-situ instruments requiring near-constant operator oversight. These measurement approaches result in sparse or limited data coverage. Despite the critical role of composition on the health and environmental impacts of particulate matter, there exis ...

    STTR Phase I 2018 Department of Energy
  8. All Fiber Approach to Locking Carrier-Envelope Phase of Ultrafast Fiber Lasers

    SBC: N.P. PHOTONICS, INC.            Topic: 25b

    Due to their advantages, fiber lasers have become major platforms for high average and peak power ultrafast laser sources. Coherent beam combining of many mode- locked fiber lasers is a very promising route to achieving ultrafast laser sources with kW-level or higher average power required for DOE accelerator applications. Scalable, robust, low-cost, and low-noise carrier envelope phase (CEP) lock ...

    STTR Phase I 2018 Department of Energy
  9. Low-cost and Flexible Transparent Electrodes Based on Ag–ZTOF (Zn–Sn–O–F) Amorphous Composites Through Ink-jet Printing

    SBC: HAZEN RESEARCH, INC.            Topic: 09b

    Sn-doped In2O3 (ITO) is the industry standard and most widely used transparent conducting electrode (TCE) because of its good electrical and optical properties. However, ITO has a number of disadvantages: ITO is not a suitable TCE for next-generation, high-efficiency, flexible OLEDs, because of its inappropriate work function, difficulty in creating desired patterns, low stability, delaminantion d ...

    STTR Phase I 2018 Department of Energy
  10. Scalable Polymerized Metal-Organic Frameworks with CO2-philic Rubbery Polymers for Membrane CO2/N2 Separation

    SBC: Helios-NRG, LLC            Topic: 18d

    As fossil fuels continue to serve as a major energy source, CO2 capture for utilization or sequestration is the only option to mitigate the CO2 emissions to the environment. However, the separation of CO2 from flue gas is an extremely costly proposition with existing technologies. Advanced membrane technology may address this challenge, if new membranes with CO2 permeance of 4,500 gpu and CO2/N2 s ...

    STTR Phase I 2018 Department of Energy
US Flag An Official Website of the United States Government