Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY19 is not expected to be complete until September, 2020.

  1. Combined Extinction/Fluorescence Absorption Diagnostics for Sprays

    SBC: En'urga Inc.            Topic: 9030163R

    This Phase II project will continue the prototype development of a pharmaceutical spray quality audit system. The spray quality audit system will estimate the planar mass distribution, mass flux, and drop size of pharmaceutical sprays that are used in functional coating applications and inhalers. A prototype tomography system will be designed and fabricated and evaluated using various fluorophore.

    SBIR Phase II 2015 Department of CommerceNational Institute of Standards and Technology
  2. Large-Area, High-Uniformity Photodiodes for Infrared Trap Detectors

    SBC: Amethyst Research Incorporated            Topic: 9020168R

    methyst Research Inc. will design, fabricate and test a high uniformity, large area, low noise infrared trap-detector detector for the 1- 4.5 μm wavelength range. This state of the art detector will have a large area (e.g., 1-1.8 cm diameter active area) with a spatial variability of internal quantum efficiency of less than 0.1 % between 1 μm and 4.5 μm. In addition, the internal quantum effici ...

    SBIR Phase I 2015 Department of CommerceNational Institute of Standards and Technology
  3. Driver Engagement/Status Monitoring Technologies for Vehicle Automation Applications

    SBC: Soar Technology, Inc.            Topic: 151FH1

    With the introduction of Level 2 (L2) vehicle automation technologies, a core challenge facing drivers is to remain engaged in the driving task and aware of the vehicle environment despite not playing an immediate role in the low level driving control loop. To overcome this challenge, SoarTech and its partners, UMTRI and Delphi Automotive, propose to develop DAISY, an innovative vehicle sub-system ...

    SBIR Phase I 2015 Department of Transportation
  4. Research and Development of a Game Based technology and Database to Train Pre-Drivers, Young Drivers, and Older Drivers to Detect Traffic Hazards

    SBC: Quantum Signal LLC            Topic: 132FH2

    Recent research suggests there are opportunities to enhance driver hazard anticipation and avoidance, which could in turn dramatically impact public safety. For example, the fatality rate per 100 million vehicle miles among 16 year old drivers is some ten times higher than it is among those between the ages of 45 and 55. However, hazard-related training has traditionally been difficult to accompli ...

    SBIR Phase II 2015 Department of Transportation
  5. Advanced Rapid Non-destructive test method to determine chemical composition of concrete materials in the field

    SBC: METNA CO            Topic: 122FH2

    NMR offers comprehensive capabilities for quantitative investigation of the chemistry, structure and deterioration conditions of concrete. Single-sided NMR provides opportunities for nondestructive, spatially resolved field evaluation of concrete. A first-generation single-sided NMR system was developed in Phase I project, and its potential for investigation of concrete deterioration mechanisms wa ...

    SBIR Phase II 2015 Department of Transportation
  6. SHARE-System for Human-factors Assessment and Readiness Evaluation

    SBC: Design Interactive, Inc            Topic: 101FA1

      This proposal addresses the development of a System for Human-factors Assessment and Readiness Evaluation (SHARE).  The SHARE system will enable the classification and modeling of the portfolio of technologies being developed under the Next Generation Air Transportation System (NextGen).  It will develop and validate anchors by which to measure and model the maturity of human fact ...

    SBIR Phase I 2010 Department of Transportation
  7. Decision Support Tools for Sustainable Manufacturing

    SBC: BIMCON Inc.            Topic: N/A

    The objective of this proposal is to establish the feasibility of developing an integrated decision support tool that transforms the current time-consuming and reactive (post-design) sustainability assessment into a real-time, proactive approach available in the early phases of product design. This tool, called Sustainability Integrated into Early Design (SIED), will define and capture lifecycle-w ...

    SBIR Phase I 2010 Department of CommerceNational Institute of Standards and Technology
US Flag An Official Website of the United States Government