You are here

Award Data

For best search results, use the search terms first and then apply the filters
Reset

The Award database is continually updated throughout the year. As a result, data for FY24 is not expected to be complete until March, 2025.

Download all SBIR.gov award data either with award abstracts (290MB) or without award abstracts (65MB). A data dictionary and additional information is located on the Data Resource Page. Files are refreshed monthly.

The SBIR.gov award data files now contain the required fields to calculate award timeliness for individual awards or for an agency or branch. Additional information on calculating award timeliness is available on the Data Resource Page.

  1. Tools for Parallel Adaptive Simulation of Multiphase Ballistic Flows

    SBC: SIMMETRIX, INC.            Topic: A15AT002

    This project will provide state-of-the-art predictive capabilities for simulating systems central to advancing the U.S. Army’s modernization priorities related to long-range precision fires and future vertical lift platforms. The goals of the project are to: (1) Produce geometry and meshing technologies that support the modeling and discretization techniques needed to explicitly track evolving/i ...

    STTR Phase II 2019 Department of DefenseArmy
  2. Developing Silicon Nanowire Sensors to Measuring Host-Cell Proteins at a Biomanufacturing Line

    SBC: ADVANCED SILICON GROUP, INC.            Topic: None

    Our biosensor is made of silicon nanowire arrays functionalized with antibodies to measure the concentration of specific proteins. In this grant we will take a sensor that has been demonstrated for use in measuring a set of generic host cell proteins and we will apply the sensor to measure a set of proteins for a specific cell line. In doing so, we will demonstrate the utility of our sensor to be ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  3. Dual Plane 3D Compton Scattering Imager with Pixelated CZT Detectors for 1-10MeV Gamma Ray

    SBC: H3D INC            Topic: None

    Phase I has proven that the current setup achieves better than 8mm spatial resolution for 2.2MeV prompt gammas. However, 1mm spatial resolution presents a significant challenge for the current setup due in part to limited timing resolution and count rate. A new analog ASIC will be developed to replace the current analog ASIC that will have better timing resolution and deliver higher count rates. I ...

    SBIR Phase II 2019 Department of CommerceNational Institute of Standards and Technology
  4. Compressive Spectral Video in the LWIR

    SBC: PHYSICAL SCIENCES INC.            Topic: A13AT015

    Physical Sciences, Inc. and Colorado State University will advance the technical maturity of the Compressive Sensing Hyperspectral Imager (CS-HSI) platform. The CS-HSI operates in the longwave infrared (LWIR) spectral range with a single-pixel architecture for low-cost, standoff wide area Early Warning of chemical vapor plumes. The motivation for applying CS to LWIR HSI is to eliminate the high-co ...

    STTR Phase II 2019 Department of DefenseArmy
  5. Advanced Instrumentation for Non-Nulling Stack Velocity Testing

    SBC: AIRFLOW SCIENCES CORP            Topic: None

    Industrial facilities, manufacturing plants, and electric power plants that burn fossil fuels exhaust the combustion products to atmosphere through their smokestacks. Stack pollutant emissions are quantified using manual testing methods developed in the 1960s, which are prone to error if non-axial flow exists in a stack.Recently, NIST has been working on an improved technique of performing 3D flow ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  6. Development of a Neutron-based Nondestructive Test Method for Concrete Petrography and Chemical Analysis

    SBC: TOURNEY CONSULTING GROUP, LLC            Topic: None

    To evaluate the technical feasibility of prompt gamma neutron activation (PGAA) as an alternative to a set of standard destructive tests of concrete petrography including aggregate type, water/cement ratio, aggregate/binder ratio, density, chloride content and chloride bulk diffusion constant; and to determine the specifications for the design of a dedicated commercial laboratory-based PGAA facili ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  7. Nanomachine Device for Semiconductor Process Control Monitoring

    SBC: XALLENT INC.            Topic: None

    Conventional characterization and test methods are increasingly ineffective when applied to structures less than 100 nanometers, causing challenges across R&D, process control and failure analysis. An increasing number of subtle defects become prominent drivers of failure as device size and operating margins decrease, e.g., processing anomalies in thin gate oxides, substrate problems related to do ...

    SBIR Phase I 2019 Department of CommerceNational Institute of Standards and Technology
  8. Intelligent System Architecture for Autonomous Care (ISAAC) Intervention

    SBC: SOAR TECHNOLOGY INC            Topic: A18064

    Unmanned systems and autonomous capabilities provide an avenue for improving enroute care in situations where medical evacuation assets are either not available or unable to reach the patient. A first step is to explore how intelligent algorithms can be u

    SBIR Phase I 2019 Department of DefenseArmy
  9. Data Analysis Tool to Assess Value of Information for Decision-making (DATAVOID)

    SBC: CHARLES RIVER ANALYTICS, INC.            Topic: A18059

    Decision-makers within the federal government and other agencies are responsible for making mission-critical decisions where a poor choice can have disastrous consequences, from monetary cost to loss of human life. To make the optimal decision, decision-makers often require detailed knowledge of the current scenario. Because information is often hard to obtain and time is limited, decision-makers ...

    SBIR Phase II 2019 Department of DefenseArmy
  10. Rapid Flow and Thermal Signature Design

    SBC: THERMOANALYTICS INC            Topic: A18102

    The efficient design and evaluation of Army vehicles requires accurate simulation of the factors that affect the vehicle’s infrared signature and thermal conditions inside the vehicle. The model must account for all the transient heat transfer within and outside the vehicle, including heat from the engine, air flow within the engine compartment, exhaust system, ventilation inside the vehicle, th ...

    SBIR Phase II 2019 Department of DefenseArmy
US Flag An Official Website of the United States Government