List

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for the given year is not complete until April of the following year. Annual Reports data is a snapshot of agency reported information for that year and hence might look different from the live data in the Awards Information charts.

  1. HIGH THERMAL CONDUCTIVITY SINTERED A1N

    SBC: Technology Holding, LLC            Topic: N/A

    ALUMINUM NITRIDE (A1N) IS AN IMPORTANT CANDIDATE MATERIAL FOR ADVANCED PACKAGING OF INTEGRATED CIRCUITS AS A HIGH THERMAL CONDUCTIVITY ALTERNATIVE TO BERYLLIUM OXIDE THAT COULD POTENTIALLY BE MADE AVAILABLE AT LOW COST. MUCH EXPERIMENTAL WORK HAS BEEN CONDUCTED ON A1N, BUT THE TECHNOLOGY STILL HAS NOT REACHED A LEVEL SUITABLE FOR APPLICATION. ADVANCES ARE NEEDED ESPECIALLY IN SINTERING TECHNOLOGY ...

    SBIR Phase II 1988 Department of Energy
  2. NEW LOW THERMAL EXPANSION STRUCTURAL CERAMICS

    SBC: Technology Holding, LLC            Topic: N/A

    OVER THE PAST FEW YEARS, A NEW FAMILY OF MATERIALS CALLED NZP (NAZR2 (PO4)3 AND ITS ANALOGS) HAS BECOME WELL KNOWN FORITS LOW THERMAL EXPANSION BEHAVIOR. RECENTLY, IT HAS BEEN SHOWN THAT ZR4 (PO4)6 AND SRZR4(PO4)6 HAVE OPPOSITE ANISOTROPY IN THERMAL EXPANSION AS WELL AS OPPOSITE BULK THERMAL EXPANSION AND THAT THEIR SOLID SOLUTION RESULTS IN LOWER ANISOTROPY AND NEAR ZERO THERMAL EXPANSION. THESE ...

    SBIR Phase II 1988 Department of Energy
  3. DESIGN, FABRICATION, AND INTERFACE CHARACTERIZATION OF CERAMIC FIBER-CERAMIC MATRIX COMPOSITES

    SBC: Technology Holding, LLC            Topic: N/A

    CERAMIC-MATRIX COMPOSITES WITH OPTIMUM FIBER-MATRIX INTERFACIAL BONDING EXHIBIT HIGH STRENGTHS, FRACTURE TOUGHNESS, AND A DAMAGE-INSENSITIVE FAILURE MODE, AND THEY ARE VASTLY SUPERIOR IN RELIABILITY TO MONOLITHIC CERAMICS. THE DESIGN AND FABRICATION OF THESE COMPOSITES REQUIRE INNOVATIVE TECHNIQUES TO CONTROL, MODIFY, AND CHARACTERIZE THE FIBER-MATRIX BONDING. TWO NOVEL TECHNIQUES FOR MEASURING TH ...

    SBIR Phase II 1988 Department of Energy
  4. A CATALYTIC COMBUSTION GAS ENERGY METER

    SBC: Hart Scientific Inc.            Topic: N/A

    A CATALYTIC COMBUSTION FLOW CALORIMETER FOR THE MEASUREMENT OF NATURAL GAS ENERGY CONTENT WILL BE DEVELOPED AND TESTED. THIS NEW CALORIMETER (GAS ENERGY METER) WILL BE DESIGNED TO BE A PROTOTYPE FOR DEVELOPMENT OF AN INSTRUMENT SUITABLE FOR REMOTE INSTALLATION, AS ACCURATE AS PRESENT LABORATORY CALORIMETERS, OPERABLE CONTINUOUSLY FOR PRECISE ACCOUNTING AT CUSTODY TRANSFER POINTS, AND LOW IN COST. ...

    SBIR Phase II 1988 Department of Energy
  5. A FEASIBILITY STUDY FOR THE PRODUCTION OF SPECIFICATIO-GRADE ASPHALT FROM UTAH TAR SANDS

    SBC: James W. Bunger And Associates            Topic: N/A

    N/A

    SBIR Phase I 1988 Department of Energy
  6. STABLE CARBON ISOTOPE AND RESTRICTION FRAGMENT LENGTH POLY MORPHISM TECHNOLOGIES FOR IMPROVEMENT OF WATER-USE EFFICIEN-CY OF C3 PLANTS

    SBC: Native Plants Inc.            Topic: N/A

    N/A

    SBIR Phase I 1988 Department of Energy
  7. GRAPHITE REINFORCED COPPER ALLOYS FOR FUSION REACTOR APPLICATIONS

    SBC: Technical research Associates, Inc.            Topic: N/A

    THE FIRST WALL STRUCTURE OF FUSION REACTORS WILL BE EXPOSED TO HOT PLASMAS AND HIGH HEAT FLUXES. THIS RESEARCH WILL DETERMINE THE FEASIBILITY OF USING BIDIRECTIONAL GRAPHITE REINFORCEMENT IN COPPER ALLOYS TO PROVIDE A TRANSITION BETWEEN CERAMIC ARMOR (WHICH PROVIDES RESISTANCE TO THE PLASMA ENVIRONMENT) AND A COPPER CONTAINMENT VESSEL WHERE THE HEAT OF REACTION IS EXTRACTED. AFTER REVIEWING THE CU ...

    SBIR Phase II 1988 Department of Energy
  8. IMPROVED REPLACEMENT TECHNOLOGY FOR RFLP ANALYSIS

    SBC: Ceres/npi            Topic: N/A

    N/A

    SBIR Phase I 1988 Department of Health and Human Services
  9. LIGHT EQUALIZATION RADIOGRAPHIC SCREEN/FILM CASSETTE

    SBC: Innovative Imaging Sciences            Topic: N/A

    N/A

    SBIR Phase I 1988 Department of Health and Human Services
  10. PICOLITER LASER-BASED ABSORBANCE AND RI DETECTOR

    SBC: Lee Scientific Inc            Topic: N/A

    CAPILLARY SEPARATION TECHNIQUES PLACE STRINGENT REQUIREMENTSON CHROMATOGRAPHIC DETECTION SYSTEMS. DETECTORS FOR SEPARATION TECHNIQUES, SUCH AS CAPILLARY LIQUID CHROMATOGRAPHY, CAPILLARY SUPERCRITICAL FLUID CHROMATOGRAPHY, AND CAPILLARY ZONE ELECTROPHORESIS, ARE REQUIRED TO MEASURE MINUTE AMOUNTS OF THE ANALYTES. DETECTORS MUST HAVE SUB-NANOLITER CELL VOLUMES TO AVOID EFFICIENCY AND RESOLUTION LOSS ...

    SBIR Phase I 1988 Department of Health and Human Services

Agency Micro-sites

SBA logo
Department of Agriculture logo
Department of Commerce logo
Department of Defense logo
Department of Education logo
Department of Energy logo
Department of Health and Human Services logo
Department of Homeland Security logo
Department of Transportation logo
Environmental Protection Agency logo
National Aeronautics and Space Administration logo
National Science Foundation logo
US Flag An Official Website of the United States Government